Breast cancer presents serious epidemiological problem, in result of which die more than 2 000 czech women every year. Screening mammography is one of the most expanded and most effective examinations for early detection of this desease but one has to take into account an inconsiderable risk connected with the procedure based on X-ray ionizing radiation. This diploma thesis deals with evaluation of the dose absorbed by the tissue. It contains the description of evaluation of the average dose in glandular tissue on PMMA phantom, as well as results of the measurements on conventional and digital mammograph. A data file with exposure parameters from mammography screening is included and interpreted. Also the Monte Carlo method was used for the dose evaluation, the thesis contains the brief description of the method, concept of analysis model in mammography and results of simulations.

The aim of this work is to define relations between grain size and bioaktivity of oxide ceramics, specifically ZrO2, Al2O3 and HA. Ceramic materials with grain size from 100 nm up to 10 m, with various surface roughness, were tested for its bioactivity. Ceramography analysis was performed for all tested materials to precisely describe microstructures. Biological properties of the ceramic materials were tested via dilation tests directly in-vitro and by in-vitro extraction. Three cell culturing lines: osteoblast MG63, fibroblast L929, and epithelioid HeLa, were used for our testing. An influence of the grain size on the biological response was only found for the ceramic materials which had been thermally etched. The thermally etched nanocrystalline samples had larger areas covered by cells than ceramics with coarse grain microstructure. Biological tests on layered composites Al2O3×ZrO2 showed the cell selection determined by the type of material, where ZrO2 surfaces were preferably covered. Improved biological response of nanocrystalline ZrO2 was demonstrated on ceramic ZrO2, Al2O3 and SiO2 substrates with nanocrystalline coating of ZrO2. In this work a novel technological process for the formation of defect-free coatings was developed. Sintered coatings were tested using in-vitro technique with cell line HeLa, L929 and MG63 for up to 72 hours. The results of the biological tests of nanocrystalline coatings were consistent with results from the bulk nanocrystalline thermally etched ZrO2 ceramics.

This thesis deals with the solution problem of fitting a window in the wall, especially for passive houses. It provides options to optimize the window connection joints, improve the thermal transmittance of the window frame, thereby reducing the total heat loss through the window. In the first part of the thesis is a research literature on the windows and heat technical and physical mechanisms. Are described equations and physical processes taking place in the windows and related building structures. This section describes the basic points in history, technical description of windows, etc. and present ways of assembly Installation the window and the influence of the thermal properties of the heat loss. The next part deals with the description of the work and the results obtained in the course of doctoral study. Describes the main objectives of the dissertation thesis, calculations and simulations of temperature fields and the results of the calculated values. Furthermore are described and analyzed measurement data and compared with the calculated values. At the end dissertation thesis are given opportunities to improve the current solution regarding the heat transfer coefficient of the frame, the optimal way of installation fillers windows in the perimeter wall and improve the thermal properties of the connecting joint.

Master‘s thesis focuses on concrete combined with polypropylen fibres produced commercially, fibres without surface modifications and fibres modificated by plasma. Most important topic of the thesis is experimental verification of influence of plasma modificated fibres on attributes of fresh concrete and physical-mechanical attributes of solidified concrete. Based on the results of the tests perfomed on examin units compares results and anylyses applicability of different fibre surface modifications.

Diploma thesis focuses on effect of the bypass factor on design and geometry of the evaporator for the cooling unit of data centre. Effect of the bypass factor on individual design parameters is solved in detail. All dependendecies are captured by using graphs in which s placed a cement on that parameter. In part C, mathematical and physical solutions are demonstrated calculations and processes leading to the design of the exchanger. In the end, evaluation of the calculations is done and there is also showed possible improvements for the practise.