De-inking sludge generated from pulp and paper industry is considered hazardous since it may contain heavy metals such as Cd, Cr, and Pb. Hence, the de-inking sludge needs to be treated before being disposed of. Sludge combustion is a proven disposal technology, which generates fly ash containing a portion of the heavy metals that may leach out under uncontrolled conditions. The aim of this thesis is to implement a new multi-zone temperature combustion technique (Low-High-Low temperature combustion, LHL) to help contain and immobilize the heavy metals within fly ash particles. During the LHL, the waste will be initially fed into a low-temperature zone (<1100 K) and then subjected to the high-temperature treatment (~1480 K) that will be followed by another low-temperature zone (~1100 K). / This dissertation describes the detailed design and construction of a novel pilot-scale combustion facility, called the Multi-Mode Combustion Facility (MCF), used as a multidisciplinary research tool for investigating the thermal remediation of contaminated solid residues. The MCF is capable of operating in two different modes: Fluidized-Bed combustion mode (FBC) and Single burner furnace mode (SBF). However, this project focuses on the FBC mode (minimum fluidization velocity of 0.42 m/s and bed temperature of 1073 K). / This research compares the combustion characteristics of de-inking sludge obtained in the LHL and in the conventional combustion techniques. The following properties of particulates were studied: morphological evolution of solid particles, structural porosity, metals interactions with fly ash particles, and leachability. / The LHL's final supermicron spherical fly ash went through a molten phase with submicron particles attached to the fly ash particles surfaces. Thus, reducing its porosity to 19%. However, the amorphous final fly ash obtained in the conventional technique reveals 32% porosity. It was found that the physical characteristics of the final LHL's fly ash are the main cause for the reduced heavy metals leachability rates of 0.18, 0.046, and 0.92% for Cd, Cr, and Pb, respectively. The conventional technique had 53.28, 16.79, and 5.20% of Cd, Cr, and Pb respectively, leaching out due to the high porosity percentages. In conclusion, the LHL technique allows for controlling the heavy metals emission from FBCs, while using a waste to energy approach and maintaining environmentally acceptable gas emission levels.

Thesis (Ph.D.)--Chemical Engineering, Georgia Institute of Technology, 2009. / Committee Chair: Hsieh, Jeffery; Committee Member: Breedveld, Victor; Committee Member: Empie, Jeff; Committee Member: Forney, Larry; Committee Member: Singh, Preet

No description available.

published_or_final_version / abstract / Environmental Management / Master / Master of Science in Environmental Management

No description available.

Bioethanol is likely to be a large contributor to the fuel sector of industry in the near future. Current research trends are geared towards utilizing food crops as substrate for bioethanol fermentation; however, this is the source of much controversy. Utilizing food crops for fuel purposes is anticipated to cause massive food shortages worldwide. Cellulose is the most abundant renewable resource on earth and is subject to a wide array of scientific study in order to utilize the glucose contained within it. Waste paper has a high degree of cellulose associated with it, which makes it an ideal target for cellulose biotechnology with the ultimate end goal of bioethanol production. This study focussed on producing the necessary enzymes to hydrolyse the cellulose found in waste paper and using the sugars produced to produce ethanol. The effects of various printing inks had on the production of sugars and the total envirorunental impact of the effluents produced during the production line were also examined. It was found that the fungus Trichoderma longibrachiatum DSM 769 grown in Mandel's medium with waste newspaper as the sole carbon source at 28 °C for 6 days produced extracellular cellulase enzymes with an activity of 0.203 ± 0.009 FPU.ml⁻¹, significantly higher activity as compared to other paper sources. This extracellular cellulase was used to hydrolyse waste newspaper and office paper, with office paper yielding the highest degree of sugar production with an end concentration of 5.80 ± 0.19 g/1 at 40 °C. Analysis by HPLC showed that although glucose was the major product at 4.35 ± 0.12 g/1, cellobiose was also produced in appreciable amounts (1.97 ± 0.71 g/1). The sugar solution was used as a substrate for Saccharomyces cerevisiae DSM 1333 and ethanol was produced at a level of 1.79 ± 0.26 g/1, the presence of which was confirmed by a 600 MHz NMR spectrum. It was found that cellobiose was not fermented by this strain of S. cerevisiae. Certain components of inks (the PAHs phenanthrene and naphthalene) were found to have a slight inhibitory effect (approximately 15% decrease) on the cellulase enzymes at very high concentrations (approximately 600 μg/1 in aqueous medium), while anthracene had no effect. Whole newsprint ink was shown not to sorb glucose. The environmental analysis of the effluents produced showed that in order for the effluents to be discharged into an aqueous ecosystem they would have to be diluted up to 200 times. They were also shown to have the potential to cause severe machinery damage if reused without proper treatment.

Every year, millions of tons of paper are diverted from landfills and recycled. Newspaper constitutes a large portion of total paper recycled, providing a cheap source of raw material for the paper industry and helping sustainable forestry. The recycling of newsprint paper involves the separation of ink from the newsprint, which is done either by flotation or washing. Conventional flotation processes for separating ink are not adequate for newsprint printed using flexography printing technique and with water-based ink. The removal of these flexographic water-based inks by washing is a better alternative. However, one drawback of washing is that it has lower yield. In addition, the subsequent wash filtrate is difficult and costly to decontaminate. The overall goal is to develop a combination of processes that can remove ink from a feedstock that contains up to 100% flexographic ink newsprint; in the context of process variables with known effects. In the present work the objectives are to (1) demonstrate that incorporating an electric field into a conventional deinking process improves deinking efficiency, (2) propose a mechanism of how incorporating an electric field helps to improve deinking efficiency, (3) demonstrate that an electric field can decontaminate water containing flexographic inks and identify the mechanism behind electric field clarification of water, and (4) demonstrate that by incorporating electric fields into both the flotation deinking stage and water decontamination, the target deinking efficiency can be achieved.

Participatory Action Research (PAR) was carried out to improve educational practices and environmental sustainability in an International School in Vietnam by undertaking two cycles of PAR to determine how the school community could use paper on a more sustainable basis. The methodology included sorting paper and encouraging the reuse of paper. Practices related to computer printing, report writing and newsletter production were also investigated. Changes in the school community, in terms of accepting responsibility and demonstrating changed attitudes and behaviours, were measured. The school community demonstrated greater awareness, increased responsibility and more action competence. Critical awareness of unsustainable practices increased. Individuals were able to effect change, but it is recommended that such actions should be institutionalised for such changes to be sustainable. Limitations and recommendations emphasise the need for continuing PAR to implement sustainability. / Educational Studies / M. Ed. (Environmental Education)

Participatory Action Research (PAR) was carried out to improve educational practices and environmental sustainability in an International School in Vietnam by undertaking two cycles of PAR to determine how the school community could use paper on a more sustainable basis. The methodology included sorting paper and encouraging the reuse of paper. Practices related to computer printing, report writing and newsletter production were also investigated. Changes in the school community, in terms of accepting responsibility and demonstrating changed attitudes and behaviours, were measured. The school community demonstrated greater awareness, increased responsibility and more action competence. Critical awareness of unsustainable practices increased. Individuals were able to effect change, but it is recommended that such actions should be institutionalised for such changes to be sustainable. Limitations and recommendations emphasise the need for continuing PAR to implement sustainability. / Educational Studies / M. Ed. (Environmental Education)