The performance of existing and planned millimeter and submillimeter astronomical arrays is limited by fluctuations in the amount of atmosperic water vapor along the atenna's line of sight. Correcting the resulting phase distortion of the received signals is seen as a significant technological challenge. Measurements of the variation in the line-of-sight water vapor abundance at the level of 1 micron precipitable water vapor on a time scale of 1 second and at arbitrary antenna positions are required. This thesis describes the design of, and preliminary results obtained with, a water vapor monior operating at abundance at the level 1 micron precipitable water vapor on a time scale of 1 second and at arbitrary antenna positions are required. This thesis describes the design of, and preliminary results obtained with, a water vapor monitor operating at infrared wavelengths which shows considerable promise for this application. Improvements in, and future plans for, the second generation water vapor monitor currently under development are also discussed. / xiii, 167 leaves : ill. ; 28 cm.

This work presents a new wireless Visible Light Communication lighting system targeted to future Smart Buildings. A digitally controlled LLC resonant dc-dc converter targeted to white LED luminaires is demonstrated. Visible Light Communication is implemented with minimal incremental cost, by operating the LLC converter in burst mode, without causing any visible disturbance. The converter operates with a regulated average LED current by adjusting the switching frequency, while the burst pulse timing is controlled to minimize the current disturbance and minimize the value of the output capacitor. Variable Pulse Position Modulation is used to modulate the data, while supporting a range of dimming settings. A digital demodulation scheme that supports variable frequency transmission is demonstrated. The 80 W, 400 V to 23 V converter experimental prototype has a peak efficiency of 93.8 %. The bit error rate of the complete system is fully characterized versus distance and angle.

Despite the documented sensitivity of polar environments, long-term monitoring data are especially sparse in these regions. Diatom-based paleolimnology has contributed significantly to understanding the response of Arctic lakes to climate change, but most studies have been conducted in regions with relatively high lakewater buffering capacity. As such, Pim Island (Nunavut, Canada) is a region of limnological interest because, due to the local geology, its surface waters are of relatively lower pH and previous research suggests that such softwater lakes may be especially responsive to climate fluctuations and therefore provide the best paleoclimate records. This thesis has two separate but related chapters, as well as an exploratory study included in appendix. First, a novel approach using visible-near-infrared spectroscopy (VNIRS) was used to infer lakewater dissolved organic carbon (DOC), from a 160-lake calibration set from the Canadian Arctic. Historically sound and similar trends were reconstructed when compared against a Canadian diatom-based DOC and Swedish VNIRS-based total organic carbon (TOC) model on Arctic Holocene sediment records. Second, a diatom and spectroscopically-based multi-proxy approach was utilized on Holocene sedimentary records from two lakes on Pim Island to assess long-term environmental change from this region. Benthic and epiphytic diatom taxa dominated the pre-19th century assemblages, although marked shifts in dominant species were recorded during the mid-Holocene. The mid-Holocene diatom assemblages underwent an abrupt ecological shift from alkaliphilous Fragilaria sensu lato to slightly acidophilous Achnanthes and Navicula. The post-19th century was characterized by an increase in the planktonic species (Cyclotella radiosa), indicating marked lakeice reductions. Third, the limnological properties and modern diatom assemblages of ponds and lakes surveyed from 1979 to 2009 on Pim Island were examined as part of an exploratory study. The ponds and lakes displayed typical characteristics observed in high Arctic lacustrine environments (i.e. oligotrophic, very dilute) but with overall relatively low alkalinity. Poorly-buffered sites had diatom assemblages that were distinct from well-buffered lakes elsewhere in the High Arctic. Our findings contribute to an improved understanding of the interactions between local environments and limnological changes, and also provide insight on the biological responses of lakes to Holocene environmental change and allow us to compare responses to those in more alkaline sites. / Thesis (Master, Biology) -- Queen's University, 2010-12-22 19:53:45.03

Thèse numérisée par la Division de la gestion de documents et des archives de l'Université de Montréal

This work presents a new wireless Visible Light Communication lighting system targeted to future Smart Buildings. A digitally controlled LLC resonant dc-dc converter targeted to white LED luminaires is demonstrated. Visible Light Communication is implemented with minimal incremental cost, by operating the LLC converter in burst mode, without causing any visible disturbance. The converter operates with a regulated average LED current by adjusting the switching frequency, while the burst pulse timing is controlled to minimize the current disturbance and minimize the value of the output capacitor. Variable Pulse Position Modulation is used to modulate the data, while supporting a range of dimming settings. A digital demodulation scheme that supports variable frequency transmission is demonstrated. The 80 W, 400 V to 23 V converter experimental prototype has a peak efficiency of 93.8 %. The bit error rate of the complete system is fully characterized versus distance and angle.

The use of sunlight has always been a major goal in the design and operation of commercial buildings to minimize electrical consumption of artificial lighting systems. Glazing systems designed to allow optimal visible light transmission also allow significant unwanted direct solar heat gain caused by infrared light. Conversely, glazing systems that are designed to reflect unwanted direct solar heat gain significantly reduce the transmittance of visible light through windows. The goal of this research was to characterize the performance of water as gap-fill for double-glazing units in eliminating the compromises that exist in current glazing systems with respect to light and heat transmittance. An in situ test approach and computer simulations were conducted to measure the performance of water-filled glazing units against air-filled glazing units. The thermal transmittance and solar heat gain coefficient values obtained from both the field experiments and computer simulations, glazing units with air-fill proved better than the glazing units with non-flowing water-fill. However, the high convective coefficient and the high thermal mass of the water can be used to its advantage when it is allowed to flow at peak temperatures, thus, maintaining lower temperature swings indoor. This can lead to a reduction of about 50-70% direct solar heat and still maintain high visibility.

In this thesis settlement areas and settlements from the Bronze Age on Gotland are in focus. The island of Gotland in the middle of the Baltic Sea is famous for its rich archaeological remains of monuments and relics from all pre-historic periods, and the Bronze Age (1700-500 BC) especially is well repre- sented. There are nearly a thousand cairns, over 300 stone-ship settings and a large amount of bronze finds, but there are few traits of contemporary settlements. With few exceptions the settlements from all pre-historic periods are in one way “invisible” but during the last decades the context has changed, as has knowledge of the settlements from the Bronze Age. Research published throughout the first ten years of the 21th century offers new and refreshing interpretations concerning settlements and houses from the period in question on both a regional level and in more comprehensive studies across Scandinavia. This is due to continued advances in archaeological methods to see the invisible remains however many of the sites are discovered in exploitation-excavations. In a smaller scale this is also true for Gotland and during the last decade there are scattered finds of houses from the period in the shape of post-holes, hearths and cooking pits. The situation on the island is not to expect larger ex- ploitations followed by excavations so we have to test other ways to look for the settlement areas and settlements. In this study I therefor examine if there are any relations to the visible, in first hand cont- emporary types of monuments such as burnt mounds, cairns, stone ship settings and finds of bronzes, to sites seen as possible settlement areas from the Bronze Age. In this context I also have to consider the remains from the early Iron Age, foremost the visible remains of fossilised fields and ancient forts. The theoretical framework is a hermeneutic approach in the study of the relations of each cont- emporary types of monuments contextualized with possible settlements. As Gotland is an island I have to relate to the meaning of landscape and islands. To get closer to the society and the social orga- nisation, my aim is also to come closer to the people who lived their daily lives on Gotland during the Bronze Age and to consider the question of the chiefdoms and the social organisation.

Dans le but de déterminer le phénomène physique ou chimique caché derrière l'efficacité des agents fluorescents à inhiber le photojaunissement de la lignine, plusieurs études ont été menées. Tout d'abord, une étude d'efficacité de nouvelles molécules d'agents fluorescents a été faite avec la technique des feuilles minces, faites de pâtes à haute teneur en lignine. Lors de cette étude, une molécule s'est démarquée du lot de par son efficacité à court et à long terme. Il s'agit d'UQTR-010. Par la suite, une étude de stabilité des agents fluorescents face aux conditions expérimentales en laboratoire a été menée. Cette étude a été réalisée en exposant des solutions aqueuses, ou des feuilles minces vaporisées d'agent fluorescent, à divers rayonnements, soit à une lumière rouge, aux fluorescents du laboratoire et à la lumière du jour pénétrant par les fenêtres du laboratoire. Une étude de cinétique de dégradation a aussi été faite. Ainsi, nous avons pu nous assurer que les lumières du laboratoire ne dégradaient pas nos agents fluorescents, autant sur matrice solide que liquide, ainsi que des précautions devaient être prises si les échantillons étaient manipulés dans un laboratoire ayant des fenêtres laissant entrer la lumière du soleil. Ensuite, nous avons mis en relation l'efficacité de certains agents fluorescents avec leurs propriétés physico-chimiques dans le but de trouver une corrélation qui nous guiderait dans nos études futures. Ainsi, nous avons utilisé comme propriétés le pourcentage d'isomères trans des agents fluorescents en solution aqueuse, la durée de vie de fluorescence et le temps de demi-vie des molécules fluorescentes. La conclusion de cette étude est qu'aucune corrélation n'est observée entre l'efficacité des agents et l'une ou l'autre de ces propriétés. Nous avons aussi corrélé l'efficacité des agents fluorescents avec la force de l'oscillateur de la première transition s'effectuant dans la molécule, soit la transition HOMO-LUMO, et la force de l'oscillateur de la seconde transition, soit la transition HOMO-LUMO+X. Aucune corrélation n'est observée du côté de la force de l'oscillateur de la première transition. Cependant, en se penchant du côté de la seconde transition, nous trouvons un coefficient de corrélation satisfaisant entre l'efficacité des agents fluorescents et la force de l'oscillateur de cette seconde transition. ______________________________________________________________________________ MOTS-CLÉS DE L’AUTEUR : Lignine, agents fluorescents, spectroscopie UV-Visible, spectroscopie de réflectance, modélisation moléculaire, transitions électroniques, feuilles minces

Visible light-driven photocatalysis has shown considerable potential in the area of clean and renewable energy, as well as in wastewater treatment. This thesis describes the synthesis, characterization and applicability of a visible-light active photocatalyst, bismuth oxybromide (BiOBr). The photocatalytic activity of BiOBr was investigated through its preparation via hydrothermal and solvothermal synthesis routes under various conditions. Hydrothermal catalyst was prepared using non template based method while for solvothermal synthesis CTAB was used as a template. Parameters of temperature and time of thermal treatment were optimized for each synthesis method and overall tests for catalyst dosage and recyclability were performed. An overall optimal route leading to high photocatalytic performance was also proposed based on the obtained results. Studies were also conducted to examine the applicability of optimally synthesized BiOBr in drinking water applications by studying catalyst-mediated disinfection of E. coli and degradation of phenol. Favourable results were obtained, confirming the prospective application of BiOBr as a viable photocatalyst for disinfection. Furthermore, the potential of enhancing BiOBr to further improve its performance is described through synthesis of a novel PdCl2/BiOBr based photocatalyst. Overall, the performance of BiOBr under various conditions in this study establishes its potential as a holistic photocatalyst and merits further development.

Photocatalysis is an advanced oxidation process for the purification and remediation of contaminated waters and wastewaters, and is advantageous over conventional treatment technologies due to its ability to degrade emerging and recalcitrant pollutants. In addition, photocatalytic disinfection is less chemical-intensive than other methods such as chlorination, and can inactivate even highly resistant microorganisms with good efficacy. Process sustainability and cost-effectiveness may be improved by utilizing solar irradiation as the source of necessary photons for photocatalyst excitation. However, solar-induced activity of the traditionally-used titania is poor due to its inefficient visible light absorption, and recombination of photo-excited species is problematic. Additionally, mass transfer limitations and difficulties separating the catalyst from the post-treatment slurry hinder conversions and efficiencies obtainable in practice. In this research, various strategies were explored to address these issues using novel visible light active photocatalysts. Two classes of carbon-enhanced photocatalytic materials were studied: activated carbon adsorbent photocatalyst composites, and carbon-doped TiO2. Adsorbent photocatalyst composites based on activated carbon and plasmonic silver/silver chloride structures were synthesized, characterized, and experimentally investigated for their photocatalytic activity towards the degradation of model organic pollutants (methyl orange dye, phenol) and the inactivation of a model microorganism (Escherichia coli K-12) under visible light. The adsorptive behaviour of the composites towards methyl orange dye was also studied and described according to appropriate models. Photocatalytic bacterial inactivation induced by the prepared composites was investigated, and the inactivation mechanisms and roles of incorporated antimicrobial silver on disinfection were probed and discussed. These composites were extended towards magnetic removal strategies for post-use separation through the incorporation of magnetic nanoparticles to prepare Ag/AgCl-magnetic activated carbon composites, and the effect of nanoparticles addition on the properties and photoactivities of the resulting materials was explored. Another silver/silver halide adsorbent photocatalyst composite based on activated carbon and Ag/AgBr exhibiting visible light absorption due to both localized surface plasmon resonance and optical band gap absorption was synthesized and its photocatalytic activity towards organics degradation and microbial inactivation was studied. Carbon-doped mixed-phase titania was also prepared and experimentally investigated.