MESMEG / Department of Mining and Environmental Geology / Literature indicated that several mineralogical identification studies have been carried out on clays but few have focused on the characterisation of geophagic materials from South Africa. Large quantities of earth materials are consumed daily in Mashau Village, however, their mineral content and geochemical compositions had not been determined. Moreover, though the consumption of geophagic materials is very common in the village, the associated health implications had not been addressed. Thus, the main aim of the research was to mineralogically and geochemically characterise geophagic materials commonly ingested in Mashau Village and infer on possible health implications that could result from their consumption. Questionnaires were administered to geophagists in the study area with the aim of generating data on the prevalence of geophagia and the motivations for the practice. Geophagic soils and their parent rocks (for determination of provenance) were sampled and analysed for mineralogical and geochemical content. Geophagic soil samples were subjected to the following physicochemical analyses: colour, particle size distribution, pH, cation exchange capacity (CEC) and electrical conductivity (EC). An x-ray diffractometer (XRD) was used for mineralogical analysis while major oxides and trace elements abundances were determined using x-ray fluorescence (XRF) spectrometry and laser ablation inductively coupled mass spectrometry (LA-ICP-MS), respectively. Furthermore, provenance of the geophagic materials was determined using data obtained from mineralogical and geochemical analysis. Inferred health implications were based on the physico-chemical, mineralogical and geochemical data obtained. Outcomes of the questionnaire survey revealed craving to be the motivation for geophagia in Mashau Village. Although the practice seemed to be prevalent in females of certain ages, it was certainly not limited to gender, age, educational level or socio-economic status. Out of the 20 geophagic samples, 3 samples were brown, 2 had a strong brown colour and another 2 had a light olive brown colour. Other soil colours were less common, as each colour was only observed in one sample. The sand fraction dominated the samples; the clay content was low, giving the samples a sandy clay loamy texture. The pH of the soil ranged from being slightly acidic (5.4) to being slightly alkaline. The CEC values were very high ranging from 17 t0 109 meq/100 g. vii The EC values were also high (ranging from 11.2 to 245 μS/cm) indicating a high amount of soluble salts. Mineralogical analysis of geophagic soils identified quartz, microcline, plagioclase, hornblende, dolomite, muscovite, kaolinite, smectite, talc, anatase, hematite, ilmenite, chlorite and epidote with quartz and kaolinite being the dominant minerals. Actinolite, augite, chlorite, epidote, forsterite, magnetite, muscovite, plagioclase, quartz, sepiolite and microcline were the minerals identified in rock samples. Geochemical analysis for major oxides content (SiO2, TiO2, Al2O3, Fe2O3, MnO, MgO, CaO, Na2O, K2O, P2O5 and Cr2O3) indicated that both geophagic soils and parent rocks were mainly composed of silica and alumina. Trace elements geochemistry showed a depletion of LREEs and an enrichment of HREEs in geophagic soils. The results also revealed that the REEs were enriched in the bulk fraction than in the clay fraction. Relative to the Upper Continental Crust (UCC) compositions, the concentrations of trace elements in geophagic soils were generally low. Provenance determination results showed that geophagic soils in Mashau were derived from basalts and sandstones. Majority of the samples were formed as a result of intense weathering while some were as a result of intermediate weathering. The negative health implications of the studied materials could include perforation of the colon, damage of the dental enamel and anaemia. However, geophagic materials could also be a good source of mineral nutrients and beneficial for reduction of nausea during pregnancy. / NRF

MESMEG / Department of Mining and Environmental Geology / Vhembe District has several clay deposits which are traditionally use for clay products such as burnt bricks without taking into account the chemical and mineralogical characteristics of clay being used. The ever-increasing market demand for these clay products cannot be met with the traditional method of clay utilization due to the paucity of scientific information on properties of the clay in the area. Consequently, there is a need to gain better understanding of the characteristics of the clay in Vhembe District and to establish the suitability of the variety of clay for different purposes. The current study was undertaken to better understand the compositional relationship between the clay deposits and surrounding rocks present in the study area. It further aimed at characterizing the clay deposits on the basis of chemical, mineralogy, physical, mechanical, thermal and micro structural properties with a view of evaluating the clays for possible industrial use. A total of thirty-nine clay and rock samples were collected from thirteen different locations across the Vhembe District. Thirteen representative samples from each location were obtained after thorough mixing until homogenization was attained and then quartered for subsequent analyses. The mineralogical and chemical characteristics of the clay and rock samples were determined using XRD and XRF respectively. Thin-sections of the rock samples were prepared and examined under petrographic microscope to better understand the mineral assemblages present in the rocks. The thermal and micro structural properties of the clays were determined using DTA-TGA and SEM analyses and the physical properties which include colour, cation exchange capacity (CEC) and soil pH were assessed. The particle distribution and Atterberg limits tests of the clay samples were also conducted in order to establish their mechanical properties. The petrographic results showed that the clay deposits exhibited an intense weathering and sedimentation processes which incorporated detrital minerals from the surrounding rock units. The rock units which include basalt, granodiorite, gneiss and quartzofeldspathic gneiss were found to be differentiated from subalkaline and/or tholeiitic magmatic composition. Although the value of SiO2 content in rock samples was higher when compared with clay samples, it indicated an ongoing desilicication and allitization processes. The high values of chemical index of alteration (CIA), low values of K/Cs (<6200), Ce* normalized value and higher values of LILE enrichment in the clay deposits indicated oxidizing environments during period of deposition. v The mineralogical composition of the studied clayey deposits showed that smectite (8.25 - 29.32%), kaolinite (14.91 - 59.26%) and chlorite (5.94 -16.54%) were present as clay minerals although associated with other non-clay minerals such quartz, plagioclase, talc and geothite. The chemical composition results revealed high silica and alumina content in most studied clay samples. Their fluxing oxides which include K2O, Na2O, CaO, and MgO, varied slightly from 0.06% to 1.78% in abundance while the Fe2O3 and TiO2 contents in most samples averages at 9.2% and 1.3% respectively. The plasticity index of the studied deposits ranged from 9.50 to 62.00% while liquid limit ranged from 31.34 to 73.62%. The microanalysis using SEM indicated that the microstructure framework of most studied clay exhibited a porous skeleton structure owing to numerous tiny voids. The composite results of SEM and CEC analyses suggested their possible application in water filter and chemical fertilizer industries since they provided passage for water and soil cations transmission. The particle size distribution demonstrated that the studied soils have clayey silt texture with wide range coverage of the well graded and sorted particle sizes. Compressibility and plasticity properties were found to be high in Mukondeni, Mashamba-1, Mashamba-2 and Mashamba-3 clay samples. The thermal behavior of Mukondeni, Mashamba-1, Mashamba-2 and Mashamba-3 samples showed relatively high shrinkage (>9%). The high shrinkage percentage suggests the preponderance of smectite minerals. Other samples which are rich in kaolinite and chlorite minerals exhibited low shrinkage (<2%). The drying trends of the studied clay suggest their suitability for fast drying processes like soft and hard refractoriness, sanitary wares and ceramics. Empirical assessment of most studied clay showed their suitability for pottery-making and manufacturing of roofing tiles and masonry bricks. / NRF

No description available.

No description available.

Isolated granitic rock bodies (granites, granodiorites, quartz monzonites) in the vicinity of Benson in southeastern Arizona were studied to trace the behavior of rock weathering. Thin sections of fresh granites were examined to characterize the original mineralogy which consisted mainly of quartz, feldspars, and micas. The weathering products show up on the granites as grus and soil profiles as well as down slope in the basin deposits. X -ray diffraction studies of the < 2 micrometers fraction of the weathering products proved illite, smectite, illite-smectite mixed layer, and kaolinite to be the dominant clays; quartz and feldspar also persisted into this size fraction. Silt sized material produced similar results. The quartz monzonite of Texas Canyon afforded a special study of the initial weathering stages of feldspars and micas. In the < 2 micrometers fraction obtained from granitic material placed in an ultra sonic bath, the feldspars weathered to a Na-montmorillinite while biotite weathered to vermiculite.

Les gisements uranifères nigériens sont localisés dans les formations carbonifères et jurassiques du bassin de Tim Mersoï. AREVA est actionnaire de 3 sites miniers de cette région: la SOMAÏR et la COMINAK dans le district d'Arlit, en exploitation depuis 50ans, et IMOURAREN, 80km plus au Sud, dont l'exploitation est programmée pour 2015. La minéralisation du gisement d'Imouraren est comprise dans la formation fluviatile du Tchirézrine 2 (Jurassique), formée de chenaux et de plaines d'inondation. Les faciès de remplissage de chenaux vont des grès grossiers aux grès très fins (cortège détritique : quartz et feldspaths), tandis que les faciès de débordement sont constitués d'analcimolites. La minéralogie secondaire est acquise lors de 2 évènements : 1- la diagenèse, avec formation de minéraux argileux, d'analcime, de quartz et d'albite secondaires, et 2- un épisode de circulations de fluides, qui induit une altération des minéraux détritiques et diagénétiques, la formation de nouvelles phases et le dépôt de l'uranium. Cette altération dessine une zonation minéralogique à l'échelle du gisement.L'hétérogénéité du Tchirézrine 2, tant au niveau des faciès que de la minéralogie, se perçoit lors du traitement du minerai, puisqu'il réagit différemment selon sa provenance, avec parfois des problèmes de récupération de l'U. Des essais de traitement de minerais, ont montré que analcimes et chlorites étaient les deux pénalisants, pour 3 raisons : 1- les piégeages des phases U au sein des analcimes, 2- la dissolution de ces 2 minéraux a tendance à faire sortir des conditions de solubilisation de l'U (pH et Eh) et à former de nombreux sulfates, 3- problèmes de percolation. Une méthode de détection des minerais riches en analcimes, basée sur la spectroscopie infrarouge, a été développée afin d'optimiser les mélanges de minerais et ainsi de réduire les effets néfastes des pénalisants lors du traitement. / Nigerian uraniferous deposits are located in carboniferous and jurassic formations of Tim Mersoï basin. AREVA is shareholder of 3 mine sites in this area: SOMAÏR and COMINAK, both in exploitation since 1960’s and IMOURAREN, 80km further South, whose exploitation is planned for 2015. Mineralization of Imouraren deposit is included in the fluvial formation of Tchirezrine 2 (Jurassic), composed of channels and flood plains. Facies of channel infillings range from coarse sandstones to siltstones, while overflow facies are composed of analcimolites.Secondary mineralogy was acquired during 2 stages: 1- diagenesis, with formation of clay minerals, analcime, secondary quartz and albites, and 2- stage of fluids circulations, which induced alteration of detrital and diagenetic minerals, formation of new phases and uranium deposition. A mineralogical zoning, at the scale of deposit resulted from this alteration. The heterogeneity of Tchirezrine 2, at the level of both facies and mineralogy, is also evidenced during ore treatment, as ore reacts differently depending on its source, with sometimes problems of U recovery. Ore treatment tests showed that analcimes and chlorites were both penalizing minerals, because of 1- the sequestration of U-bearing minerals into analcimes, 2- their dissolution which trends to move away from U solubilization conditions (pH and Eh) and to form numerous sulfates, and 3- problems of percolation. A detection method of analcime-rich ores, based on infrared spectroscopy, was developed in order to optimize ore blending and so to reduce negative effects during ore treatment process.

We investigated the effects of substrate (cellulose or starch) and different clay contents on the production of microbial extracellular polymeric substances (EPS) and concomitant development of stable soil aggregates. Soils were incubated with different amounts of montmorillonite (+ 0.1%, + 1%, + 10%) both with and without two substrates of contrasting quality (starch and cellulose). Microbial respiration (CO2), biomass carbon (C), EPS-protein, and EPS-polysaccharide were determined over the experimental period. The diversity and compositional shifts of microbial communities (bacteria/archaea) were analysed by sequencing 16S rRNA gene fragments amplified from soil DNA. Soil aggregate size distribution was determined and geometric mean diameter calculated for aggregate formation. Aggregate stabilities were compared among 1–2-mm size fraction. Starch amendment supported a faster increase than cellulose in both respiration and microbial biomass. Microbial community structure and composition differed depending on the C substrate added. However, clay addition had a more pronounced effect on alpha diversity compared to the addition of starch or cellulose. Substrate addition resulted in an increased EPS concentration only if combined with clay addition. At high clay addition, starch resulted in higher EPS concentrations than cellulose. Where additional substrate was not provided, EPS-protein was only weakly correlated with aggregate formation and stability. The relationship became stronger with addition of substrate. Labile organic C thus clearly plays a role in aggregate formation, but increasing clay content was found to enhance aggregate stability and additionally resulted in the development of distinct microbial communities and increased EPS production.

A quartz diorite intrusion of probable early Tertiary age that crops out over at least 6 square miles in the Palo Verde Ranch area in Pinal County, Arizona was mapped as a distinct intrusion. The quartz diorite intrudes an area comprising Pinal Schist, Oracle granite, andesitic flows, granoaplite, and dike rocks including both pegmatite and diabase. Two major physical features, the Owl Head Buttes and Chief Buttes volcanic areas, both remnants of an extensive early Tertiary series of flows of intermediate composition that covered the area, now remain as lava-capped buttes above the pediment. Weak but persistent fracture-controlled copper mineralization is found in the quartz diorite and the Pinal Schist at or near their mutual contacts in the form of chrysocolla, malachite, black copper oxides, chalcocite, chalcopyrite, and bornite, in decreasing order. Pyrite is rare. Alteration related to northeast and northwest-trending fractures increases in intensity from the common propylitic to argillic to the northeast toward the San Juan claims area. A barely discernible increase in copper sulfides mirrors the alteration zoning, although geochemical sampling showed background copper in the quartz diorite to be more uniform away from fractures.