Spelling suggestions: "subject:"phasedarray antennas"" "subject:"beadarray antennas""
51 |
Wideband planar array antennas: theory and measurementsShively, David G. January 1988 (has links)
The need for a wide bandwidth array is introduced and explained. Basic planar array principles are reviewed as well as previous work performed on wide bandwidth planar array design. An Archimedean spiral is suggested for the array element and a model for the element radiation pattern is presented. A wide bandwidth linear array is then analyzed using the element model. The array is made to operate over a two octave bandwidth by using an alternate number of elements. This idea is then extended to two dimensions to form a wide bandwidth planar array design. An improved array design is then suggested using fewer elements. This array was fabricated and tested and showed close agreement to theoretically predicted radiation patterns. / M.S.
|
52 |
Digital phased array architectures for radar and communications based on off-the-shelf wireless technologiesOng, Chin Siang 12 1900 (has links)
Approved for public release, distribution is unlimited / This thesis is a continuation of the design and development of a three-dimensional 2.4 GHz digital phased array radar antenna. A commercial off-the-shelf quadrature modulator and demodulator were used as phase shifters in the digital transmit and receive arrays. The phase response characteristic of the demodulator was measured and the results show that the phase difference between the received phase and transmit phase is small. In order to increase the bandwidth of the phased array, a method of time-varying phase weights for linear frequency modulated signal was investigated. Using time-varying phase weights on transmit and receive give the best performance, but require the range information of the target. It is more practical to use time-varying phase weights on only one side (transmit or receive but not both), and constant phase weights on the other side. The simulation results showed that by using time-varying phase weights, the matched filter loss is not as severe as it is when using the conventional fixed weights technique. It was also found that this method is only effective for small scan angles when the time-bandwidth product is large. The approach to implement time-varying phase weights on transmit using commercial components such as direct digital synthesizer and quadrature modulator is discussed. / Civilian, Ministry of Defense, Singapore
|
53 |
Adaptive Beam Control Of Dual Beam Phased Array Antenna SystemSemsir, Emine Zeynep 01 June 2009 (has links) (PDF)
In this study, the Dual Beam Phased Array Antenna System designed for COST260* project is upgraded to have the abilities of beam steering, tracking and direction finding by providing the necessary computer codes using C++ Programming Language. The functions of new prototype are tested to verify the operation.
*COST260 project was an adaptive phased array receiving antenna system for satellite communication, which was operating at 11.49-11.678 GHz band.
|
54 |
Design and Polarimetric Calibration of Dual-Polarized Phased Array Feeds for Radio AstronomyWebb, Taylor D. 05 July 2012 (has links) (PDF)
Research institutions around the globe are developing phased array feed (PAF) systems for wide-field L-band radio astronomical observations. PAFs offer faster survey speeds and larger fields of view than standard single-pixel feeds, which enable rapid sky surveys and significantly increased scientific capability. Because deep space astronomical signals are inherently weak, PAF systems must meet stringent noise and sensitivity requirements. Meeting these requirements requires detailed modeling of the phased array itself as well as the reflector it is mounted on. This thesis details a novel approach to dual-pol PAF design that models the array and reflector as a complete system in order to achieve a more optimal sensitivity and system noise temperature. The design and construction of two arrays designed using this technique is discussed. The implementation of a data acquisition system to receive data from the first of these arrays is also detailed. Polarization state information plays an important role in understanding cosmological processes for many deep space sources. Because of phase and gain imbalances in the LNAs and receiver chains calibration is required for accurate measurement of polarization by phased array feeds. As a result accurate polarimetric calibration techniques are essential for many observations. Existing polarimetric calibration methods are based on assumptions about the form of the system Mueller matrix that limit the generality of the method or require long observations of a polarized source which is time-consuming for multiple PAF beams. This thesis introduces a more efficient method of calibration that uses only three snapshot observations of bright astronomical calibrator sources, one unpolarized and two partially polarized. The design of an engineering array for the Green Bank Telescope is discussed. Measured results from a prototype element are presented along with simulated on-reflector results for the full array. Simulations predict that the array will be the highest sensitivity dual pol feed built by the Radio Astronomy Systems group at Brigham Young University to date.
|
55 |
Development of Monolithic SiGe and Packaged RF MEMS High-Linearity Five-bit High-Low Pass Phase Shifters for SoC X-band T/R ModulesMorton, Matthew Allan 16 May 2007 (has links)
A comprehensive study of the High-pass/Low-pass topology has been performed, increasing the understanding of error sources arising from bit layout issues and fabrication tolerances. This included a detailed analysis of error sources in monolithic microwave phase shifters due to device size limitations, inductor parasitics, loading effects, and non-ideal switches. Each component utilized in the implementation of a monolithic high-low pass phase shifter was analyzed, with its influence on phase behavior shown in detail. An emphasis was placed on the net impact on absolute phase variation, which is critical to the system performance of a phased array radar system. The design of the individual phase shifter filter sections, and the influence of bit ordering on overall performance was also addressed.
A variety of X-band four- and five-bit phase shifters were fabricated in a 200 GHz SiGe HBT BiCMOS technology platform, and further served to validate the analysis and design methodology. The SiGe phase shifter can be successfully incorporated into a single-chip T/R module forming a system-on-a-chip (SoC).
Reduction in the physical size of transmission lines was shown to be a possibility with spinel magnetic nanoparticle films. The signal transmission properties of phase lines treated with nanoparticle thin films were examined, showing the potential for significant size reduction in both delay line and High-pass/Low-pass phase topologies.
Wide-band, low-loss, and near-hermetic packaging techniques for RF MEMS devices were presented. A thermal compression bonding technique compatible with standard IC fabrication techniques was shown, that uses a low temperature thermal compression bonding method that avoids plastic deformations of the MEMS membrane.
Ultimately, a system-on-a-package (SoP) approach was demonstrated that utilized packaged RF MEMS switches to maintain the performance of the SiGe phase shifter with much lower loss. The extremely competitive performance of the MEMS-based High-pass/Low-pass phase shifter, despite the lack of the extensive toolkits and commercial fabrication facilities employed with the active-based SiGe phase shifters, confirms both the effectiveness of the detailed phase error analysis presented in this work and the robust nature of the High-pass/Low-pass topology.
|
56 |
Development and integration of silicon-germanium front-end electronics for active phased-array antennasCoen, Christopher T. 05 July 2012 (has links)
The research presented in this thesis leverages silicon-germanium (SiGe) heterojunction bipolar transistor (HBT) technology to develop microwave front-end electronics for active phased-array antennas. The highly integrated electronics will reduce costs and improve the feasibility of snow measurements from airborne and space-borne platforms. Chapter 1 presents the motivation of this research, focusing on the technological needs of snow measurement missions. The fundamentals and benefits of SiGe HBTs and phased-array antennas for these missions are discussed as well. Chapter 2 discusses SiGe power amplifier design considerations for radar systems. Basic power amplifier design concepts, power limitations in SiGe HBTs, and techniques for increasing the output power of SiGe HBT PAs are reviewed. Chapter 3 presents the design and characterization of a robust medium power X-band SiGe power amplifier for integration into a SiGe transmit/receive module. The PA design process applies the concepts presented in Chapter 2. A detailed investigation into measurement-to-simulation discrepancies is outlined as well. Chapter 4 discusses the development and characterization of a single-chip X-band SiGe T/R module for integration into a very thin, lightweight active phased array antenna panel. The system-on-package antenna combines the high performance and integration potential of SiGe technologies with advanced substrates and packaging techniques to develop a high performance scalable antenna panel using relatively low-cost materials and silicon-based electronics. The antenna panel presented in this chapter will enable airborne SCLP measurements and advance the technology towards an eventual space-based SCLP measurement instrument that will satisfy a critical Earth science need. Finally, Chapter 5 provides concluding remarks and discusses future research directions.
|
57 |
A 5 GHz BiCMOS I/Q VCO with 360° variable phase outputs using the vector sum methodOpperman, Tjaart Adriaan Kruger. January 2009 (has links)
Thesis (M.Eng.(Microelectronic Engineering))--University of Pretoria, 2009. / Includes summaries in Afrikaans and English. Includes bibliographical references (leaves [74]-78). Mode of access: World Wide Web.
|
58 |
RFI Mitigation and Discrete Digital Signal Processing RFSoC Algorithm Implementations for Radio Astronomy and Wideband Communication SystemsWard, Devon Christopher 28 March 2024 (has links) (PDF)
Due to the massive increase of active transmitters broadcasting over wideband frequencies, such as 5G wireless systems, LEO/MEO satellites, satellite constellations, and the increase of IoT devices in the average home, the radio frequency spectrum is becoming more and more congested by interference. Passive receivers face additional challenges due to the growing use of wideband frequency transmissions aimed at boosting communication system throughput. As a result, passive receivers must adopt more robust and intricate techniques to mitigate radio frequency interference. A proposed RFI removal system, known as the true time delay Hadamard projection algorithm, has been introduced in previous work to eliminate a single RFI source while preserving a narrowband signal of interest. An RF frontend is developed to assess the effectiveness of the Hadamard projection algorithm implemented on an RFSoC ZCU216. Additionally, the TTD Hadamard projection algorithm is expanded to enable the cancellation of multiple RFI sources rather than just a single source for a uniform linear array and a uniform rectangular array. Over-the-air tests are conducted to verify the performance of the interference cancellation algorithms and demonstrate the algorithms' ability to preserve the signals of interest while removing the wideband interference. Multiple algorithms are proposed to estimate the time delays used by the interference cancellation algorithm to effectively eliminate wideband interference. These algorithms address diverse scenarios encompassing interference sources ranging from strong to weak SNR. Detailed reports of algorithm performance provide insights into their effectiveness and suitability across specific interference conditions.
|
59 |
Genetic algorithm design and testing of a random element 3-D 2.4 GHZ phased array transmit antenna constructed of commercial RF microchipsEsswein, Lance C. 06 1900 (has links)
Approved for public release, distribution is unlimited / The United States Navy requires radical and innovative ways to model and design multifunction phased array radars. This thesis puts forth the concept that Genetic Algorithms, computer simulations that mirror the natural selection process to develop creative solutions to complex problems, would be extremely well suited in this application. The capability of a Genetic Algorithm to predict adequately the behavior of an array antenna with randomly located elements was verified with expected results through the design, construction, development and evaluation of a test-bed array. The test-bed array was constructed of commercially available components, including a unique and innovative application of a quadrature modulator microchip used in commercial communications applications. Corroboration of predicted beam patterns from both Genetic Algorithm and Method of Moments calculations was achieved in anechoic chamber measurements conducted with the test-bed array. Both H-plane and E-plane data runs were made with several phase steered beams. In all cases the measured data agreed with that predicted from both modeling programs. Although time limited experiments to beam forming and steering with phase shifting, the test-bed array is fully capable of beam forming and steering though both phase shifting and amplitude tapering. / Outstanding Thesis / Lieutenant Commander, United States Navy
|
60 |
Front-end considerations for next generation communication receiversRoy, Mousumi January 2011 (has links)
The ever increasing diversity in communication systems has created a demand for constant improvements in receiver components. This thesis describes the design and characterisation of front-end receiver components for various challenging applications, including characterisation of low noise foundry processes, LNA design and multi-band antenna design. It also includes a new theoretical analysis of noise coupling in low noise phased array receivers.In LNA design much depends on the choice of the optimum active devices. A comprehensive survey of the performance of low noise transistors is therefore extremely beneficial. To this end a comparison of the DC, small-signal and noise behaviours of 10 state-of-the-art GaAs and InP based pHEMT and mHEMT low noise processes has been carried out. Their suitability in LNA designs has been determined, with emphasis on the SKA project. This work is part of the first known detailed investigation of this kind. Results indicate the superiority of mature GaAs-based pHEMT processes, and highlight problems associated with the studied mHEMT processes. Two of the more promising processes have then been used to design C-band and UHF-band MMIC LNAs. A new theoretical analysis of coupled noise between antenna elements of a low noise phased array receiver has been carried out. Results of the noise wave analysis, based on fundamental principles of noisy networks, suggest that the coupled noise contribution to system noise temperatures should be smaller than had previously been suggested for systems like the SKA. The principles are applicable to any phased array receiver. Finally, a multi-band antenna has been designed and fabricated for a severe operating environment, covering the three extremely crowded frequency bands, the 2.1 GHz UMTS, the 2.4 GHz ISM and the 5.8 GHz ISM bands. Measurements have demonstrated excellent performance, exceeding that of equivalent commercial antennas aimed at similar applications.
|
Page generated in 0.1974 seconds