"March 2002" / Includes bibliographical references (leaves 145-161) / xvii, 198 leaves : ill. (some col.), maps (some col.), plates ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / An analogue for shallow marine carbonate sedimentation and deposition on a broad passive margin is described from the eastern Great Australian Bight. / Thesis (Ph.D.)--University of Adelaide, Dept. of Geology and Geophysics, 2002

Thesis (M.Sc.)--Memorial University of Newfoundland, 2005. / The CD-ROM includes Appendix A. Bibliography: leaves 205-214. Also available online.

<p>Sandstone and shale samples were selected within the systems tracts for laboratory analyses. The sidewall and core samples were subjected to petrographic thin section analysis, mineralogical analyses which include x-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and stable carbon and oxygen isotopes geochemistry to determine the diagenetic alteration at deposition and post deposition in the basin. The shale samples were subjected to Rock-Eval pyrolysis and accelerated solvent extraction (ASE) prior to gas chromatographic (GC) and gas chromatographic-mass spectrometric (GC-MS) analyses of the rock extracts, in order to determine the provenance, type and thermal maturity of organic matter present in sediments of the Orange Basin. The results revealed a complex diagenetic history of sandstones in this basin, which includes compaction, cementation/micritization, dissolution, silicification/overgrowth of quartz, and fracturing. The Eh-pH shows that the cements in the area of the basin under investigation were precipitated under weak acidic and slightly alkaline conditions. The &delta / 18O isotope values range from -1.648 to 10.054 %, -1.574 to 13.134 %, and -2.644 to 16.180 % in the LST, TST, and HST, respectively. While &delta / 13C isotope values range from -25.667 to -12.44 %, -27.862 to -6.954% and -27.407 to -19.935 % in the LST, TST, and HST, respectively. The plot of &delta / 18O versus &delta / 13C shows that the sediments were deposited in shallow marine temperate conditions.</p>

A study of the distribution of diagenetic alterations and their impact on reservoir-quality evolution in four deep-water turbidite successions (Cretaceous to Eocene) from basins in active (foreland) and passive margins revealed the impact of tectonic setting, depositional facies, and changes in the relative sea level. Diagenetic modifications encountered in the turbiditic sandstones from the passive margin basins include dissolution and kaolinitization (kaolin has δ18OV-SMOW = +13.3‰ to +15.2‰; δDV-SMOW = -96.6‰ to -79.6‰) of framework silicates, formation of grain coating chloritic and illitic clays, cementation by carbonates and quartz, as well as the mechanical and chemical compaction of detrital quartz. Kaolinitization, which is most extensive in the lowstand systems tracts, is attributed to meteoric-water flux during major fall in the relative sea level. Preservation of porosity and permeability in sandstones from the passive margin basins (up to 30% and 1 Darcy, respectively) is attributed to the presence of abundant rigid quartz and feldspar grains and to dissolution of carbonate cement as well as mica and feldspars. Diagenetic modifications in turbidites from the foreland basins include carbonate cementation and mechanical compaction of the abundant ductile rock fragments, which were derived from fold-thrust belts. These diagenetic alterations resulted in nearly total elimination of depositional porosity and permeability. The wide range of δ13CV−PDB values of these cements (about -18‰ to +22‰) in passive margin basins is attributed to input of dissolved carbon from various processes of organic matter alterations, including microbial methanogenesis and thermal decarboxylation of kerogen. The narrower range of δ13CV−PDB values of these cements (about -2‰ to +7‰) in the foreland basins suggests the importance of carbon derivation from the dissolution of carbonate grains. The generally wide range of δ18O values (about -17‰ to -1‰) of the carbonate cements reflect the impact of oxygen isotopic composition of the various fluid involved (including marine depositional waters, fluxed meteoric waters, evolved formation waters) and the wide ranges of precipitation temperatures. Results of this study are anticipated to have important implication for hydrocarbon exploration in deep-water turbidites from passive and active margin basins and for pre-drilling assessment of the spatial and temporal distribution of reservoir quality in such deposits.

A series of deposits, located along the southern flanks of Grand Mesa, Colorado, and extending to the south, are problematic, and the processes related to emplacement are not understood. The overall area is dominated by two landform systems, Grand Mesa, which supported a Pleistocene ice cap, and the North Fork Gunnison River drainage. Thus, one has to ask: Are these deposits the result of the melting of the ice cap or are they fluvial terraces associated with the evolution of the ancestral Gunnison River? The goal of this research was to map the areal extent of the deposits and to interpret the formation and climatic significance in understanding the evolution of the Pleistocene landscape in the region. An extensive exposure, parallel to State Highway 65 near Cory Grade, was used for detailed description and sampling. Three additional exposures, ~10 to 20 km (~6 to 12 mi) were used to extend the areal extent of sampling. The study area was mapped using aerial photography and traditional field mapping aided by GPS. From the field work, a detailed stratigraphic column, including lithology and erodability, was constructed. Vertical exposures of the deposits were described, mapped, and recorded in the field and using detailed photo mosaics. Samples were collected from each stratum of the deposits for grain-size, shape, and sorting analyses. Five distinct depositional facies were identified. Sieve analysis on collected samples shows that four distinct grain-sizes occur in the outcrops; coarse sand, very-coarse sand, granule, and pebble and boulder. Mean grain-sizes range from 0.0722 to 0.9617, -0.0948 to -0.9456, -1.0566 to -1.9053, and -2.0050 to -3.4643, respectively. Glacio-fluvial depositional environments were identified and supported with observations of sedimentary structures and clast composition. Two major environments of deposition are recorded in the deposits; fluvial deposits from glacial outburst floods, and debris flow deposits. Imbrication of clasts in the strata suggests the flow came from the direction of Grand Mesa to the north. Facies and subsequent sequences were constructed to portray evidence that supports the glacio-fluvial mode of deposition.

Reservoir permeability is one of the important parameters derived from well test analysis. Small-scale permeability measurements in wells are usually made using core plugs, or more recently, probe permeameter measurements. Upscaling of these measurements for comparisons with permeability derived well tests (Pressure Build-Up) can be completed by statistical averaging methods. Well Test permeability is often compared with one of the core plug averages: arithmetic, geometric and harmonic. A question that often arises is which average does the well test-derived permeability represent and over what region is this average valid? A second important question is how should the data sets be reconciled when there are discrepancies? In practice, the permeability derived from well tests is often assumed to be equivalent to the arithmetic (in a layered reservoir) or geometric (in a randomly distributed permeability field) average of the plug measures. These averages are known to be members of a more general power-average solution. This pragmatic approach (which may include an assumption on the near-well geology) is often flawed due to a number of reasons, which is tried to be explained in this study. The assessment of in-situ, reservoir permeability requires an understanding of both core (plug and probe) and well test measurements &amp / #8211 / in terms of their volume scale of investigation, measurement mechanism, interpretation and integration. Pressure build-up tests for 26 wells and core plug analysis for 32 wells have valid measured data to be evaluated. Core plug permeabilities are upscaled and compared with pressure build-up test derived permeabilities. The arithmetic, harmonic and geometric averages of core plug permeability data are found out for each facies and formation distribution. The reservoir permeability heterogeneities are evaluated in each step of upscaling procedure by computing coefficient of variation, The Dykstra-Parson&amp / #8217 / s Coefficient and Lorenz Coefficients. This study compared core and well test measurements in South East of Turkey heavy oil carbonate field. An evaluation of well test data and associated core plug data sets from a single field will be resulting from the interpretation of small (core) and reservoir (well test) scale permeability data. The techniques that were used are traditional volume averaging/homogenization methods with the contribution of determining permeability heterogeneities of facies at each step of upscaling procedure and manipulating the data which is not proper to be averaged (approximately normally distributed) with the combination of Lorenz Plot to identify the flowing intervals. As a result, geometrical average of upscaled core plug permeability data is found to be approximately equal to the well test derived permeability for the goodly interpreted well tests. Carbonates are very heterogeneous and this exercise will also be instructive in understanding the heterogeneity for the guidance of reservoir models in such a system.

Interpretation of 900 km of a closely spaced grid of high-resolution seismic profiles over the northwestern margin of South Caspian Basin (SCB) allows recognition and study of six late Pleistocene - Holocene depositional sequences. Sequence stratigraphy analysis of sedimentary strata from 117,000 years B.P. to present led to the identification of a highstand systems tract, two transgressive systems tracts and six lowstand systems tracts. Each systems tract is characterized by specific seismic facies. Diverse depositional processes on the northwestern margin of the SCB are suggested by the thirteen seismic facies patterns recognized in the study area. Two distinct progradational complexes were interpreted within Sequence III and Sequences IV and V in the northeastern and northwestern parts of the study area, respectively. Stratigraphic interpretation of the sequences provided important information on parameters that control depositional architectures, such as lake level fluctuations, tectonic dynamics, and sediment supply. High sedimentation rates combined with a series of high-frequency and high-amplitude lake-level fluctuations, abrupt changes at the shelf edge, abnormally high formation pressure, and high tectonic activity during Quaternary time resulted in the development of a variety of complex geologic drilling hazards. I distinguished three types of hazards as a result of this study: mud volcanoes, sediment instability, and shallow gas. The 2D high-resolution seismic dataset from the northwestern margin of the SCB allowed more detailed seismic sequence stratigraphic analysis in the study area than has previously been attempted. In particular, it has a clear application in deciphering sediment supply and relative lake level changes as well as tectonic relationship of the northwestern shelf margin of the SCB. Results of this work led us towards better understanding of recent depositional history, improved our knowledge of the nature of the basin tectonics, climate history and styles of and controls on sedimentation processes within a sequence stratigraphic framework during the late Pleistocene-Holocene time.

Not available / text

The Middle Jurassic Entrada Sandstone of the Four Corners region, USA, is composed predominantly of very fine-grained, red, silty sandstone with poorly defined sedimentary structures. The origin of this facies is enigmatic, even though it is common both on the Colorado Plateau and globally, and is spatially situated between deposits recording unambiguous marine and aeolian environments. Eleven sections were measured along an 85 km transect from the Blanding Basin in southeastern Utah to the San Juan Basin in northwestern New Mexico. Outcrop and laboratory analyses distinguish eight facies: (1) silty shale, (2) shallow subaqueous reworked, fine- to medium-grained sandstone, (3) brecciated, very fine-grained sandstone, (4) crinkly laminated, very fine-grained sandstone with preserved wind ripples and abundant silty laminae, (5) weakly laminated, fine-grained sandstone with occasional silty laminae, (6) planar-laminated, fine-grained, wind-rippled sandstone, (7) cross-stratified, fine- to medium-grained aeolian cross-stratified sandstone, and (8) micritic limestone. Lateral and vertical relationships of these facies show a proximal to distal transition from cross-bedded wind-lain facies to loess-dominated sabkha facies with increasing abundance of water-lain facies basinward. The well known Todilto Limestone (facies 8) is situated stratigraphically below loess-dominated sabkha facies (facies 4 and 5) within the Entrada Sandstone, reinforcing previous interpretations that the unit represents a catastrophic flooding event and not a local groundwater flux. / text

Tectonic signatures such as growth strata, clastic progradation, detrital composition, thickness trends, paleoflow shifts, lithofacies distribution, and vertical stratigraphic stacking patterns provide the basis for a range of tectonic/structural interpretations. Complete understanding of the application and limitations of tectonic signatures is important to maintain consistency and reduce uncertainty of interpretations that use them. This study provides insight into the external controls on two frequently used tectonic signatures in foreland basins: (1) growth strata, and (2) clastic wedge progradation. First, two syntectonic unconformity types are recognized in non-marine, Cenomanian growth strata adjacent to the Sevier thrust-belt in southeastern Nevada, USA. Unconformities with larger angular discordance (>10°, “Traditional Type”) developed when uplift outpaced sediment accumulation. More subtle unconformities with less discordance (2-10°, “Subtle Type”) developed when sediment accumulation nearly kept pace with uplift. Increasing sediment supply with positive net accommodation, allows syntectonic deposits to aggrade above a growing structure, with no change in uplift rate. Hence, sediment supply and regional accommodation impart an important control over growth strata geometries that are often interpreted on the basis of tectonics alone. Identification of unconformity types in growth strata can therefore document additional phases of uplift, particularly for intervals where sediments aggraded above an active structure due to higher sediment supply during regional subsidence, or sea level rise. Second, an anomalous, Campanian clastic wedge is identified in Cordilleran Foreland basin fill, Utah and Colorado. The complex internal architecture, tide-dominated facies and characteristic flat-to-falling shoreline stacking patterns of the wedge reflect rapid progradation of wide (60-80 km), embayed, tide-influenced shorelines; these characteristics distinguish the anomalous wedge from the underlying and overlying clastic wedges in the basin. A high-resolution regional correlation and isopach maps for the anomalous wedge provide evidence that extensive clastic progradation was coeval with both Sevier- and Laramide-style deformation. Stratigraphic relations suggest that development of the anomalous character of Wedge B was due to uplift of a Laramide structure within the foredeep, and possibly enhanced by reduced dynamic subsidence. / text