Spelling suggestions: "subject:"resonator "" "subject:"eesonator ""
271 |
Optically Transduced Two-Dimensional (2D) Resonant Nanoelectromechanical Systems and Their Emerging ApplicationsLee, Jaesung 08 February 2017 (has links)
No description available.
|
272 |
Understanding Impact Load Wave Transmission Performance of Elastic Metamaterials.Khan, Md Mahfujul H. January 2016 (has links)
No description available.
|
273 |
Modeling and design of resonators for electron paramagnetic resonance imaging and ultra high field magnetic resonance imagingStefan, Anca Irina 02 December 2005 (has links)
No description available.
|
274 |
Investigation of spectral properties of broadband photon-pairs generated by four-wave mixing in an on-chip ring resonator / リング共振器内で四光波混合により発生する広帯域光子対のスペクトルに関する研究Sugiura, Kenta 23 March 2022 (has links)
付記する学位プログラム名: 京都大学卓越大学院プログラム「先端光・電子デバイス創成学」 / 京都大学 / 新制・課程博士 / 博士(工学) / 甲第23904号 / 工博第4991号 / 新制||工||1779(附属図書館) / 京都大学大学院工学研究科電子工学専攻 / (主査)教授 竹内 繁樹, 教授 川上 養一, 准教授 浅野 卓 / 学位規則第4条第1項該当 / Doctor of Philosophy (Engineering) / Kyoto University / DGAM
|
275 |
Performance considerations in high-speed TDFA-band silicon photonic micro-ring resonator modulatorsHagan, David January 2019 (has links)
The ever-increasing bandwidth requirements to support telecommunications infrastructure
necessitates large-scale fabrication of low-cost and scalable silicon photonic integrated circuits. Wavelength-division multiplexing (WDM) schemes are fundamentally limited in the number of channels supported in long-haul transmission by the erbium doped fiber amplifier (EDFA). To address this, researchers have turned focus toward the thulium doped fiber amplifier (TDFA), which provides 3× more bandwidth. This thesis describes the development of high-speed silicon-on-insulator (SOI) micro-ring resonator (MRR) modulators optimized for wavelengths in the TDFA band. Chapter 2 presents a theoretical performance comparison between MRR modulators designed for optimized use at EDFA and TDFA wavelengths. Chapter 3 presents an experimental study of optical loss mechanisms at extended wavelengths which suggests reduced waveguide scattering and enhanced divacancy defect absorption as well as larger bending and substrate leakage losses when compared with shorter wavelengths. An electronic variable optical attenuator is characterized in Chapter 4 to experimentally verify the predicted 1.7× TDFA-band free-carrier effect enhancement over EDFA-band wavelengths. The
first steady-state operation of an MMR modulator near a central wavelength of 1.97 µm is also demonstrated under the enhanced free-carrier effect. Chapter 5 demonstrates the first high-speed reverse bias operation of an MRR modulator with a measured bandwidth of 12.5 GHz, and an on-chip optical link consisting of a modulator followed by a defectmediated detector with open eye-diagrams up to data rates of 12.5 Gbps. Chapter 6 introduces an electrically-driven post-fabrication defect-assisted resonance trimming technique via local annealing for use in MRR devices. Chapter 7 presents a Monte Carlo simulation of resonance alignment in multi-MRR systems subjected to spatially-correlated wafer variation created through the Virtual Wafer Model process to predict thermal power consumption and power reduction through resonance trimming. / Thesis / Doctor of Philosophy (PhD)
|
276 |
Compact Dielectric Resonator Antenna with Band-Notched Characteristics for Ultra-Wideband ApplicationsMajeed, Asmaa H., Abdullah, Abdulkareem S., Sayidmarie, Khalil H., Abd-Alhameed, Raed, Elmegri, Fauzi January 2015 (has links)
Yes / In this paper, a compact dielectric resonator antenna (DRA) with band-notched
characteristics for ultra-wideband applications is presented. A comprehensive parametric study was
carried out using CST Microwave Studio Suite TM 2011 to analyze and optimize the characteristics of
the proposed antenna. Three shapes for the coupling slot were investigated. Simulation results show
that the proposed DRA had a −10 dB impedance bandwidth of 23% from 9.97 GHz to 12.558 GHz, and a
maximum gain of 7.23 dBi. The antenna had a notched band centered at 10.57 GHz, which increased the
reflection coefficient by 23.5 dB, and reduced the gain by 6.12 dB. The optimized designs were verified
by experimental tests on fabricated samples.
|
277 |
Compact and Highly Sensitive Bended Microwave Liquid Sensor Based on a Metamaterial Complementary Split-Ring ResonatorMosbah, S., Zebiri, C., Sayad, D., Elfergani, Issa T., Bouknia, M.L., Mekki, S., Zegadi, R., Palandoken, M., Rodriguez, J., Abd-Alhameed, Raed 27 March 2022 (has links)
Yes / In this paper, we present the design of a compact and highly sensitive microwave sensor based on a metamaterial complementary split-ring resonator (CSRR), for liquid characterization at microwave frequencies. The design consists of a two-port microstrip-fed rectangular patch resonating structure printed on a 20 × 28 mm2 Roger RO3035 substrate with a thickness of 0.75 mm, a relative permittivity of 3.5, and a loss tangent of 0.0015. A CSRR is etched on the ground plane for the purpose of sensor miniaturization. The investigated liquid sample is put in a capillary glass tube lying parallel to the surface of the sensor. The parallel placement of the liquid test tube makes the design twice as efficient as a normal one in terms of sensitivity and Q factor. By bending the proposed structure, further enhancements of the sensor design can be obtained. These changes result in a shift in the resonant frequency and Q factor of the sensor. Hence, we could improve the sensitivity 10-fold compared to the flat structure. Subsequently, two configurations of sensors were designed and tested using CST simulation software, validated using HFSS simulation software, and compared to structures available in the literature, obtaining good agreement. A prototype of the flat configuration was fabricated and experimentally tested. Simulation results were found to be in good agreement with the experiments. The proposed devices exhibit the advantage of exploring multiple rapid and easy measurements using different test tubes, making the measurement faster, easier, and more cost-effective; therefore, the proposed high-sensitivity sensors are ideal candidates for various sensing applications. / This work was supported by the Moore4Medical project, funded within ECSEL JU in collaboration with the EU H2020 Framework Programme (H2020/2014–2020) under grant agreement H2020-ECSEL-2019-IA-876190, and the Fundação para a Ciência e Tecnologia (ECSEL/0006/2019). This project received funding in part from the DGRSDT (Direction Générale de la Recherche Scientifique et du Développement Technologique), MESRS (Ministry of Higher Education and Scientific Research), Algeria. This work was also supported by the General Directorate of Scientific Research and Technological Development (DGRSDT)–Ministry of Higher Education and Scientific Research (MESRS), Algeria, and funded by the FCT/MEC through national funds and, when applicable, co-financed by the ERDF, under the PT2020 Partnership Agreement under the UID/EEA/50008/2020 project.
|
278 |
Time-varying Small Antennas for Wideband ApplicationsSalehi, Mohsen 18 December 2013 (has links)
A desirable goal in wireless communication systems is to achieve a high-rate data transmission through electrically small antennas. However, the overall transmission bandwidth is limited by the antenna size. As a well-known physical limitation, maximum achievable bandwidth of a small antenna is governed by the fundamental limit which defines a lower bound on the antenna quality factor. This limit is a function of electrical size of the antenna and therefore, as the antenna shrinks in size the bandwidth decreases as well. This dissertation presents a new technique to decouple the impedance bandwidth of a high-Q antenna from the information bandwidth in order to provide a wideband data-transmission. This technique controls the natural resonant frequencies of an electrically small antenna in a time-varying fashion such that ultra-fast frequency-shift keying modulation can be achieved regardless of the narrow bandwidth of the antenna. A major advantage of the proposed technique is that the high-Q property of a miniaturized antenna is a desirable design parameter rather than a limiting factor. Therefore, the antenna size can be reduced as much as required. It is shown that if the fundamental resonance of an antenna is shifted in time, the frequency of the near-zone fields which construct the reactive stored energy, changes momentarily and hence, the radiating fields track any instantaneous variation of the antenna fundamental resonance. This characteristic is utilized to employ a single-mode high-Q antenna in the transient state and modulate the fundamental resonant frequency according to the baseband data information. This approach leads to a new class of compact transmitters with a minimized architecture and high data-rate transmission capability. / Ph. D.
|
279 |
Two Elements Elliptical Slot CDRA Array with Corporate Feeding For X-Band ApplicationsAbdullah, Abdulkareem S., Majeed, Asmaa H., Sayidmarie, Khalil H., Abd-Alhameed, Raed 04 1900 (has links)
Yes / In this paper, a compact two-element cylindrical dielectric resonator antenna (CDRA) array with corporate feeding is proposed for X-band applications. The dielectric resonator antenna (DRA) array is excited by a microstrip feeder using an efficient aperture-coupled method. The designed array antenna is analyzed using a CST microwave studio. The fabricated sample of the proposed CDRA antenna array showed bandwidth extending from 10.42GHz to 12.84GHz (20.8%). The achieved array gain has a maximum of 9.29dBi at frequency of 10.7GHz. This is about 2.06dBi enhancement of the gain in comparison with a single pellet CDRA. The size of the whole antenna structure is about 50 x 50mm2.
|
280 |
Radiation Pressure induced Nonlinearity in Micro-dropletLee, Aram 15 December 2016 (has links)
Optical resonators such as silica micro-spheres and micro-toroids can support whispering gallery modes (WGMs), where light circulates near the resonator surface and is confined by the total internal reflection at the dielectric boundary. Such resonators can exhibit very high quality (Q) factors, since the resonator surface can maintain atomic level smoothness. The combination of high Q factors and small resonator volumes has led to a wide range of applications in sensing, optomechanics, nonlinear optics, and quantum optics.
In this dissertation, we introduce a new type of whispering gallery resonators (WGRs) based on micro-droplets in an immiscible liquid-liquid system. Within such an all-liquid platform, it is possible to achieve highly nonlinear coupling between light and liquid that can potentially lead to single-photon level optical nonlinearity. Specifically, we experimentally characterize a droplet (D~500um) of index matching fluid submerged in the water as a high-Q optical resonator, where we use an optical fiber taper to couple light into the droplet through non-contact evanescent coupling. The highest Q-factor observed in the experiment is 2x10^7 which closely matches the upper limit of intrinsic Q-factor set by the material absorption. Given with such a high Q factor, the WGM can exert strong radiation pressure on the droplet interface, push it outward, increase the length of optical path, and produce a red-shift in WGM resonance. Our experimental results have found that the ratio of those resonance shifts and the optical power coupled into the resonator is approximately 60 fm/μW. The result closely matches to our steady-state estimation based on solving the coupled Maxwell-Navier-Stokes equation. To investigate the dynamic interplay of light and liquid, we develop a harmonic oscillator (HO) model to describe the time-domain behaviors of the coupled optofluidic system. We find a good agreement between theoretical predictions and our experimental data.
The shift of WGM resonance can potentially be induced by thermal effects. To estimate the magnitude of thermal effects, we also investigate the thermally induced nonlinear behaviors of WGMs in a cylindrical fiber resonator (D~125um), where we change the mechanism of heat dissipation by changing the cladding material (e.g. air and water). For direct temperature measurements, we use a fiber optical resonator with a fiber Bragg grating (FBG) inscribed in the fiber core to observe temperature shifts induced by the high-Q WGMs. Our result shows that the temperature increase in the fiber resonator in the water is 0.13 C, whereas the fiber resonator in air shows ~4.5 C increase in temperature. Our results suggest that the relatively high thermal conductivity of water suppresses thermal nonlinearity by ~50 times, and that the red-shifts of WGMs can largely be attributed to radiation pressure effect. / Ph. D.
|
Page generated in 0.0583 seconds