This project is aimed at semiconductive gas sensors based on tin dioxide. In the first part, gas sensors are divided depending on their principal of functionality. Next part is about functionality of tin dioxide gas sensors and the possibilities of active layer modification. Experimental describes gas sensor from its drawing until construction, testing and characterization. Several microelectronic technologies such as thin-film, thick-film, LTCC, spray-coating or wire-bonding were used for constructing the sensor. In the last part properties of gas sensors and differences in functionality between modified and unmodified gas sensor are summarized.

The master's thesis is focused on the statistical evaluation of the most frequent level in the tank for 10 years, determining the abrasion terminant, setting retreat shoreline and bank stabilization proposals in the area of interest Svitavice on the water reservoir Letovice. The thesis consists of an accompanying report and a technical report. The accompanying report contains basic technical and administrative data, hydrology ratio and others conditions in the area of interest. In addition, the accompanying report contains a description of production and activities in wide surroundings of the tank. The technical report contains statistical evaluation of the most frequent water surface in the tank for 10 years, hydro technical calculation to determine the prognosis of the bank line recession, visualization proposal of biotechnical measures. In conclusion, an estimate cost of the proposed biotechnical measures is calculated.

The goal of this master's thesis is design and built of platform for three-rotor helicopter development. The helicopter is also known as tricopter. Theoretical part describes principle of tricopter's flight and stabilization. There is also described basics inertial navigation system and sensors which are required for correct functionality. Practical part is dedicated to development of tricopter's frame, schematics diagram, communication between subsystems and stabilization system development. Flight stablization system is base on ATmega128A an using PID Controller. In the end is described testing of developed platform.

Heavy metals released to the natural ecosystem constitute significant risks not only for organisms, but also for water supplies in the nature. There are a number of analytical methods for the determination of heavy metals. Each of them is suitable for different element and its character. Since the results of the analysis are applied during the solidification and stabilization, it is necessary to ensure the highest correlation between hazardous waste and solidification medium for maximum inhibition of toxic ions. This work investigates the stabilization of heavy metals binders based on cement base with admixture of the natural zeolite and its possible use for the solidification of heavy metals in soluble form.

5 Summary So far, no commercially used device, capable of evaluating the condition of the deep stabilizing spine system (DSSS), has appeared on the market. Therefore, a so called muscle dynamometer (SD01, SD02), has been constructed that enables to reveal a possible dysfunction of the DSSS. During a six-week-rehabilitation-course, aimed at correcting the body posture and strengthening the DSSS muscles, a statistically significant change (p<0.001) between the values of input and output measurements of the chosen group tested has been obtained. Correctness of the approach to objectify the initial state of the patient and his progress during the treatment was shown by the completed measurements. The effectiveness of therapeutical training was confirmed. Based on positive experience from SD01, a new version of muscle dynamometer, SD02, was constructed. Measurements by SD02 were to establish the condition of DSSS (frontal spine stabilization) by a lay-sit test repeatedly from the test battery UNIFITTEST 6-60 and by the diaphragm test. Measurements were conducted on 45 samples. Basic somatic measurements were performed and then measurements with the SD02 were conducted during the diaphragm test and UNIFITTEST. For comparison of the values the pairing t-test was used (normal data distribution was verified by the...

1 Abstract Title: Exploitation of regular exercise based on the elements of developmental kinesiology for people suffering with back pain. Objectives: The aim of my diploma thesis was observing the effect of a group motional program based on tenets of developmental kinesiology for function of the motional system of clients suffering from back pain. Methods: The theoretical part of my diploma thesis was done with a method of literary recherché using technical literature, articles and studies. Experiment was chosen for the practical part, quasi in particular, which was complemented by method of qualitative research, personal case study in particular. There are two clinical casuistries paced in my thesis. There were two following methods for collecting data during my research: kinesiology analysis focused on anamnesis, check-up by sight, check-up by touch and functional probing (dynamic check-up of spine, diagnostically testing of deep stabilizing muscles.) Another methods used in my diploma thesis were assessments of pain with a usage of visual analogy scale and semi-structured interview. Pre-tests and post-test were identical. 10 people suffering from chronic back pain in an area of cervical spine or lumbar spine (5 clients suffering from chronic back pain in an area of lumbar spine and 5 clients suffering...

Title: Corrected arm hang as a compensatory element in physioterapy Objective: The main objective of this master thesis is to measure and compare the level of engagement of muscles stabilizing the scapula during arm hang and supported exercise. Methods: Our study included nine probands whose measurement results were evaluated quantitatively. The age of probands at the time of measurement was from 18 to 25 years. A condition for inclusion in the investigated group was absence of subjective symptoms, functional impairment, traumatic injury, orthopedic defects or diseases of the upper limb. All probands were active athletes. Biomonitor ME 6000 manufacturer Mega Electronics Ltd. was used for recording the electrical activity of the muscles. The obtained data were processed by the Megawin software. All measurements for the purposes of the study took place in the laboratory of biomechanics FTVS UK. The resulting data were compared intraindividual and interindividual. Results: The results demonstrated that middle and lower portions of m. Trapezius is more active in the corrected arm hang. In contrast, the supported exercise leads to greater activity of m. Serratus anterior and lower activity of upper portion of m. Trapezius. Keywords: arm hang, supported exercise, surface electromyography, stabilization...

This thesis is dealing with the problematic position of the upper house of the czech Parliament. In this thesis author is operating as with primary literature (i.e. laws and historic constitutional documents) in analysis historical moments of the czech parliamentarism, so with direct observation of the members of the Senate (in 11th term). Author was focusing himself on direct observations of the senate committees and plenary session of the Senate. With great help of the Senate's staff and senator Jaromír Jermář, all the members of the Senate was addressed with author's request to participate in research. Results of this research are basic cornerstone in order to answer the questions in the introduction about the sense and the role of the upper house of the czech Parliament. First chapter represents an introduction, where are the most important sources, metodology, questions entitled and this problematic is basically explained. Second chapter is aiming on the theoretical concept of the bicameral parliaments. Third chapter is profoundly analysing the historical experience of the Czech state with the second chambre parliament. Fourth chapter is, finally, analysing the representational, constitutional and legislative-controlling functions of the Senate toward the executive. Fifth chapter is...

Author: Bc. Anežka Zasadilová Title: The effect of physiotherapy on patients with gastroesophageal reflux disease Objectives: The aim of this thesis is to design a therapeutic unit and evaluate its effect on long-term treatment in the therapy of selected patients with gastroesophageal reflux disease Methods: The group of patients treated for esophageal reflux disease was examined using a standardized questionnaire, esophageal manometry and postural tests. This was followed by a two-month therapy aimed at stretching and strengthening the diaphragm using several physiotherapeutic methods. After completing the therapy, the probands were measured again as in the same way as in the initial examination. The obtained data were evaluated by statistical analysis using a nonparametric test for one selection (Wilcoxon test). Results: The evaluation of the questionnaire survey resulted in the value of p-value = 0.007265, ie less than the selected level of alpha significance (= 0.05). Based on the Wilcoxon test, it was confirmed that the input score was statistically significantly higher than the output score. The evaluation of the esophageal manometry gave the value of p-value = 0.6956, ie greater than the selected level of significance alpha (= 0.05). Based on the Wilcoxon test, it was not confirmed that the...

Title: Strategy of postural stabilisation using unstable surface and water barrel. Objectives: The aim of this study is to investigate the level of muscle actiavtion of choosen muscles during lunge on unstable surface or with using water barrel. Investigation of the postural strategy used during lunge orn unstable surface or with the water barrel and creation of methodology for measurment and data analysis. Methods: Into this pilot study, there were picked 5 people (athletes). Data for outcomes where used from 3 athletes. The measurement of level of muscle activation were done by surface electromyography over gluteus medius muscle and musculi multifidii bilaterally.For data procession was used software Origin 2012 Postural stability was measured through force plates by Kistler and gained data were procesed by using software programmes Bioware, MS Excel and Matlab. For data analysis from EMG measurement was used simple comparasion of outcomes. Stabilometry outcomes were analysed by statistical methode t-test. Results: The results indicate greater level of muscle activation during lunge with aquabag than lunge on unstable surface for most of the measured muscles. The only exception, where level of muscle activity was higher, was multifidi muscle on rear leg. Another outcome proved that the postural...