Global ETD Search

1	Installation and Testing of the Isobar Separator for Anions at the A. E. Lalonde AMS Laboratory Using Chlorine-36 Analysis Flannigan, Erin 03 January 2024 (has links) Accelerator Mass Spectrometry (AMS) studies of rare isotopes with abundant isobars that form negative ions often require the use of large accelerators to achieve high sensitivity measurements. The Isobar Separator for Anions (ISA) is a radiofrequency quadrupole (RFQ) reaction cell system that provides selective isobar suppression for many of these isotopes in the low energy system, prior to injection into an accelerator. The ISA can then facilitate the measurement of these ions using smaller accelerators. A commercial version from Isobarex Corp. was installed in a separate low energy injection line of the 3 MV accelerator system at the A. E. Lalonde AMS Laboratory in the University of Ottawa and was tested using the measurement of 36Cl, suppressing its stable isobar 36S. The ISA includes a DC deceleration region, a combined cooling and reaction cell, and a DC acceleration region. The deceleration region reduces the beam energy from the ion source (20-35 keV) to a level that chemical reactions can occur, scattering is minimized, and that the reaction cell can accept and contain. RFQ segments along the length of the cell create a potential well, which limits the divergence of the traversing ions. DC offset voltages on these RFQ segments maintain a controlled ion velocity through the cell. Helium was used as a cooling gas to further decelerate the ions, facilitating charge exchange between 36S and a reaction gas. Helium provided the highest transmission of 30-80% for chlorine anions. The reaction gas NO2 was chosen to preferentially react with sulfur. Over seven orders of magnitude reduction of sulfur to chlorine was observed. After exiting the cell, the beam is reaccelerated prior to injection into the tandem accelerator for AMS analysis. Using 36Cl reference materials, it was determined that linear transmission results could be obtained for a 36Cl/Cl ratio ranging from 10−11 to 10−15. The measurements were stable over more than 24 hours of continuous measurement. A blank level on the order of 10−15 was observed. The ISA was used to measure unknown 36Cl /Cl ratio groundwater samples and the results are compared to external AMS measurements. Accelerator Mass Spectrometry Chlorine-36 Isobar Separation Reaction cell Ion-gas reactions Radio-frequency quadrupole
2	A Radio Frequency Quadrupole Instrument for use with Accelerator Mass Spectrometry: Application to Low Kinetic Energy Reactive Isobar Suppression and Gas–phase Anion Reaction Studies Eliades, John Alexander 21 August 2012 (has links) A radio frequency (rf) quadrupole instrument, currently known as an Isobar Separator for Anions (ISA), has been integrated into an Accelerator Mass Spectrometry (AMS) system to facilitate anion–gas reactions before the tandem accelerator. An AMS Cs+ sputter source provided > 15 keV ions that were decelerated in the prototype ISA to < 20 eV for reaction in a single collision cell and re-accelerated for AMS analysis. Reaction based isobar suppression capabilities were assessed for smaller AMS systems and a new technique for gas–phase reaction studies was developed. Isobar suppression of 36S– and 12C3– for 36Cl analysis, and YF3– and ZrF3– for 90Sr analysis were studied in NO2 with deceleration to < 12 eV. Observed attenuation cross sections, σ [x 10^–15 cm^2], were σ(S– + NO2) = 6.6, σ(C3– + NO2) = 4.2, σ(YF3– + NO2) = 7.6, σ(ZrF3– + NO2) = 19. With 8 mTorr NO2, relative attenuations of S–/Cl– ~ 10^–6, C3–/Cl– ~ 10^–7, YF3–/SrF3– ~ 5 x 10^–5 and ZrF3–/SrF3– ~ 4 x 10^–6 were observed with Cl– ~ 30% and SrF3– > 90% transmission. Current isobar attenuation limits with < 1.75 MV accelerator terminal voltage and ppm impurity levels were calculated to be 36S–/Cl– ~ 4 x 10^–16, 12C3–/Cl– ~ 1.2 x 10^–16, 90YF3–/SrF3– ~ 10^–15 and 90ZrF3–/SrF3– ~ 10^–16. Using 1.75 MV, four 36Cl reference standards in the range 4 x 10^–13 < 36Cl/Cl < 4 x 10^–11 were analyzed with 8 mTorr NO2. The measured 36Cl/Cl ratios plotted very well against the accepted values. A sample impurity content S/Cl < 6 x 10^–5 was measured and a background level of 36S–/Cl < 9 x 10^–15 was determined. Useful currents of a wide variety of anions are produced in AMS sputter sources and molecules can be identified relatively unambiguously by stripping fragments from tandem accelerators. Reactions involving YF3–, ZrF3–, S– and SO– + NO2 in the ISA analyzed by AMS are described, and some interesting reactants are identified. radio frequency quadrupole rf quadrupole accelerator mass spectrometry AMS gas-phase reactions isobar suppression anion negative ion chlorine Cl 36Cl carbon trimer C3 sulphur sulfur sulphur oxide sulfur oxide SO methane CH4 nitrogen dioxide NO2 nitrous oxide N2O oxygen O2 argon Ar strontium Sr 90Sr SrF3 yttrium Y zirconium Zr ZrF3 trace isotope analysis superhalogen anion secondary ion mass spectrometry SIMS Cs sputter ion source rf quadrupole ion trajectory simulation anion gas reactions negative ion gas reactions gas-phase anion reactions S- + NO2 SO- + NO2 S- + N2O S- + O2 S- + Ar Cl- + NO2 Cl- + Ar Cl- + CH4 SrF3- + NO2 YF3- + NO2 ZrF3- + NO2 C3- + NO2 0768 0494 0605
3	A Radio Frequency Quadrupole Instrument for use with Accelerator Mass Spectrometry: Application to Low Kinetic Energy Reactive Isobar Suppression and Gas–phase Anion Reaction Studies Eliades, John Alexander 21 August 2012 (has links) A radio frequency (rf) quadrupole instrument, currently known as an Isobar Separator for Anions (ISA), has been integrated into an Accelerator Mass Spectrometry (AMS) system to facilitate anion–gas reactions before the tandem accelerator. An AMS Cs+ sputter source provided > 15 keV ions that were decelerated in the prototype ISA to < 20 eV for reaction in a single collision cell and re-accelerated for AMS analysis. Reaction based isobar suppression capabilities were assessed for smaller AMS systems and a new technique for gas–phase reaction studies was developed. Isobar suppression of 36S– and 12C3– for 36Cl analysis, and YF3– and ZrF3– for 90Sr analysis were studied in NO2 with deceleration to < 12 eV. Observed attenuation cross sections, σ [x 10^–15 cm^2], were σ(S– + NO2) = 6.6, σ(C3– + NO2) = 4.2, σ(YF3– + NO2) = 7.6, σ(ZrF3– + NO2) = 19. With 8 mTorr NO2, relative attenuations of S–/Cl– ~ 10^–6, C3–/Cl– ~ 10^–7, YF3–/SrF3– ~ 5 x 10^–5 and ZrF3–/SrF3– ~ 4 x 10^–6 were observed with Cl– ~ 30% and SrF3– > 90% transmission. Current isobar attenuation limits with < 1.75 MV accelerator terminal voltage and ppm impurity levels were calculated to be 36S–/Cl– ~ 4 x 10^–16, 12C3–/Cl– ~ 1.2 x 10^–16, 90YF3–/SrF3– ~ 10^–15 and 90ZrF3–/SrF3– ~ 10^–16. Using 1.75 MV, four 36Cl reference standards in the range 4 x 10^–13 < 36Cl/Cl < 4 x 10^–11 were analyzed with 8 mTorr NO2. The measured 36Cl/Cl ratios plotted very well against the accepted values. A sample impurity content S/Cl < 6 x 10^–5 was measured and a background level of 36S–/Cl < 9 x 10^–15 was determined. Useful currents of a wide variety of anions are produced in AMS sputter sources and molecules can be identified relatively unambiguously by stripping fragments from tandem accelerators. Reactions involving YF3–, ZrF3–, S– and SO– + NO2 in the ISA analyzed by AMS are described, and some interesting reactants are identified. radio frequency quadrupole rf quadrupole accelerator mass spectrometry AMS gas-phase reactions isobar suppression anion negative ion chlorine Cl 36Cl carbon trimer C3 sulphur sulfur sulphur oxide sulfur oxide SO methane CH4 nitrogen dioxide NO2 nitrous oxide N2O oxygen O2 argon Ar strontium Sr 90Sr SrF3 yttrium Y zirconium Zr ZrF3 trace isotope analysis superhalogen anion secondary ion mass spectrometry SIMS Cs sputter ion source rf quadrupole ion trajectory simulation anion gas reactions negative ion gas reactions gas-phase anion reactions S- + NO2 SO- + NO2 S- + N2O S- + O2 S- + Ar Cl- + NO2 Cl- + Ar Cl- + CH4 SrF3- + NO2 YF3- + NO2 ZrF3- + NO2 C3- + NO2 0768 0494 0605

1

Page generated in 0.0936 seconds