The Motorola Inc. paging protocol FLEX is discussed. The design and construction of a FLEX paging protocol decoder is discussed in detail. It proposes a decoding solution that includes a radio frequency (RF) receiver and a decoder board. The RF receiver will be briefly discussed. The decoder design is the main focus of this thesis as it transforms the RF frequency modulated (FM) data from the receiver and converts it to FLEX data words. The decoder is designed to handle bit sampling, bit clock synchronization, FLEX packet detection, and FLEX data word collection. The FLEX data words are then sent by the decoder to an external computer through a serial link for bit processing and storage. A FLEX transmitter will send randomly generated data so that a bit error rate (BER) calculation can be made at a PC. Each receiver'9s noise power and noise bandwidth will be measured so that noise spectral density may be calculated. A complete measurement set-up will be shown on how these noise measurements are made. The BER at a known power level is recorded. This enables Eb/No curves to be generated so that results of the decoding algorithm may be compared. This is performed on two different receivers. / Master of Science

<p>Magnetic resonance imaging is a research and clinical tool that has been applied in a wide variety of sciences. One area of magnetic resonance imaging that has exhibited terrific promise and growth in the past decade is magnetic susceptibility imaging. Imaging tissue susceptibility provides insight into the microstructural organization and chemical properties of biological tissues, but this image contrast is not well understood. The purpose of this work is to develop effective approaches to image, assess, and model the mechanisms that generate both isotropic and anisotropic magnetic susceptibility contrast in biological tissues, including myocardium and central nervous system white matter. </p><p>This document contains the first report of MRI-measured susceptibility anisotropy in myocardium. Intact mouse heart specimens were scanned using MRI at 9.4 T to ascertain both the magnetic susceptibility and myofiber orientation of the tissue. The susceptibility anisotropy of myocardium was observed and measured by relating the apparent tissue susceptibility as a function of the myofiber angle with respect to the applied magnetic field. A multi-filament model of myocardial tissue revealed that the diamagnetically anisotropy α-helix peptide bonds in myofilament proteins are capable of producing bulk susceptibility anisotropy on a scale measurable by MRI, and are potentially the chief sources of the experimentally observed anisotropy.</p><p>The growing use of paramagnetic contrast agents in magnetic susceptibility imaging motivated a series of investigations regarding the effect of these exogenous agents on susceptibility imaging in the brain, heart, and kidney. In each of these organs, gadolinium increases susceptibility contrast and anisotropy, though the enhancements depend on the tissue type, compartmentalization of contrast agent, and complex multi-pool relaxation. In the brain, the introduction of paramagnetic contrast agents actually makes white matter tissue regions appear more diamagnetic relative to the reference susceptibility. Gadolinium-enhanced MRI yields tensor-valued susceptibility images with eigenvectors that more accurately reflect the underlying tissue orientation.</p><p>Despite the boost gadolinium provides, tensor-valued susceptibility image reconstruction is prone to image artifacts. A novel algorithm was developed to mitigate these artifacts by incorporating orientation-dependent tissue relaxation information into susceptibility tensor estimation. The technique was verified using a numerical phantom simulation, and improves susceptibility-based tractography in the brain, kidney, and heart. This work represents the first successful application of susceptibility-based tractography to a whole, intact heart.</p><p>The knowledge and tools developed throughout the course of this research were then applied to studying mouse models of Alzheimer’s disease in vivo, and studying hypertrophic human myocardium specimens ex vivo. Though a preliminary study using contrast-enhanced quantitative susceptibility mapping has revealed diamagnetic amyloid plaques associated with Alzheimer’s disease in the mouse brain ex vivo, non-contrast susceptibility imaging was unable to precisely identify these plaques in vivo. Susceptibility tensor imaging of human myocardium specimens at 9.4 T shows that susceptibility anisotropy is larger and mean susceptibility is more diamagnetic in hypertrophic tissue than in normal tissue. These findings support the hypothesis that myofilament proteins are a source of susceptibility contrast and anisotropy in myocardium. This collection of preclinical studies provides new tools and context for analyzing tissue structure, chemistry, and health in a variety of organs throughout the body.</p> / Dissertation

This work presents a spin torque nano-oscillator (STNO) based binary frequency shift keying (BFSK) modulation schema implemented on a printed circuit board (PCB). Maximal input data rate reaches 20 Mbit/s. Depending on the STNO used, carrier frequency can range from 1 to 10 GHz. Both DC and AC currents flowing through the STNO can be tuned between 0 to 4 mA. Using one magnetic tunnel junction (MTJ) STNO, a 380 MHz frequency shift around the center frequency 9 GHz was observed, when the modulated current was toggled between 0.8 mA and 1.2 mA at a rate of 20 Mbit/s. This is the first work demonstrating that the STNOs are applicable for BFSK modulation on the wireless application level.

The main purpose of this research was to develop improved methods for RF coil characterisation, and for non-invasive spatio-temporal mapping of temperature in the living body, in order to utilise the full potential of magnetic resonance imaging (MRI) at high magnetic fields by ensuring radiofrequency (RF) safety. Current RF power limits are often overly conservative, unnecessarily limiting the full potential of MRI, especially at high field. Thus it is useful to monitor tissue temperature while running MR imaging sequences which may deposit high RF power. Proton resonance frequency (PRF) MR thermometry can employ the phase of the complex MR signal to estimate temperature change over time. However, the shift of the water PRF with temperature is relatively small, making phase-based MR thermometry inherently sensitive to any extraneously caused changes of local frequency or MR phase. A potential source of error to PRF MR thermometry is a change in surround air susceptibility. The considerable impact of air susceptibility changes on PRF MR thermometry was demonstrated and quantified in experiments and magnetic field simulations. One way of correcting MR thermometry is to use a chemically shifted reference substance, in combination with a phase-sensitive chemical shift-selective MR thermometry sequence. The requirement of having a reliable separation of substances based on their resonance frequency was met by a novel frequency-selective phase-sensitive spin-echo (SE) MR thermometry sequence. This sequence was thoroughly tested in phantom and in-vivo experiments as well as in extensive Bloch simulations. The sequence limitations and advantages are discussed in detail. This technique acquires unsaturated water and fat images in rapid succession at the same position in space. The acquisition of a water and fat slice in less than 100 ms allows the correction of rapid field fluctuations in the brain caused by breathing and heartbeat, while still ensuring the correction of long term drift. With no assumptions required regarding temperature distribution in the tissue, this novel MR thermometry technique can measure brain temperature within a single (1.5 mm)3 voxel with a very low standard deviation (SD) of 0.3 K. Using an MRI phantom with a dimethyl sulfoxide reference, heating experiments achieved a MR temperature measurement with an SD of approximately 0.1 K in a single (1.5 mm)3 voxel. In conclusion, the work presented in this thesis assists the development of a real-time in-vivo temperature monitoring system that guarantees patient RF safety at high field.

The recent advancements in electronics and the advents of small scaled instruments has increased the attachment of life and functionality of devices to electrical power sources but at the same time granted the engineers and companies the ability to use smaller sources of power and batteries. Therefore, many scientists have tried to come up with new solutions for a power alternatives. Piezoelectric is a promising material which can readily produce continuous electric power from mechanical inputs. However, their power output is dependent upon several factors such as, system natural frequency, their position in the system, the direction of vibration and many other internal and external factors. In this research the working bandwidth of the system is increased through utilizing of two different piezoelectric beam in different directions. The dependency of output power with respect to rotation angle and also the frequency shift due to the rotation angle is studied.

Structural Health Monitoring is a useful tool for reducing maintenance costs and improving the life and performance of engineering structures. Impedance-Based SHM utilizes the coupled electromechanical behavior of piezoelectric materials to detect adverse changes and material and mechanical failures of structures. Environmental variables such as temperature present a challenge to assessing the veracity of damage detected through statistical modeling of impedance signals. An effective frequency shift method was developed to compensate impedance measurements for changes resulting from environmental temperature fluctuations. This thesis investigates how the accuracy of this method can be improved and be applied to a 100oF range of temperatures. Building up the idea of eliminating temperature effects from impedance measurements, this thesis investigates the possibility of using statistical moments to create a temperature independent impedance baseline. / Master of Science

International Telemetering Conference Proceedings / October 26-29, 1998 / Town & Country Resort Hotel and Convention Center, San Diego, California / Presentation of Alcatel Espace last studies and developments regarding TT&C receiver Products for satellite. This document lays on 3 parts: · a technical point of view showing digital demodulation principles used (base band recovery, analytical head, PM or FM demodulation) and their related offered possibilities(digital controlling loop, lock status detection, jammer detection,....) · a technology/design description · a synthesis showing performance and results

The existence of bulk magnetism in matter can be attributed to the magnetic properties of the sub-atomic particles that constitute the former. The fact that the origin of these microscopic magnetic moments cannot be related to the existence of microscopic currents became apparent when this assumption predicted completely featureless bulk magnetic properties in contradiction to the observation of various bulk magnetic properties [1]. This microscopic magnetic moment, independent of other motions, hints at the existence of a hitherto unknown degree of freedom that a particle can possess. This property has come to be known as the "spin" of the particle. The atomic nucleus is comprised of the protons and the neutrons which possess a spin each. The composite object- the atomic nucleus is therefore a tiny magnet itself. In the presence of an external bias like a magnetic field, the nucleus therefore evolves like a magnetic moment and attains a characteristic frequency in its evolution called the Larmor frequency given by, (formula) where η is the magnetogyric ratio of the particle and B is the applied magnetic field. The existence of a natural frequency presents the possibility of a resonance behaviour in the response of the system when probed with a driving field. This is the basic principle of magnetic resonance, which in the context of the atomic nucleus, was discovered independently by Purcell [2] and Bloch [3]. From its conception, the technique and the associated understanding of the involved phenomena have come a long way. In its original form the technique involved the study of the steady-state response of the nuclear magnetic moment to a driving field. This continuous wave NMR had the basic limitation of exciting resonances in a given sample, serially. In due course of time, this technique was replaced by the Fourier transform NMR (FTNMR) [4]. This technique differed from the continuous wave NMR in its study of the transient response of the system in contrast to the steady-state response in the former. The advantage of this method is the parallel observation of all the resonances present in the system ( within the band-width of the excitation). In addition to the bias created by the external field, other internal molecular fields produce additional bias which in turn produce interesting signatures on the spectrum of the system, which are potential carriers of information about the molecular state. The fact that the spins are not isolated from the molecular environment, produces a striking effect on the ideal spectrum of the system. These effects contain in them, the signatures of the molecular local environment and are hence of immense interest to physicists, chemists and biologists.

Backscatter communication enables wireless communication at a power consumption orders of magnitude lower than conventional wireless communication. Instead of generating new RF-signals backscatter communication leverages ambient signals, such as WiFi-, Bluetooth- or TV-signals, and reflects them by changing the impedance of the antenna. Backscatter communication is known as a short-range communication technique achieving ranges in the order of meters. To improve the communication range, we explore the use of a tunnel diode as an amplifier of the backscattered RF-signal. We developed the amplifier on a PCB-board together with a matching network tuned to give maximum gain at 868 MHz. Our work demonstrates that the 1N3712 tunnel diode can achieve gains up to 35 dB compared to a tag without amplification while having a peak power consumption of 48 μW. With this amplifier the communication distance can be increased by up to two orders of magnitude.

No description available.