181 |
DTV antennas for mobile applicationsYang, Yu-Chan 06 June 2008 (has links)
The study in this thesis focuses on the DTV antennas for mobile applications. By using the novel techniques in the proposed antenna, the narrow-band problem and the radiation pattern of the conventional DTV antenna can be improved. In the first design, the antenna comprises two radiating arms. By adjusting the open gap between the ends of the two radiating arms, large impedance bandwidth can be obtained for DTV signal reception. In the second design, by integrating a coupling portion into the dipole antenna, the full-wavelength resonant mode can be excited successfully and combined with the half-wavelength mode to form a wide operating band. Finally, in the third design, a U-shaped feeding gap is embedded within the V-shaped antenna to excite the full-wavelength resonant mode. Additionally, the dipole antenna can radiate comparable E£X and E£c components, resulting in no nulls in the total-power radiation patterns in the horizontal and vertical planes.
|
182 |
Small Antennas Design for 2.4 GHz ApplicationsNassar, Ibrahim Turki 04 October 2010 (has links)
In many wireless devices, antennas occupy the majority of the overall size. As compact device sizes become a greater focus in industry, the demand for small antennas escalates. In this thesis, detailed investigations on the design of a planar meandered line antenna with truncated ground plane and 3D dipole antenna at 2.4 GHz (ISM band) are presented. The primary goal of this research is to develop small, low coast, and low profile antennas for wireless sensor applications. The planar meandered line antenna was designed based on a study of different miniaturization techniques and a study of the ground plane effect. The study of the ground plane effect proved that it has a pivotal role on balancing the antenna current. The study of the miniaturization process proved that it affects directly the gain, bandwidth, and efficiency. The antenna efficiency and gain were improved using the truncated ground plane. This antenna has a measured gain of -0.86 dBi and measured efficiency of 49.7%, making it one of the efficient and high gain small antennas. The 3D dipole antenna was designed using a novel method for efficiently exploiting the available volume. This method consists of fabricating the dipole on a cube configuration with opening up the internal volume for other uses. This antenna was tested, and it was found that this antenna has good radiation characteristics according to its occupied volume. Ka of this antenna is 0.55, its measured gain is 1.69 dBi with 64.2% measured efficiency. Therefore, this design is very promising in low-power sensing
applications. A Wheeler Cap was designed for measuring the efficiency and the 3-antenna method was used for measuring the designed antennas gain.
|
183 |
Progress towards directly measuring the membrane dipole field in lipid bicelles using vibrational Stark effect spectroscopyHu, Wenhui, M.A. 16 February 2012 (has links)
The electrostatic field created by the inward pointing dipole moments of an oriented membrane leaflet has never been measured directly, but is thought to have an important influence on membrane function. Here we present the first direct measurement of the membrane dipole field in lipid bicelles using vibrational Stark effect spectroscopy which is based on the sensitivity of a nitrile oscillator’s vibrational frequency to its local electrostatic environment. The nitrile probe was introduced as the artificial amino acid p-cyanophenylalanine (CN-Phe) in four different locations of a α-helical peptide composed of alternating alanine and leucine residues. This peptide was intercalated into bicelles composed of mixtures of the long chain lipids 1,2-dimyristoyl-sn-glycero-3-phosphocholine (DMPC), 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC), or 1-palmitoyl-2-oleoyl-sn-glycero-3-phosphocholine (POPC), and the short chain lipid 1,2-dihexanoyl-sn-glycero-3-phosphocholine (DHPC) formed in two different sizes, 5 nm and 15 nm in radius. Formation of the bicelle above the phase transition temperature of the lipid mixture was confirmed by ³¹P NMR, and the structure of the [alpha]-helix within the bicelle was confirmed by circular dichroic spectroscopy. The absorption energy of the nitrile probe at 4 positions along the helical axis was measured by Fourier transform infrared spectroscopy, from which we estimate the magnitude of the membrane dipole electrostatic field to be -6 MV/cm. Then we successfully manipulated the dipole field in q = 0.5 DMPC/DHPC bicelles by incorporating the small molecule phloretin into the membrane and measured the corresponding ratiometric fluorescence signal of the co-intercalated voltage gated dye di-8-ANEPPS. We measured 0.7 ± 0.2 cm⁻¹ blue shift in absorption energy of the nitrile probe due to the decrease in dipole field caused by phloretin, corresponding to a dipole field of -4.2 MV/cm. This change was essentially identical to what has been estimated through ratiometric fluorescence methods, indicating that VSE spectroscopy will be useful tool for measurement of the biological effects of electrostatic fields in lipid membranes. / text
|
184 |
Experiment to measure the electron electric dipole moment using laser cooled Cs atomsIhn, Yong-Sup 25 September 2013 (has links)
This thesis describes the physics, design, and construction of an experiment to measure the electric dipole moment (EDM) of the electron. In the experiment, laser-cooled Cs atoms will be held in an optical dipole force trap in the presence of applied electric and magnetic fields. The signature of an electron EDM is a first-order electric field shift of the Zeeman resonance frequency of the Cs ground state. We present an analysis of the systematic and statistical errors of this experiment, which shows that the experiment should have a sensitivity of the order of 10⁻²⁹ e-cm. We pay particular attention to potential light-shift induced errors and to magnetic field noise. We also present the design and experimental results for a cold Cs atom source, high voltage field plates, optical trapping field in a resonant build-up cavity, noval titanim ultrahigh vacuum system, and magnetic sheilding system. These results show that a measurement of the electron edm at the level of 10⁻²⁹ e-cm. should be feasible. / text
|
185 |
Seismic sensitivity to variations of rock properties in the productive zone of the Marcellus Shale, WVMorshed, Sharif Munjur 18 February 2014 (has links)
The Marcellus Shale is an important resource play prevalent in several states in the eastern United States. The productive zone of the Marcellus Shale has variations in rock properties such as clay content, kerogen content and pore aspect ratio, and these variations may strongly effect elastic anisotropy. The objective of this study is to characterize surface seismic sensitivity for variations in anisotropic parameters relating to kerogen content and aspect ratio of kerogen saturated pores. The recognized sensitivity may aid to characterize these reservoir from surface seismic observations for exploration and production of hydrocarbon.
In this study, I performed VTI anisotropic modeling based on geophysical wireline log data from Harrison County, WV. The wireline log data includes spectral gamma, density, resistivity, neutron porosity, monopole and dipole sonic logs. Borehole log data were analyzed to characterize the Marcellus Shale interval, and quantify petrophysical properties such as clay content, kerogen content and porosity. A rock physics model was employed to build link between petrophysical properties and elastic constants. The rock physics model utilized differential effective medium (DEM) theory, bounds and mixing laws and fluid substitution equations in a model scheme to compute elastic constants for known variations in matrix composition, kerogen content and pore shape distribution.
The seismic simulations were conducted applying a vertical impulse source and three component receivers. The anisotropic effect to angular amplitude variations for PP, PS and SS reflections were found to be dominantly controlled by the Thomsen Ɛ parameter, characterizing seismic velocity variations with propagation direction. These anisotropic effect to PP data can be seen at large offset (>15o incidence angle). The most sensitive portion of PS reflections was observed at mid offset (15o-30o). I also analyzed seismic sensitivity for variations in kerogen content and aspect ratio of structural kerogen. Elastic constants were computed for 5%, 10%, 20% and 30% kerogen content from rock physics model and provided to the seismic model. For both kerogen content and aspect ratio model, PP amplitudes varies significantly at zero to near offset while PS amplitude varied at mid offsets (12 to 30 degree angle of incidences). / text
|
186 |
The hearing abilities of elasmobranch fishesCasper, Brandon M 01 June 2006 (has links)
The hearing abilities of elasmobranch fishes were examined in response to several types of stimuli using auditory evoked potentials (AEP). Audiograms were acquired for the nurse shark, Ginglymostoma cirratum, the yellow stingray, Urobatis jamaicensis, in a controlled environment using a monopole underwater speaker. A dipole stimulus was used to measure the hearing thresholds of the horn shark, Heterodontus francisi, and the white-spotted bamboo shark, Chiloscyllium plagiosum. The dipole experiments yielded much lower thresholds than any other experiment, suggesting that this type of sound specifically stimulated the macula neglecta by creating a strong velocity flow above the head of the shark. A shaker table was created to measure the directional hearing thresholds of the C. plagiosum and the brown-banded bamboo shark, C. punctatum. This experiment showed that these sharks could sense accelerations equally in all directions suggesting that they have omnidirectional ears. The results also yielded higher thresholds than with the dipole, suggesting that the macula neglecta was not stimulated as the sharks were being accelerated. An audiogram was also acquired for the Atlantic sharpnose shark, Rhizoprionodon terraenovae, using a monopole speaker in the field. This experiment revealed that the hearing thresholds did not appear to be masked by ambient noise levels, and resulting thresholds yielded the lowest levels detected by any elasmobranch using AEPs. Taken together, these experiments show that sharks are most sensitive to low frequency sounds in the near field and use both their otoconial endorgans as well as the macula neglecta to sense particle motion.
|
187 |
Improving the Limit on the Electron EDM: Data Acquisition and Systematics Studies in the ACME ExperimentHess, Paul William 06 June 2014 (has links)
The ACME collaboration has completed a measurement setting a new upper limit on the size of the electron's permanent electric dipole moment (EDM). The existence of the EDM is well motivated by theories extending the standard model of particle physics, with predicted sizes very close to the current experimental limit. The new limit was set by measuring spin precession within the metastable H state of the polar molecule thorium monoxide (ThO). A particular focus here is on the automated data acquisition system developed to search for a precession phase odd under internal and external reversal of the electric field. Automated switching of many different experimental controls allowed a rapid diagnosis of major systematics, including the dominant systematic caused by non-reversing electric fields and laser polarization gradients. Polarimetry measurements made it possible to quantify and minimize the polarization gradients in our state preparation and probe lasers. Three separate measurements were used to determine the electric field that did not reverse when we tried to switch the field direction. The new bound of |de|< 8.7 × 10<sup>-29</sup> e cm is over an order of magnitude smaller than previous limits, and strongly limits T-violating physics at TeV energy scales. / Physics
|
188 |
Extraction and Validation of the FIDEL Field Model Parameters for the Main Dipoles of the LHC / Extrahering och Validering av FIDEL-Fältmodellparametrarna för dipolerna i LHCSernelius, David January 2007 (has links)
The Large Hadron Collider (LHC) is presently under construction at CERN. The LHC is a circular accelerator that stores proton beams and accelerates them to a 7 TeV beam energy for high energy physics research. The required bending and focusing/defocusing fields are achieved with superconducting magnets. Such a superconducting magnet-based accelerator can be controlled only when the field errors of production and installation of all magnetic elements are known to the required accuracy. The ideal way to compensate the field errors is to have direct diagnostics on the beam. For the LHC, however, a system solely based on beam feedback may be too demanding. The present baseline for the LHC control system hence requires an accurate forecast of the magnetic field and the multipole field errors to reduce the burden on the beam-based feedback. The field model is the core of this magnetic prediction system, also known as \emph{the Field Description for the LHC} (FIDEL). The model will provide the forecast of the magnetic field at a given time, magnet operating current, magnet ramp rate, magnet temperature, and magnet powering history. The model is based on the identification and physical decomposition of the effects that contribute to the total field in the magnet aperture of the LHC dipoles. This thesis presents the tool that was constructed to ease the detection, identification and finally correction of errors in the raw data from the series measurements of the main dipoles of the LHC. The results after cleaning all measurement data for the over 240 dipoles measured at cold, using this tool, is also presented. Another aspect of the Thesis is the presentation of a procedure devised to extract the model parameters for the main dipole magnets of the LHC by using the cleaned data. The procedure and the model are verified and validated by application to the magnets of the 7-8 sector of the LHC.
|
189 |
A High-Gain Planar Dipole Antenna for Ultra-Wideband ApplicationsShadrokh, Shahin 31 March 2014 (has links)
In this thesis, a low-profile, high-gain, ultra-wideband (UWB) planar dipole antenna is presented for radar imaging applications. The antenna is loaded with open complementary double concentric split-hexagonal-ring resonators (LC tank) and chip resistors, and backed with a novel double-layer FSS reflector for gain enhancement. A broadband microstrip to parallel-plate transformer is designed as the feeding structure of the antenna to provide impedance matching and balanced-to-unbalanced transition. The measurement results show the proposed antenna operates over the frequency bandwidth of 0.65-3.8 GHz with S11< -10 dB (VSWR) and smooth gains in the range of 6.2-9 dBi.
|
190 |
Understanding Multi-Peak Anomalies for Unexploded Ordnance DiscriminationKushnir, Alexandra R. L. 23 July 2008 (has links)
A workflow for the discrimination of multi-peak anomalies due to an unexploded
ordnance (UXO) is presented. The effects of changes in the depth and orientation of a
subsurface target on its TEM response are explored. Further, the variation of the peak
separation, peak widths, maxima to minimum ratios and maxima values through time are
modelled. Models of spatial and temporal variations are performed for both one and twotargets.
These models are devoid of noise and focus primarily on the 3lb FLBGR bomb.
It is found that the decay of the magnitudes of the anomaly maxima are related to the
decay of the characteristic polarization curves of the UXO that creates them. The
behaviour of the decay of the magnitudes of the maxima values of multi-peak anomalies
is determined to be a good indication of target number in the subsurface. Observing these
decays, it is possible to distinguish between two multi-peak scenarios, namely: a) a multipeak
anomaly produced by a single UXO or two UXOs of the same type; and b) a multipeak
anomaly produced by two UXOs of different types.
|
Page generated in 0.023 seconds