京都大学 / 0048 / 新制・論文博士 / 博士(医学) / 乙第13329号 / 論医博第2197号 / 新制||医||1044(附属図書館) / 京都大学大学院医学研究科医学専攻 / (主査)教授 伊達 洋至, 教授 森本 尚樹, 教授 川口 義弥 / 学位規則第4条第2項該当 / Doctor of Medical Science / Kyoto University / DFAM

This master`s thesis is focused on possibility of use of flue gas as source of CO2 for algae cultivation in bioreactors. The first part of the master`s thesis is devoted to a qualitative and quantitative description of flue gas sources as CO2 source for algae cultivation. In the thesis industry sectors with the largest share of CO2 emissions on a global scale and in the Czech republic are summarized. On the basis of these data it was possible to determine cheap sources of CO2 for algae cultivation producing valuable biomass and other bio-products. The composition of flue gas from these sources was discussed in this section also with given expected outlook within the following years. The next part of the thesis is devoted to the influence of flue gas properties on algae cultivation. The impact of flue gas individual parameters on cell growth rate, quality and composition of biomass is described there. The description and design of the bioreactor is processed in the next part of the thesis. The experimental part of the thesis was performed on a bioreactor with similar properties. The next part of the thesis describes the effect of light on algae cultivation and the design of a regulation scheme for bioreactor light source. The experimental part of the thesis describes methods used to determine the concentrations of flue gas substances that could pass from flue gas into cultivation medium for algae cultivation to measure the changing composition of the flue gas in the closed experimental bioreactor system. The processed data from experimental measurements are presented and are discussed. The change in the composition of the culture medium for algae (without the presence of algae) due to flue gas aeration was monitored in the experimental part. It includes also the measurement of the change in the composition of the flue gas in time. All obtained and collected information are then summarized and discussed in the final part of the master`s thesis.

This thesis deal with improvement behavior of temperature control in bioreactor. It was created model of system. Basic PI controller could solve all problems. After analysis of system were decided to used fuzzy controller. Fuzzy controller in comparison with classic PI controller has better behavior in this application.

Membrane bioreactors (MBRs) offer promising solution for wastewater treatment and reuse to address the problem of water scarcity. Nevertheless, this technology is still facing challenges associated with membrane biofouling. This phenomenon has been mainly investigated in lab-scale MBRs with little or no insight on biofouling in full-scale MBR plants. Furthermore, the temporal dynamics of biofouling microbial communities and their extracellular polymeric substances (EPS) are less studied. Herein, a multidisciplinary approach was adopted to address the above knowledge gaps in lab- and full-scale MBRs. In the full-scale MBR study, 16S rRNA gene pyrosequencing with multivariate statistical analysis revealed that the early and mature biofilm communities from five full-scale MBRs differed significantly from the source community (i.e. activated sludge), and random immigration of species from the source community was unlikely to shape the community structure of biofilms. Also, a core biofouling community was shared between the five MBR plants sampled despite differences in their operating conditions. In the lab-scale MBR studies, temporal dynamics of microbial communities and their EPS products were monitored on different hydrophobic and hydrophilic membranes during 30 days. At the early stages of filtration (1 d), the same early colonizers belonging to the class Betaproteobacteria were identified on all the membranes. However, their relative abundance decreased on day 20 and 30, and sequence reads belonging to the phylum Firmicutes and Chlorobi became dominant on all the membranes on day 20 and 30. In addition, the intrinsic membrane characteristic did not select any specific EPS fractions at the initial stages of filtration and the same EPS foulants developed with time on the hydrophobic and hydrophilic membranes. Our results indicated that the membrane surface characteristics did not select for specific biofouling communities or EPS foulants, and the same early colonizers were selected from the source community (i.e. activated sludge), and then went through significant changes to form a mature biofilm. Our findings from these studies could support future research aimed at developing enhanced biological-based strategies to control biofouling in MBRs.

Shortage of potable water is a problem that affects many nations in the world and it will aggravate in a near future if pertinent actions are not carried out. Decrease in consumption, improvements in water distribution systems to avoid losses and more efficient water treatment processes are some actions that can be implemented to attack this problem. Membrane technology and biological processes are used in wastewater treatment to achieve high water quality standards. Some other technologies, besides water treatment, attempt to obtain energy from organic wastes present in water. In this study, a proof-of-concept was accomplished demonstrating that a Microbial Electrolysis Cell can be fully integrated with a Membrane Bioreactor to achieve wastewater treatment and harvest energy. Conductive hollow fiber membranes made of nickel functioned as both filter material for treated water reclamation and as a cathode to catalyze hydrogen production reaction. The produced hydrogen was subsequently converted into methane by hydrogenotrophic methanogens. Organic removal was 98.9% irrespective of operation mode. Maximum volumetric hydrogen production rate was 0.2 m3/m3d, while maximum current density achieved was 6.1 A/m2 (based on cathode surface area). Biofouling, an unavoidable phenomenon in traditional MBRs, can be minimized in this system through self-cleaning approach of hybrid membranes by hydrogen production. The increased rate of hydrogen evolution at high applied voltage (0.9 V) reduces the membrane fouling. Improvements can be done in the system to make it as a promising net energy positive technology for the low strength wastewater treatment.

Algae are microscopic organisms with a great potential to produce biomass and lipids at productivities several times higher than terrestrial crops. To grow, these organisms consume carbon dioxide (CO2), a greenhouse gas. This gas, emitted primarily by power plants after coal burning, can be effectively used for algae production, thus resulting in CO2 remediation and biomass beneficial utilization as feedstuff, industrial filler and biodiesel feedstock. However, since coal is a fuel mined from the earth’s crust, it contains heavy metals that are released during coal burning and inevitably enter the algal cultivation system, contaminating the water were algae is grown, the algal biomass and the products derived from such biomass. The distribution of heavy metals from flue gas in algal cultivation systems is unknown, yet necessary to advance this industry. This study focused on quantifying the distribution and effects that ten coal-derived heavy metals (Cu, Co, Zn, Pb, As, Se, Cr, Hg, Ni and Cd) will have on algae strain Scenedesmus obliquus and on the potential products derived from this algae.

abstract: Zero-Valent Metals (ZVM) are highly reactive materials and have been proved to be effective in contaminant reduction in soils and groundwater remediation. In fact, zero-Valent Iron (ZVI) has proven to be very effective in removing, particularly chlorinated organics, heavy metals, and odorous sulfides. Addition of ZVI has also been proved in enhancing the methane gas generation in anaerobic digestion of activated sludge. However, no studies have been conducted regarding the effect of ZVM stimulation to Municipal Solid Waste (MSW) degradation. Therefore, a collaborative study was developed to manipulate microbial activity in the landfill bioreactors to favor methane production by adding ZVMs. This study focuses on evaluating the effects of added ZVM on the leachate generated from replicated lab scale landfill bioreactors. The specific objective was to investigate the effects of ZVMs addition on the organic and inorganic pollutants in leachate. The hypothesis here evaluated was that adding ZVM including ZVI and Zero Valent Manganese (ZVMn) will enhance the removal rates of the organic pollutants present in the leachate, likely by a putative higher rate of microbial metabolism. Test with six (4.23 gallons) bioreactors assembled with MSW collected from the Salt River Landfill and Southwest Regional Landfill showed that under 5 grams /liter of ZVI and 0.625 grams/liter of ZVMn additions, no significant difference was observed in the pH and temperature data of the leachate generated from these reactors. The conductivity data suggested the steady rise across all reactors over the period of time. The removal efficiency of sCOD was highest (27.112 mg/lit/day) for the reactors added with ZVMn at the end of 150 days for bottom layer, however the removal rate was highest (16.955 mg/lit/day) for ZVI after the end of 150 days of the middle layer. Similar trends in the results was observed in TC analysis. HPLC study indicated the dominance of the concentration of heptanoate and isovalerate were leachate generated from the bottom layer across all reactors. Heptanoate continued to dominate in the ZVMn added leachate even after middle layer injection. IC analysis concluded the chloride was dominant in the leachate generated from all the reactors and there was a steady increase in the chloride content over the period of time. Along with chloride, fluoride, bromide, nitrate, nitrite, phosphate and sulfate were also detected in considerable concentrations. In the summary, the addition of the zero valent metals has proved to be efficient in removal of the organics present in the leachate. / Dissertation/Thesis / Masters Thesis Environmental and Resource Management 2019

No description available.

No description available.

Nitrogen pollution is a growing problem that is detrimental to the environment and the economy. Traditional treatment of nitrogen is a multi-stage process, expensive, operationally intensive, and requires large land areas. This research studied the effects of BiOWiSH® Aqua (Aqua), a biological enhancement product, on the simultaneous nitrification and denitrification process in a membrane aerated bioreactor (MABR) to determine if it is a feasible application for wastewater treatment. The MABR used during experimentation was a small-scale batch reactor with a continuous flow of air through a silicone membrane. The effect of carbon source and concentration on nitrogen removal rates and biomass growth/behavior were determined through a series of laboratory experiments with Aqua and wastewater. With glucose and solely Aqua cultures, average reduction rates in nitrogen concentrations were 1.2 mg-N/L/hour for all C:N ratios investigated. When wastewater was used as the main carbon source, creating a mix of wastewater and Aqua bacteria in the MABR, average reduction rates were 10.9 mg-N/L/hour. A maximum reduction rate of 21.3 mg-N/L/hour occurred at a 2:1 C:N ratio. This research concluded that pure Aqua cultures are not efficient at removing nitrogen or greatly augment the nitrogen reduction process. MABRs can use the biochemical oxygen demand in wastewater as a useful/viable carbon source. High carbon to nitrogen ratios (C:N ratio of 30:1) did not result in faster nitrogen reduction rates but did experience rapid biofilm growth and death. This shows that high C:N ratios are not an efficient operationally for MABRs due to the excess sludge created. C:N ratios of v approximately 3:1 provided the most consistent nitrogen reduction for both glucose and wastewater. This research concluded that C:N ratios, pH, and oxygen diffusion heavily affect the MABR’s performance. In addition, MABRs can utilize low C:N ratios during treatment, particularly during the treatment of high-strength wastewater.