Climate change is mankind’s biggest challenge and scientists around the globe agree that civilization is pushing towards a breaking point. Renewable energy are alternatives that are capable to remove the need for fossil fuel. Wind power will play a vital role and has the possibility to confront the challenges that face the globe. In order for wind power to reach its full potential constructors need to take into account the distance between each wind power turbine, as it can cause energy loss and generate less electricity into the system. These energy losses decrease the potential of wind power and thus also for renewable as a whole. Energy losses that emerge within the space between wind power plants are named wake losses. Once the wind has passed the plant, a distance equal to seven rotor diameters is needed for the wind to regain its full force. By positioning the plants within the announced distance, the production of each plant decreases since downstream turbines are not able to generate a full effect.       This Bachelor thesis in Energy Engineering aims to analyse these wake losses for the wind power plant Skäppentorp, which is situated in Mönsterås County. The nearby wind power plant Brotorp is affecting Skäppentorps production and the authors of this degree project chose to present the wake losses as a percentage. A third wind power plant named Idhult functioned as a reference. Idhult is of course not affected before the positioning of Brotorp but neither after it, therefore the plant was used to ensure that weak winds were not ascribed to Brotorp but are a result of a weak wind year. The Bachelor thesis covered thus three wind power plants, Skäppentorp which interacts and is affected by Brotorp and Idhult which served as reference. The wake losses were calculated in Microsoft Excel and set against the software windPRO to validate the programmed produced losses for the same plant. Skäppentorp’s surrounding were divided into 12 sectors, where each sector covers an angle of 30 degrees. By doing so a full circle, 360 degrees, surrounding the plant was established. The wind speed and the production before respectively after Brotorp deployment was produced by using a nearby measuring post. Via an average production value for each sector, before and after Brotorp, a percentage wake loss was calculated. This was set against Idhult to sort away better respectively worse wind years. The period before covered the year 2012 until 2015 and the period after covered 2016 until 2018.  The result from Microsoft Excel indicates that sector four and sector nine were subjected to the highest percentage of losses. The results from the software windPRO however indicated the highest loss in sector four. Three sectors obtained the same percentage loss as windPRO while remaining values came out dissimilar. The distinction between some of the sectors may be caused by the positioning of some of the Brotorp turbines, where some are located on the borderline between sectors. This implies that some turbines affect two sectors when calculated with Microsoft Excel, which it does not when simulated with windPRO. The sum of all sections indicated that Brotorp turbines caused a wake loss of 3,8 %. This was compared to the simulation in windPRO which resulted in 5,7 %.

This Master Thesis is the research done in the country of Rwanda. The project leads to study the climate of this country in order to establish whether this climate could be used to produce energy from air and to implement the first wind turbine for serving the nation.   After an introduction about the historical background of wind power, the thesis work deals with assessment of wind energy potential of Rwanda in focusing of the most suitable place for wind power plants. The best location with annual mean wind speed, the rate of use of turbine with hub height for an annual production per year, the mean wind speeds for 6 sites of Rwanda based on ECMWF for climatic data for one year at relief of altitude of 100m and coordinates are reported too.   The result of energy produced and calculations were done based on power hitting wind turbine generator in order to calculate Kinetic energy and power available at the best location to the measurement over the period of 12 months, that could be hoped for long term.   With help of logarithmic law, where wind speed usually increases with increasing in elevation and the desired wind speeds at all 6 sites were used. The annual energy production was taken into account at the best site with desired wind speed at the initial cost of turbine as well as the cost of energy (COE).However, with comparison of the tariff of EWSA, the price of Wind designed in this Research per kWh is cheaper and suitable for people of Rwanda. / <p><em>Rwanda has considerable opportunities development energy from hydro sources, methane gas, solar and peat deposits. Most of these energy sources have not been fully exploited, such as solar, wind and geothermal. As such wood is still being the major source of energy for 94 per cent of the population and imported petroleum products consume more than 40 per cent of foreign exchange. Energy is a key component of the Rwandan economy. It is thus recognized that the current inadequate and expensive energy supply constitutes a limiting factor to sustainable development. Rwanda’s Vision 2020 emphasizes the need for economic growth, private investment and economic transformation supported by a reliable and affordable energy supply as a key factor for the development process. To achieve this transformation, the country will need to increase energy production and diversify into alternative energy sources. Rwandan nations don’t have small-scale solar, wind, and geothermal devices in operation providing energy to urban and rural areas. These types of energy production are especially useful in remote locations because of the excessive cost of transporting electricity from large-scale power plants. The application of renewable energy technology has the potential to alleviate many of the problems that face the people of Rwanda every day, especially if done so in a sustainable manner that prioritizes human rights.</em></p>