ITC/USA 2005 Conference Proceedings / The Forty-First Annual International Telemetering Conference and Technical Exhibition / October 24-27, 2005 / Riviera Hotel & Convention Center, Las Vegas, Nevada / The four-quadrant frequency discriminator (FQFD) plays an important role in GPS receivers for carrier synchronization. This paper presents a detailed study of the operating principle of the FQFD, and the acquisition performance degradation due to the gain fluctuation of the FQFD is discussed. A modified FQFD called the enveloped-four-quadrant frequency discriminator (Enveloped-FQFD) is proposed, which introduces an envelope calculator on the basis of the FQFD. Performance comparison of the FQFD and the Enveloped-FQFD is given through theoretical analysis and computer simulation. Simulation results show that by employing the Enveloped-FQFD, a quicker pull-in process and a wider threshold than the FQFD can be achieved, while the additional hardware costs are trivial.

International Telemetering Conference Proceedings / October 13-16, 1986 / Riviera Hotel, Las Vegas, Nevada / A digital frequency discriminator (DFD) of the delay-correlator type is described. The device is shown to have an instantaneous frequency measurement capability on very short pulses. The theoretical performance of the DFD in a noisy background is derived and shown to compare favorably with measured results.

In recent years, millions of customers all over the world have been subscribing to mobile telephony services which are based on modern digital transmission. At the high transmission bit rates that these systems use, the mobile radio channel exhibits frequency-selective fading characteristics. Under such conditions, the received signal could experience significant intersymbol interference (ISI) from severe distortion to the waveform of the received baseband signal. Therefore, such techniques as adaptive waveform equalisation or adaptive maximum likelihood sequence estimation (MLSE) are used in modern digital mobile radio telephone systems to combat this undesirable ISI. These adaptive schemes have almost always been used in conjunction with coherent demodulation in the receivers.This study examines the application of noncoherent demodulation, in the form of frequency discriminator detection, as an alternative to coherent demodulation. The GSM (Global System for Mobile Communications) standard has been used as the basis for this investigation. It has been shown analytically that in the presence of frequency-selective fading, a propagation environment common to the GSM system, the use of frequency discriminator detection gives rise to nonlinear ISI in the demodulated signal. It has also been shown that frequency-selective fading could cause large unwanted "spikes" to appear in the demodulated signal, thus leading to a severe degradation in the bit-error-rate (BER) performance. Consequently, several waveform distortion cancellation schemes for combatting the nonlinear ISI have been formulated. The BER performances of these proposed schemes, under various propagation conditions, have been studied by computer simulation.Furthermore, it has been observed that the undesirable "spikes", that occur in the demodulated signal due to frequency-selective fading, could be ++ / suppressed by the use of inverse-limiting in conjunction with frequency discriminator detection. As a result, an effective adaptive detection scheme has been formulated, based on modelling the combination of the GMSK modulator, the mobile channel, the frequency discriminator, and any transmit and receive fitters, as a finite-state machine. The transmitted data is then detected using an MLSE. The BER performance of this proposed adaptive detection scheme has been extensively investigated by computer simulation. This has been carried out assuming various propagation conditions, including the two-ray fading channel model with equal path powers and relative delays of up to four bit periods, the maximum relative delay considered in the GSM system. Also, the effectiveness of the proposed adaptive detection scheme in combatting IS] has been investigated by computer simulation based on the six-ray GSM empirical propagation models for typical urban (TU), hilly terrain (HT) and rural area (RA) environments. The computer simulated results confirm that the voice grade performance required for the GSM system could be achieved by the proposed adaptive detection scheme in all the recommended GSM propagation models considered. Furthermore, the BER performance of the receiver remains unaffected by a carrier frequency offset of up to 2 kHz.

abstract: Pulse Density Modulation- (PDM-) based class-D amplifiers can reduce non-linearity and tonal content due to carrier signal in Pulse Width Modulation - (PWM-) based amplifiers. However, their low-voltage analog implementations also require a linear- loop filter and a quantizer. A PDM-based class-D audio amplifier using a frequency-domain quantization is presented in this paper. The digital-intensive frequency domain approach achieves high linearity under low-supply regimes. An analog comparator and a single-bit quantizer are replaced with a Current-Controlled Oscillator- (ICO-) based frequency discriminator. By using the ICO as a phase integrator, a third-order noise shaping is achieved using only two analog integrators. A single-loop, singlebit class-D audio amplifier is presented with an H-bridge switching power stage, which is designed and fabricated on a 0.18 um CMOS process, with 6 layers of metal achieving a total harmonic distortion plus noise (THD+N) of 0.065% and a peak power efficiency of 80% while driving a 4-ohms loudspeaker load. The amplifier can deliver the output power of 280 mW. / Dissertation/Thesis / Ph.D. Electrical Engineering 2011

In this thesis, RF sections of a multi tier instantaneous frequency measurement (IFM) receiver which can operate in 2 &ndash / 18 GHz frequency band is designed, simulated and partially realized. The designed structure uses one coarse tier, three medium tiers and one fine tier for frequency discrimination. A novel reflective phase shifting technique is developed which enables the design of very wideband phase shifters using stepped cascaded transmission lines. Compared to the classical phase shifters using coupled transmission lines, the new approach came out to be much easier to design and fabricate with much better responses. This phase shifting technique is used in coarse and medium tiers. In fine frequency measurement tier, I/Q discriminator approach is used because reflective phase shifters would necessitate unacceptably long delay lines. Two I/Q discriminators are designed and fabricated using Lange directional couplers that operate in 2-6 GHz and 6-18 GHz, resulting in satisfactory response. Additionally, 6 GHz HP and 6 GHz LP distributed filters are designed and fabricated to be used for these I/Q discriminators in fine tier. In order to eliminate possible ambiguities in coarse tier, a distributed element LP-HP diplexer with 10 GHz crossover frequency is designed and fabricated successfully to be used for splitting the frequency spectrum into 2-10 GHz and 10-18 GHz to ease the design and realization problems. Three power dividers operating in the ranges 2-18 GHz, 2-6 GHz and 6-18 GHz are designed for splitting incoming signals into different branches. All of these dividers are also fabricated with satisfactory response. The fabricated components are all compact and highly reproducible. The designed IFM can tolerate 48 degrees phase margin for resolving ambiguity in the tiers while special precautions are taken in fine tier to help ambiguity resolving process also. The resulting IFM provides a frequency resolution below 1 MHz in case of using an 8-bit sampler with a frequency accuracy of 0.28 MHz rms for 0 dB input SNR and 20 MHz video bandwidth.

A novel photonic frequency discriminator has been developed. The discriminator utilizes a Mach Zehnder interferometer-assisted ring resonator to achieve enhanced linearity. A numerical frequency-domain two-tone test is performed to evaluate the unique design of the discriminator, particularly for suppression of the third order intermodulation distortion. The discriminator is switchable between linear-intensity and linear-field regimes by adjusting a phase delay on one arm of the Mach Zehnder interferometer. Through the simulation, the linear<intensity discriminator is shown to be advantageous. The discriminator is an optical ring resonator-Mach Zehnder interferometer synthesized passive filter. The ring resonator is made of Arsenic trisulfide (As2S3) and the bus waveguide is a Titanium<diffused Lithium niobate (LiNbO3) waveguide. This As2S3 ring-on-Ti:LiNbO3 hybrid structure offers electro-optic tunability of the device owing to a strong electro-optic effect of the substrate material. A large optical confinement factor achieved by vertical integration of the As2S3 strip waveguide on a LiNbO3 substrate enables a low loss ring resonator. The Mach Zehnder interferometer is formed by the optical path length difference of the birefringent LiNbO3 substrate instead of a physical Y-branch structure, which makes the fabrication tolerances relaxed. In order for this highly birefringent device to be characterized, each polarization mode must be measured separately. A novel algorithm which can measure the wavelength-swept Jones matrix including its phase response is devised. The efficacy of the algorithm is demonstrated by characterizing a ring resonator. Finally, the fabricated discriminator is fully characterized using the algorithm.