The Eppley Precision Spectral Pyranometer (PSP) is a shortwave radiometer that is widely used in global networks to monitor solar irradiances at the earth's surface. Within the instrument, a blackened surface is in intimate thermal contact with the hot junction of a thermopile. The cold junction of the thermopile communicates thermally with the large thermal capacitance of the instrument body, which acts as a heat sink. Radiation arrives at the blackened surface through one or two hemispherical dome-shaped filters that limit the instrument response to the solar spectrum. The voltage developed by the thermopile is then interpreted in terms of the incident irradiance. Measurements taken with the pyranometer are compared with results from theoretical models. Discrepancies between model results and measurements are used to isolate inaccuracies in the optical properties of the atmosphere used in the models. As the accuracy of the models increases, the reliability of the measurements must be examined in order to assure that the models keep up with reality. The sources of error in the pyranometer are examined in order to determine the accuracy of the instrument. Measurements obtained using the pyranometer are known to be influenced by environmental conditions such as ambient temperature, wind, and cloud cover [Bush, et al., 1998]. It is surmised that at least some of the observed environmental variability in these data is due to parasitic thermal exchanges within the instrument [Haeffelin et al., 1999]. Thermal radiation absorbed and emitted by the filters, as well as that reflected and re-reflected among the internal surfaces, influences the net radiation at the detector surface and produces an offset from the signal that would result from the incident shortwave radiation alone. Described is an ongoing effort to model these exchanges and to use experimental results to verify the model. The ultimate goal of the work described is to provide reliable protocols, based on an appropriate instrument model, for correcting measured shortwave irradiance for a variable thermal radiation environment. / Master of Science

The objective of this thesis is to study two Basins of the Gulf of Guinea (GoG), namely the Dahomey and the Liberian Basins. These Basins are located in the northern part of the GoG, where oil and gas exploration has significantly increased in the last 10 years or so. We proposed geological descriptions of these two Basins. The key characteristics of the two models are the presence of channels and pinch-outs for depths of between 1 km and 2 km (these values are rescaled for our numerical purposes to 600- m and 700-m depths) and normal faults below 3 km (for our numerical purposes we use 1 km instead of 3 km). We showed that these models are consistent with the plate tectonics of the region, and the types of rocks and ages of rocks in these areas. Furthermore, we numerically generated seismic data for these two models and depth-migrated them. We then interpreted the migrated images under the assumption that the geologies are unknown. The conclusions of our interpretations are that we can see clearly the fault systems in both models. However, our results suggest that seismic interpretations of the channels and pinch-outs associated with the geology of the Dahomey and Liberian Basins will generally be difficult to identify. In these particular cases, we missed a number of channels and pinch-outs in our interpretations. The limited resolution of seismic images is the key reason for this misinterpretation.

The work presented in this thesis encompasses the design, development, realization and testing of novel magnetoelectric thin film elements that do not rely on ferromagnets, but are based entirely on magnetoelectric antiferromagnets such as Cr2O3. Thin film spintronic elements, and in particular magnetoelectric transducers, are crucial building blocks of high efficiency data processing schemes that could complement conventional electronic data processing in the future. Recent developments in magnetoelectrics have revealed, that exchange biased systems are ill-suited to electric field induced switching of magnetization due to the strong coupling of their ferromagnetic layer to magnetic fields. Therefore, ferromagnet-free magnetoelectric elements are proposed here in an effort to mitigate the practical problems associated with existing exchange biased magnetoelectric elements. This goal is achieved by establishing an all-electric read-out method for the antiferromagnetic order parameter of thin films, which allows to omit the ferromagnet from conventional exchange biased magnetoelectric elements. The resulting ferromagnet-free magnetoelectric elements show greatly reduced writing thresholds, enabled operation at room temperature and do not require a pulsed magnetic field, all of which is in contrast to state-of-the-art exchange biased magnetoelectric systems. The novel all-electric read-out method of the magnetic field-invariant magnetization of antiferromagnets, so-called spinning-current anomalous Hall magnetometry, can be widely employed in other areas of thin film magnetism. Its high precision and its sensitivity to previously invisible phenomena make it a promising tool for various aspects of thin solid films. Based on this technique, a deep understanding could be generated as to what physical mechanisms drive the antiferromagnetic ordering in thin films of magnetoelectric antiferromagnets. As spinning-current anomalous Hall magnetometry is an integral probe of the magnetic properties in thin films, it offers no intrinsic scale sensitivity. In order to harness its great precision for scale related information, a statistical framework was developed, which links macroscopic measurements with microscopic properties such as the antiferromagnetic domain size.

The work presented in this thesis encompasses the design, development, realization and testing of novel magnetoelectric thin film elements that do not rely on ferromagnets, but are based entirely on magnetoelectric antiferromagnets such as Cr2O3. Thin film spintronic elements, and in particular magnetoelectric transducers, are crucial building blocks of high efficiency data processing schemes that could complement conventional electronic data processing in the future. Recent developments in magnetoelectrics have revealed, that exchange biased systems are ill-suited to electric field induced switching of magnetization due to the strong coupling of their ferromagnetic layer to magnetic fields. Therefore, ferromagnet-free magnetoelectric elements are proposed here in an effort to mitigate the practical problems associated with existing exchange biased magnetoelectric elements. This goal is achieved by establishing an all-electric read-out method for the antiferromagnetic order parameter of thin films, which allows to omit the ferromagnet from conventional exchange biased magnetoelectric elements. The resulting ferromagnet-free magnetoelectric elements show greatly reduced writing thresholds, enabled operation at room temperature and do not require a pulsed magnetic field, all of which is in contrast to state-of-the-art exchange biased magnetoelectric systems. The novel all-electric read-out method of the magnetic field-invariant magnetization of antiferromagnets, so-called spinning-current anomalous Hall magnetometry, can be widely employed in other areas of thin film magnetism. Its high precision and its sensitivity to previously invisible phenomena make it a promising tool for various aspects of thin solid films. Based on this technique, a deep understanding could be generated as to what physical mechanisms drive the antiferromagnetic ordering in thin films of magnetoelectric antiferromagnets. As spinning-current anomalous Hall magnetometry is an integral probe of the magnetic properties in thin films, it offers no intrinsic scale sensitivity. In order to harness its great precision for scale related information, a statistical framework was developed, which links macroscopic measurements with microscopic properties such as the antiferromagnetic domain size.:TABLE OF CONTENTS Abbreviations 9 1 Introduction 11 1.1 Motivation 11 1.2 Objectives 12 1.3 Organization of the thesis 13 2 Background 15 2.1 History of magnetoelectric coupling 15 2.2 Long range magnetic ordering 16 2.2.1 Magnetic order parameter and field susceptibility 17 2.2.2 Magnetic proximity effect 19 2.2.3 Exchange bias 20 2.3 Phenomenology of magnetoelectric coupling 21 2.3.1 The linear magnetoelectric effect 21 2.3.2 Magnetoelectric pressure on the antiferromagnetic order parameter 22 2.3.3 Switching the antiferromagnetic order parameter 23 2.4 Realized magnetoelectric thin film elements 24 2.4.1 BiFeO3/CoFe system 24 2.4.2 Cr2O3/Co/Pt system 25 3 Experimental methods 27 3.1 Development of ferromagnet free magnetoelectric elements 28 3.1.1 The substrate 29 3.1.2 The Cr2O3 bulk and top surface 31 3.1.3 The V2O3 or Pt bottom electrodes 33 3.1.4 Epitaxial relationships 34 3.1.5 The Cr2O3 bottom interface 39 3.1.6 Twinning of Cr2O3 39 3.1.7 Hall crosses and patterning processes 43 3.2 Magnetotransport measurements 44 3.2.1 Hall effects 45 3.2.2 Anomalous Hall effect 46 3.2.3 Magnetoelectric writing 47 3.2.4 All electric read out 49 3.3 The experimental setup 50 3.3.1 Temperature control 50 3.3.2 Magnetic field control 51 4 Spinning-current anomalous Hall magnetometry 53 4.1 Characteristics of the technique 53 4.1.1 Operational principle 53 4.1.2 Advantages 55 4.1.3 Magnetic hysteresis loops and field-invariant magnetization 55 4.1.4 Measurement of field-invariant magnetization 56 4.1.5 Limitations 58 4.2 Application of SCAHM to Cr2O3(0001) thin films 59 4.2.1 Criticality and distribution of the antiferromagnetic phase transition 61 4.2.2 Evaluation of the magnetic proximity effect 64 4.3 SCAHM with thin metallic antiferromagnetic IrMn films 65 4.3.1 [Pt/Co]4/IrMn exchange bias system 65 4.3.2 Isolated antiferromagnetic IrMn thin films 67 5 Magnetoelectric performance 69 5.1 Magnetoelectric field cooling 69 5.2 The gate bias voltage 71 5.3 Isothermal binary magnetoelectric writing in Cr2O3 72 6 Order parameter selection in magnetoelectric antiferromagnets 77 6.1 Uncompensated magnetic moment 77 6.2 Extrinsic causes for broken sublattice equivalence 81 6.3 The V2O3 gate electrode 83 7 Measurement of microscopic properties with an integral probe 87 7.1 Interentity magnetic exchange coupling 87 7.2 Ensemble formalism for the entity size determination 90 7.3 Estimation of the entity sizes 94 7.4 Microscopic confirmation of the ensemble model 97 8 Summary and Outlook 101 8.1 Goal-related achievements 101 8.1.1 All-electric read-out of the AF order parameter 101 8.1.2 Electric field induced writing of the AF order parameter 102 8.2 Further achievements 103 8.2.1 Foreseen impact of SCAHM on thin film magnetism 103 8.2.2 Practical optimization routes of magnetoelectric Cr2O3 systems 104 8.2.3 Theoretical work 105 8.3 Future directions 105 8.3.1 Development of Cr2O3-based magnetoelectric systems 105 8.3.2 Applications of SCAHM 106 References 107 Erklärung 113 Acknowledgements 115 Curriculum Vitae 117 Scientific publications, contributions, patents 119