ITC/USA 2014 Conference Proceedings / The Fiftieth Annual International Telemetering Conference and Technical Exhibition / October 20-23, 2014 / Town and Country Resort & Convention Center, San Diego, CA / Network loads close to Ethernet wire speed and latency sensitive data in a Flight Test Instrumentation (FTI) system, represent challenging requirements for FTI network equipment. Loss of data due to network congestion, overflow on the end nodes, as well as packet latency above a few hundred microseconds, can be critical during a flight test. To avoid these problems, several advanced packet filtering and network optimization functions are required in order to achieve best possible performance and thus avoid loss of data. This paper gives insight into how to properly engineer an Ethernet based FTI network and how to use advanced Ethernet switch techniques such as Quality of Service (QoS) and rate shaping.

published_or_final_version / abstract / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy

Voice over IP technology (VoIP) has recently gained popularity among consumers. Many popular VoIP services exist only as software for PCs. The need of taking such services out of the PC, into a stand-alone device has been discovered, and this thesis work deals with the development of such a device. The thesis work is done for Häger Scandinavia AB, a Swedish telephone manufacturer. This thesis work covers the design of a complete prototype of a table-top VoIP telephone running an embedded Linux Operating system. Design areas include product development, hardware design and software design.The result is a working prototype with hardware and corresponding Linux device drivers. The prototype can host a Linux application adapted to it. Conclusions are that the first hardware version has worked well and that using an open-source operating system is very useful. Further work consists of implementing a complete telephony software application in the system, evaluation of system requirements and adapting the prototype for a commercial design.

No description available.

No description available.

No description available.

Currently, a viable solution to provide multicast provision over a multiprotocol label switch with traffic engineering (MPLS-TE) domain is unavailable because of the missing link able to couple multicast traffic distribution with an MPLS-TE enabled network. This is due to the limited or less research investigation that was done in this area. Most of the investigation methods tackle the problem individually such as deploying internet protocol (IP) multicast in a plain network or MPLS domain but without considering a combination of both technologies that is aware of differentiated services requirements. This thesis presents an alternative solution for the multicast differentiated services provision problem over a MPLS-TE enabled network. The approach is exposed and analyzed through a practical solution that was developed within a network simulation environment. The research presented in this thesis orchestrates the already available technologies offered by the multicast protocols suite and differentiated services (DiffServ) aware MPLS-TE that allows applying separately the constraint-based routing and admission control to different classes of services. The novelty and solution of this thesis relies on using MPLS constraint-based routing concepts (e.g.traffic trunks) in order to solve TE issues revealed during multicast traffic distribution.

Border Gateway Protocol (BGP) is the backbone of routing infrastructure in the Internet. In its current form, it is an insecure protocol with potential for propagation of bogus routing information. There have been several high-profiles Internet outages linked to BGP in recent times. Several BGP security proposals have been presented in the literature; however, none has been adopted so far and, as a result, securing BGP remains an unsolved problem to this day. Among existing BGP security proposals, Secure BGP (S-BGP) is considered most comprehensive. However, it presents significant challenges in terms of number of signature verifications and deployment considerations. For it to provide comprehensive security guarantees, it requires that all Autonomous Systems (ASes) in the Internet to adopt the scheme and participate in signature additions and verifications in BGP messages. Among others, these challenges have prevented S-BGP from being deployed today. In this thesis, we present two novel lightweight security protocols, called Credible BGP (C-BGP) and Hybrid Cryptosystem BGP (HC-BGP), which rely on security mechanisms in S-BGP but are designed to address signature verification overhead and deployment challenges associated with S-BGP. We develop original and detailed analytical and simulation models to study performance of our proposals and demonstrate that the proposed schemes promise significant savings in terms of computational overhead and security performance in presence of malicious ASes in the network. We also study the impact of IP prefix hijacking on control plane as well as data plane. Specifically, we analyze the impact of bogus routing information on Inter-Domain Packet Filters and propose novel and simple extensions to existing BGP route selection algorithm to combat bogus routing information.

Using the approach of Coloured Petri nets (CPNs) and automata theory, this thesis shows how to formalise the service provided by the Transmission Control Protocol (TCP) and verify TCP Connection Management, an essential part of TCP. Most of the previous work on modelling and analysing TCP Connection Management is based on early versions of TCP, which are different from the current TCP specification. Also the scope is mainly confined to the connection establishment procedure, while the release procedure is either simplified or omitted from investigation. This thesis extends prior work by verifying a detailed model of TCP Connection Management. In defining the TCP service, the set of service primitives and their sequencing constraints are specified at each service access point. / Thesis (PhDComputerSystemsEng)--University of South Australia, 2004.

This thesis examines the current implementations for the distribution of real-time GNSS data over IP networks such as the public Internet, focusing on two essential components of the system, data format and transport protocol. The provision of a suitable data format will allow users to take full advantage of the real-time GNSS data distribution system. Types of GNSS supported, message sizes, data rates, data precision levels, hardware and software support and possible future developments are investigated. An analysis is carried out on commonly known GNSS data formats, highlighting the most suitable standard for each evaluation criterion. A similar investigation is carried out on the transport protocols. An analysis is conducted on various design aspects of NTRIP and RT-IGS protocols, covering factors such as data latency, integrity, firewalls and proxy server compatibility and scalability. The analysis also covers the design aspects of the new draft Version 2 of NTRIP. The latter parts of this thesis report on the experiment results aimed at providing assessment of the current level of implementation of NTRIP. Data latency and integrity using NTRIP over the Internet are examined. Their impacts on users applications as the quality of real-time kinematic positioning is assessed. The results show that the performance of the system satisfies the rigorous requirement of the end-user application. The draft version of the new NTRIP indicates that UDP will be also supported. A similar investigation is carried out, providing the first experiment results on the new option. Tests using similar metrics, data latency and integrity, were carried out to verify the inherent differences between TCP and UDP. It was ascertained that, in most cases, UDP does offer improvement in terms of reduced latency over TCP. However this improvement is not significant enough to affect the performance of users applications tested. Compatibility tests were also carried out and the test results show that the new option experiences some compatibility issues with firewalls and wireless networks.