Mechanical properties of thermal spray deposited coatings are highly influenced by their microstructural characteristics. The objective of this investigation is to evaluate the mechanical properties of thermally sprayed coatings consisted of aluminum and zinc based on the coating microstructure, using an image based computational scheme. Microstructural images of coating samples were subjected to image-based finite element analysis and the results were validated by experimental tests and analytical models. Comparison of the experimental data with FEA was used to explain the microstructural basis of the mechanical characteristics of Al-Zn coatings and the differences between two methods of thermal spray techniques. It was concluded that the cold spraying technique produces higher-quality coatings with less porosity and higher hardness compared to wire arc deposition. An isotropic behavior was observed in the cold sprayed coating. Finally, the electrochemical tests showed that the coating with a higher amount of zinc had better anti-corrosion properties.

No description available.

As one of the most common minerals in crustal rocks, quartz has been widely used as an indicator for shock metamorphism. Shocked quartz is found in the Chicxulub impact crater, an impact crater that has been linked to the Cretaceous-Tertiary extinction ~66 million years ago. The microstructural deformation features found in the shocked quartz do not form randomly, and their orientation provides a better understanding of the impact cratering process. At present, there are no studies of EBSD data analysis of shocked quartz from Chicxulub. We investigated six thin sections from two samples from the M0077A borehole in the lower peak ring of the Chicxulub impact crater, using the Scanning Electron Microscopy (SEM)-EBSD technique. Both samples consist of shocked granite, with a significant amount of quartz.  Therefore, this study investigates the crystallographic preferred orientation (CPO) of shocked quartz and predicts the seismic velocities and anisotropy, based on the EBSD data. We carried out the analysis of EBSD data by using the MATLAB-based MTEX toolbox that can perform CPO analysis from pole figure plots and the prediction of seismic properties of minerals based on the Voigt-Reuss-Hill effective medium method. Although acquiring the EBSD data from these samples is challenging, leading to the lack of data measured, we found out that the prediction of P wave seismic velocity is in good agreement with other recent studies conducted in the same area. The range of predicted P wave velocities is 5.5-6.5 km/s with anisotropy of 8-15%. The actual observed laboratory measurements and in-situ seismic measurements are considerably smaller than this velocity range because our calculations do not incorporate pores or take microcracks into account.  A likely explanation for the large variability of anisotropy in shocked quartz is the relatively few mapped grains with EBSD, which would influence the CPO and lead to high predicted seismic anisotropy. Considering a greaternumber of grains in the CPO analysis, the CPO is reduced, and seismic anisotropy becomes smaller.