International Telemetering Conference Proceedings / October 22-25, 2001 / Riviera Hotel and Convention Center, Las Vegas, Nevada / This project investigates the feasibility of position detection in an office or industrial setting. The objective is to design a low-cost positioning system that uses the unlicensed 5.7 GHz ISM band, with centimeter accuracy and limited range. During the conceptual design phase of the system, indoor channel models will be investigated to determine which of a variety of architectures will be useful. For triangulating the position, an array of widely spaced stationary receivers and a mobile transmitter is proposed.

International Telemetering Conference Proceedings / October 21, 2002 / Town & Country Hotel and Conference Center, San Diego, California / The objective of the project is to continuously track a handheld device in an office, with centimeter accuracy in the three dimensions. A 3-D ray-tracing algorithm has been developed to simulate the impulse response of the indoor channel. The algorithm can evaluate the impulse response at multiple receiver locations. Non-linear optimization has been used to eliminate the need for multiple runs of simulation. The optimization program also significantly reduces the number of rays launched. The algorithm incorporates bandwidth effects on multipath resolution of the system.

Ultra-Wideband ¡}UWB¡~Communication Technology is one of the potential technologies in indoor wireless communication applications. Because of the property of fine resolution of transmitted signal by UWB, it is powerful on indoor location applications. In the first place, we need to estimate the time of arrival based on the wireless location applications. Whether synchronization between the template signals and received signals affects directly the SNR of the estimator output and decreases the ranging accuracy. Because of the transmitted signal is the type of impulse radio for UWB system, it is more important on the time accuracy of the internal oscillator. In the thesis, we utilize the Delay-Locked Loop ¡}DLL¡~ structure with Self-tuning function to reduce the timing jitter in the internal oscillator. We can improve the stability in the tracking loop and utilize multipath canceller to cancel the multipath interference in the indoor environment. When reaching synchronization between the template signal and received signal by using the tracking loop, we can improve ranging accuracy and increase location precision according to the received signal.

No description available.

No description available.

Networks with hundreds of ad hoc nodes equipped with communication and position finding abilities are conceivable with recent advancements in technology. Methods are presented in this thesis to assess the communicative capabilities and node position estimation of mobile ad hoc networks. Specifically, we investigate techniques for providing communication and geolocation with specific characteristics in wireless ad hoc networks. The material presented in this thesis, communication and geolocation, may initially seem a collection of disconnected topics related only distantly under the banner of ad hoc networks. However, systems currently in development combining these techniques into single integrated systems. In this thesis first, we investigate the effect of multilayer interaction, including fading and path loss, on ad hoc routing protocol performance, and present a procedure for deploying an ad hoc network based on extensive simulations. Our first goal is to test the routing protocols with parameters that can be used to characterize the environment in which they might be deployed. Second, we analyze the location discovery problem in ad hoc networks and propose a fully distributed, infrastructure-free positioning algorithm that does not rely on the Global Positioning System (GPS). The algorithm uses the approximate distances between the nodes to build a relative coordinate system in which the node positions are computed in three-dimensions. However, in reconstructing three-dimensional positions from approximate distances, we need to consider error threshold, graph connectivity, and graph rigidity. We also statistically evaluate the location discovery procedure with respect to a number of parameters, such as error propagation and the relative positions of the nodes.

[pt] Este trabalho apresenta os resultados de uma sondagem em frequencia do canal indoor de faixa larga em 1,8GHz, onde foram testados alguns ambientes na tentativa de simular a mobilidade de um usuário. A técnica de sondagem é baseada na técnica clássica de varredura em frequencia, onde foi implementado um link óptico ao invés de cabos coaxiais, para permitir um maior range de medidas. A completa análise de dispersão temporal em pequena e larga escala foi extraída de medidas da resposta impulsiva, como retardo médio, espalhamento rms de retardos, banda de coerência e suas variações com a mobilidade. Do conjunto de análises efetuadas dois resultados obtiveram destaque: perfis de potência de retardo com a distância , resultando em uma boa representação dos principais espalhadores do ambiente; e a validação de um limitante teórico da relação entre a banda de coerência e o espalhamento rms de retardos, recentemente proposto por outro autor. Este trabalho apresenta os resultados de uma sondagem em frequencia do canal indoor de faixa larga em 1,8GHz, onde foram testados alguns ambientes na tentativa de simular a mobilidade de um usuário. A técnica de sondagem é baseada na técnica clássica de varredura em frequencia, onde foi implementado um link óptico ao invés de cabos coaxiais, para permitir um maior range de medidas. A completa análise de dispersão temporal em pequena e larga escala foi extraída de medidas da resposta impulsiva, como retardo médio, espalhamento rms de retardos, banda de coerência e suas variações com a mobilidade. Do conjunto de análises efetuadas dois resultados obtiveram destaque: perfis de potência de retardo com a distância , resultando em uma boa representação dos principais espalhadores do ambiente; e a validação de um limitante teórico da relação entre a banda de coerência e o espalhamento rms de retardos, recentemente proposto por outro autor. / [en] The results of a 1.8 GHz indoor wide-band channel souding survey at some typical environments, trying to account for pedestrian subscriber mobility, are presented. The sounding technique has been based on the classical frequency domain one, with an optic link instead of coaxial cables provinding an extended path range. Complete small and large- scale time dispersionanalysis have been derived from the impulse responses measured, like mean delay, rms delay spread, coherence bandwidth and its variations with mobility. From the whole analysis carried out, two main results are worth remarking: the power delay profile variation with distance providing a pictorial representation of the main scattering mechanisms of the environment; and the validation of a lower bound relation between the coherence bandwidth and rms delay spread recently proposed by another author.

This work concentrates on the application of diversity techniques and space time block coding for future mobile wireless communications. The initial system analysis employs a space-time coded OFDM transmitter over a multipath Rayleigh channel, and a receiver which uses a selection combining diversity technique. The performance of this combined scenario is characterised in terms of the bit error rate and throughput. A novel four element QOSTBC scheme is introduced, it is created by reforming the detection matrix of the original QOSTBC scheme, for which an orthogonal channel matrix is derived. This results in a computationally less complex linear decoding scheme as compared with the original QOSTBC. Space time coding schemes for three, four and eight transmitters were also derived using a Hadamard matrix. The practical optimization of multi-antenna networks is studied for realistic indoor and mixed propagation scenarios. The starting point is a detailed analysis of the throughput and field strength distributions for a commercial dual band 802.11n MIMO radio operating indoors in a variety of line of sight and non-line of sight scenarios. The physical model of the space is based on architectural schematics, and realistic propagation data for the construction materials. The modelling is then extended and generalized to a multi-storey indoor environment, and a large mixed site for indoor and outdoor channels based on the Bradford University campus. The implications for the physical layer are also explored through the specification of antenna envelope correlation coefficients. Initially this is for an antenna module configuration with two independent antennas in close proximity. An operational method is proposed using the scattering parameters of the system and which incorporates the intrinsic power losses of the radiating elements. The method is extended to estimate the envelope correlation coefficient for any two elements in a general (N,N) MIMO antenna array. Three examples are presented to validate this technique, and very close agreement is shown to exist between this method and the full electromagnetic analysis using the far field antenna radiation patterns.

Submitted by Renata Lopes (renatasil82@gmail.com) on 2017-04-20T12:33:06Z No. of bitstreams: 1 analuizasiqueiraferreira.pdf: 2299159 bytes, checksum: 4a5563c4c2ee9592b3902e4440a2031b (MD5) / Approved for entry into archive by Adriana Oliveira (adriana.oliveira@ufjf.edu.br) on 2017-04-20T12:45:20Z (GMT) No. of bitstreams: 1 analuizasiqueiraferreira.pdf: 2299159 bytes, checksum: 4a5563c4c2ee9592b3902e4440a2031b (MD5) / Made available in DSpace on 2017-04-20T12:45:20Z (GMT). No. of bitstreams: 1 analuizasiqueiraferreira.pdf: 2299159 bytes, checksum: 4a5563c4c2ee9592b3902e4440a2031b (MD5) Previous issue date: 2011-04-11 / O uso de banda ultra-larga (ultra wideband - UWB) vem sendo tema de pesquisa na área da comunicação sem fio há cerca de 20 anos e os bons resultados obtidos tem levado à introdução de novas tecnologias no mercado de transmissão de dados a curtas distâncias. No entanto, o uso de UWB para a transmissão de dados através da rede elétrica (power line communications - PLC) ainda é uma questão de investigação em aberto, interessante e promissora para um conjunto específico de aplicações que demandam elevada taxa de transmissão em curtas distâncias e baixo custo, tais como impressoras, monitores, etc. Neste contexto, a presente dissertação analisa diferentes aspectos da transmissão UWB através de cabos de distribuição de energia elétrica. Um sistema UWB impulsivo é analisado quando i) o canal PLC é outdoor, linear e variante no tempo; ii) o canal PLC é indoor, linear e invariante no tempo; iii) há ruído AWGN (additive white Gaussian noise) e iv) há ruído AIGN (additive impulsive Gaussian noise). Além disso, são respondidas questões referentes à adequação do pulso UWB ao canal de comunicação, considerando o espectro do mesmo quando o canal PLC é outdoor ou indoor. As modulações UWB investigadas são pela posição do pulso (pulse position modulation - PPM) e pela amplitude do pulso (pulse amplitude modulation - PAM). Além de apresentar diretrizes para o projeto de um sistema UWB para aplicações PLC, a presente dissertação analisa diversas estratégias e técnicas para recepção e redução da complexidade computacional do receptor UWB. Os resultados indicam que o uso de UWB é interessante para algumas aplicações específicas que envolvam elevada taxa de transmissão, através de curtas distâncias e baixo custo. / Ultra wideband modulation (UWB) has been a subject of research in the wireless field for nearly 20 years and the good results achieved have led to the introduction of new technologies in the market of short distances data communication. However, the employment of UWB for data transmission over power lines (PLC) is still an open, interesting and promising research theme for a specific set of applications which require high throughput over short distances and low cost, such as printers, computer monitors, etc. In this context, this dissertation examines several aspects of the UWB transmission through electricity distribution cables. An UWB impulsive system is analyzed when i) the PLC channel is outdoor, linear and time invariant; ii) the PLC channel is indoor, linear and time invariant; iii) there is AWGN (additive white gaussian noise) and iv) there is AIGN (additive impulsive gaussian noise) noise. Moreover, many questions regarding the adequacy of UWB pulse for the communication channel are answered, taking into account its spectrum when the PLC channel is outdoor or indoor. The UWB modulations investigated are pulse position modulation (PPM) and pulse amplitude modulation (PAM). Apart from presenting some guidelines to project a UWB system, this work analyzes different strategies and techniques for reception that reduce the computational complexity of the UWB receiver. The results point out that UWB is interesting for some specific applications which require high data transmission rate in short distances and low cost.

This work concentrates on the application of diversity techniques and space time block coding for future mobile wireless communications. The initial system analysis employs a space-time coded OFDM transmitter over a multipath Rayleigh channel, and a receiver which uses a selection combining diversity technique. The performance of this combined scenario is characterised in terms of the bit error rate and throughput. A novel four element QOSTBC scheme is introduced, it is created by reforming the detection matrix of the original QOSTBC scheme, for which an orthogonal channel matrix is derived. This results in a computationally less complex linear decoding scheme as compared with the original QOSTBC. Space time coding schemes for three, four and eight transmitters were also derived using a Hadamard matrix. The practical optimization of multi-antenna networks is studied for realistic indoor and mixed propagation scenarios. The starting point is a detailed analysis of the throughput and field strength distributions for a commercial dual band 802.11n MIMO radio operating indoors in a variety of line of sight and non-line of sight scenarios. The physical model of the space is based on architectural schematics, and realistic propagation data for the construction materials. The modelling is then extended and generalized to a multi-storey indoor environment, and a large mixed site for indoor and outdoor channels based on the Bradford University campus. The implications for the physical layer are also explored through the specification of antenna envelope correlation coefficients. Initially this is for an antenna module configuration with two independent antennas in close proximity. An operational method is proposed using the scattering parameters of the system and which incorporates the intrinsic power losses of the radiating elements. The method is extended to estimate the envelope correlation coefficient for any two elements in a general (N,N) MIMO antenna array. Three examples are presented to validate this technique, and very close agreement is shown to exist between this method and the full electromagnetic analysis using the far field antenna radiation patterns.