I detta examensarbete har energiberäkningar och analyser enligt FEBY12 gjorts på ett radhusområde för att undersöka vad som krävs för att lågenergihusen ska uppnå passivhusstandard. Att uppföra energisnåla byggnader är i dagens samhälle viktigt för alla företag eftersom människor blir allt mer energimedveten och krav från beställare blir allt högre. I arbetet har en modell av radhusområdet modellerats i Revit Architecture för att på ett smidigt sätt få korrekta värden i de olika energiberäkningsprogrammen Vasari, Energihuskalkyl och PHPP. Programmen har helt olika kvalitéer därför har en jämförelse och analys av programmen utförts. Analyser har tydligt visat att det krav som finns för att uppnå passivhusstandard på värmeförlusttalet är betydligt svårare att uppnå än det krav som ställs på den levererade energin. För att uppnå passivhusstandard vidtogs diverse åtgärder såsom U-värde för väggar förbättrades, ventilationsaggregatets verkningsgrad höjdes samt fönsterpartierna reducerades avsevärt. / Energy calculations and analysis have in this thesis paper been made in accordance with the FEBY12 on a row house area to examine what is needed for low energy houses to achieve passive house standards. The ability to construct energy efficient buildings in today’s society is very important for all companies in the business since the people are becoming more and more environmentally conscious and demands from buyers are increasing.  To be able to efficiently obtain accurate values from the different energy calculation programs such as Vasari, Energihuskalkyl and PHPP for this examination, a model was created using Revit Architecture. The programs’ quality strongly differs from each other and therefore analysis and comparisons have been made to reach a result. Analysis clearly shows that the demands to reach passive house standard on rates of heat loss are significantly harder to meet than the demands put on the supplied energy.  To achieve passive house standard several different measures were taken, for example the U-value in the walls were improved, ventilation was made more efficient and the window panels were reduced significantly.

The thesis deals with the issue of architecture of a contemporary single-family house in The Beskydy region. In the introduction of the thesis The Beskydy region as well as the document of the Protected landscape area of Beskydy (Chráněná krajinná oblast - CHKO Beskydy) are described. In recent years the above mentioned topic has been discussed a lot among the architects and designers of the region. Current architecture in the CHKO Beskydy has been stagnating for years due to the fact that in this region quality architecture of a little higher level will always necessarily be in conflict with the devastating policy of the CHKO Beskydy. The objective of the thesis is to specify rules that need to be observed when creating a contemporary single-family house in the Beskydy region. The design as well as the realization of a single-family house in Prostřední Bečva serves to experimentally verify the thesis. This thesis, including the analysis of the obtained data, collecting information, technical examination and authorized expert opinions, has performed as an important part of the engineering process leading to the approval of architectural projects from the institutions of the state administration.

<p>A large proportion of the energy consumption is in the building industry and a large part goes to heating our homes and premises. In the developing countries' development now threatens the large consumption of energy in our earth's climate. It is in the West world that we must be good role models in terms of energy efficiency. One solution to reduce energy consumption for heating of buildings may be to continue to build low energy houses and passive houses, but it is also about rebuilding the buildings that currently have high energy consumption such as the old Million program Houses. These buildings will be standing many years and their energy consumption will not diminish over time by itself and energy prices will certainly not diminish in the future. This report will touch on the subject mainly new construction, how to build an energy efficient building, but a smaller portion will touch on the subject rebuilding, particularly the solutions that can fit into economic terms.</p><p><strong> </strong></p><p>Calculations have been done to link the concepts of U_mean of a building and its energy consumption. This was done by calculations using an Excel document created in connection with this thesis.</p><p> </p><p>The buildings and architectural solutions addressed in this report will focus on apartment buildings where the partner of this thesis is Eskilstuna Municipal Building. Eskilstuna Municipality Property manages buildings and premises to Eskilstuna Municipality, but also owns their own house with rental apartments.<strong></strong></p>

A large proportion of the energy consumption is in the building industry and a large part goes to heating our homes and premises. In the developing countries' development now threatens the large consumption of energy in our earth's climate. It is in the West world that we must be good role models in terms of energy efficiency. One solution to reduce energy consumption for heating of buildings may be to continue to build low energy houses and passive houses, but it is also about rebuilding the buildings that currently have high energy consumption such as the old Million program Houses. These buildings will be standing many years and their energy consumption will not diminish over time by itself and energy prices will certainly not diminish in the future. This report will touch on the subject mainly new construction, how to build an energy efficient building, but a smaller portion will touch on the subject rebuilding, particularly the solutions that can fit into economic terms.   Calculations have been done to link the concepts of Umean of a building and its energy consumption. This was done by calculations using an Excel document created in connection with this thesis.   The buildings and architectural solutions addressed in this report will focus on apartment buildings where the partner of this thesis is Eskilstuna Municipal Building. Eskilstuna Municipality Property manages buildings and premises to Eskilstuna Municipality, but also owns their own house with rental apartments.

Intresset kring lågenergibyggnader blir allt större och så kallade passivhus, med god isolering, hög lufttäthet och värmeåtervinning, byggs i allt större utsträckning i Sverige och andra europeiska länder. Vissa frågetecken har dock uppkommit kring inomhusklimatet i husen och risken för både under- och övertemperaturer. En annan viktig aspekt är hur husens egenskaper påverkar värmelasterna och hur detta i sin tur påverkar energiförsörjningssystemet. I detta examensarbete undersöks dessa båda aspekter – värmelastegenskaper och innetemperaturer – i fyra likadana nybyggda flerbostadshus i Falkenberg. Mätvärden från husens tekniska system, inklusive lufttemperaturmätningar i samtliga lägenheter, analyseras. Husen består av totalt 108 lägenheter, värms med fjärrvärme och använder ca 50 kWh/m2 Atemp årligen. Värmelastegenskaperna kännetecknas framförallt av låga effektbehov för både uppvärmning och varmvatten samt relativt stora svängningar över dygnet. Husen tycks vara känsligare för variationer i interntillskott än konventionella hus, vilket leder till regelbundna svängningar i effektbehovet för uppvärmning, med en topp under natten och morgonen. Detta leder till förstärkta svängningar i fjärrvärmenätet, vilket skulle kunna undvikas med hjälp av effektstyrning. Passivhusens stora termiska tröghet talar för en sådan möjlighet. Även innetemperaturen uppvisar regelbundna dygnsvariationer, som kan vara något större än i vanliga hus. Låga temperaturer förekommer tidvis under vintern, men resultaten pekar inte på några brister i de tekniska systemen. Temperaturen på sommaren är inte högre än i andra hus, och övertemperaturer tycks inte vara något stort problem i dessa hus. Det kan dock finnas en möjlighet att minska risken för övertemperaturer ytterligare genom användning av nattkyla under varma perioder. Denna möjlighet kan vara ett sätt att utnyttja passivhusens speciella egenskaper för att ytterligare förbättra konceptet. / There is today an increasing interest in low-energy buildings, and the so-called “passive houses” are becoming increasingly popular in Sweden and other European countries. There are however some concerns regarding the indoor climate in these houses, notably the risk of too low indoor temperatures in the winter and too high temperatures in the summer. Another issue is the heat load characteristics of this type of buildings, and how these affect the energy systems. In this thesis, these two aspects – heat load characteristics and indoor temperatures – are analysed in four identical multi-family buildings in Falkenberg, Sweden, using measured values from the buildings’ technical systems and measured indoor air temperatures in all dwellings. The buildings are heated with district heating, comprise 108 dwellings in total and use approximately 50 kWh/m2 annually (space heating, hot water and electricity for building services). The heat loads are mainly characterised by low but varying heat demands for space heating and hot water. The buildings appear to have a higher than usual sensitivity for variations in heat from internal sources and solar gains, leading to regular variations in the heat demand for space heating and fluctuations in the total heat demand. These fluctuations, which may negatively affect the energy system, could be avoided by actively controlling the heat demand for space heating. There are also daily fluctuations in the indoor temperatures, but the buildings perform well in this aspect, with temperatures that stay within the acceptable range most of the time. The summer indoor temperatures do not get higher than in other buildings. A possibility for further improvement within this area could be the use of forced ventilation during the night in hot periods, and hence utilising the buildings’ well insulated and airtight building envelope to keep heat out during the day. This possibility might further improve the passive house concept.

Inomhusklimatet har en avgörande roll för människans hälsa och välmående då människor befinner sig inomhus i nästan halva sitt liv. Det finns flera aspekter till hur det ska erhållas ett bra inomhusklimat men de mer betydelsefulla aspekterna är både god luftkvalitet och termisk komfort. Samtidigt som innebörden av reducering av energianvändning har en viktig roll i dagens utveckling. Då det ständigt arbetas med att försöka reducera energianvändningen i syfte till att underlätta för miljö- belastningen, väcker det frågor om hur den termiska komforten påverkas av detta. Rapportens syfte kommer därmed ligga i identifikation av uppvärmningssystem för ett givet flerbostadshus i Stockholmsområdet med fokus på termisk komfort och energianvändning. Utvärderingen baseras på olika typer av inverkan från diverse system som har utförts med beräkningssprogrammet IDA ICE. Ett referensfall för ett flerbostadshus användes som underlag och modellerades enligt A- och K-ritningar samt indata enligt Sveby. Det kommer även att inkludera de miljöcertifieringar som används i störst utsträckning här i Sverige och både ange deras krav gällande den termiska komforten samt respektive fokusområde då olika miljöcertifieringar har olika bedömningskriterier.   Under denna studie visade det sig att det sällan tas hänsyn till den termiska komforten på motsvarande sätt som energianvändningen. Det har även visat sig att i de fall där krav gällande den termiska komforten finns, är den otillräckligt definierad för att ge en god uppfattning av komforten. Kraven tar, med andra ord, inte hänsyn till hur bra ett hus presterar under ett helt år utan fokuserar på ett momentant värde. Till simuleringen gjordes en känslighetsanalys som påvisade vikten och behovet av en tydlig standard för odefinierade variabler för att uttrycka människors bedömning av termisk komfort. Efter samtliga simuleringarna, granskades energiberäkningar efter erhållen granskningsmall från WSP Systems i syfte att utföra en egenkontroll samt ge ett underlag för rimlighetsbedömning. Från de erhållna resultaten visade det sig att golvvärme och ökad börvärde till 22 °C gav en ökad termisk komfort men samtidigt en ökning i energianvändningen medan FTX-systemet med radiatorer gav upphov till reducerad energianvändning med cirka en tredjedel samt en liten ökning av den termiska komforten. Det visade sig även vara att vid val av FTX-systemet gav högst årlig energibesparing men att det även bör tas hänsyn till installationskostnaderna för FTX-system och golvvärmesystemet till skillnad från om börvärdet ökas till 22 °C. Det blir då en kostnadsfråga och en avgörande parameter för val bland dessa tre systemen. / The indoor climate plays a crucial role in human health and well-being when people are indoors for nearly half their life. There are several aspects to how one should achieve good indoor climate, but the more significant aspects are both good air quality and thermal comfort. Simultaneously one must regard that the reduction of energy has an important role in today’s development. While trying to reduce energy consumption in order to facilitate the environmental load, it raises the questions whether the thermal comfort is affected by this.  The purpose of the report will lie in the identification of a heating system for a given apartment building in the Stockholm area, with a focus on thermal comfort and energy use. The evaluation is based on various types of impacts from various systems that have been computed in IDA ICE. A reference case for an apartment building was used as a basis and was modeled according to architectural and constructional drawings while input data was used according to Sveby. It will also include the environmental certifications used in Sweden and specify their requirements regarding the thermal comfort, and each focus area as various environmental certifications have different assessment criteria’s. During this study it was found that we rarely take into account the thermal comfort in the same way we do with the energy consumption. It has also been found that in cases where the requirements for the thermal comfort exist, it is often insufficiently defined to provide one with a good perception of comfort. The requirements do, in other words, not take into account how well a building performs during a whole year but instead focuses on one instantaneous value. For the simulation a sensitivity analysis was made that revealed the importance and necessity of a clear standard for undefined variables to express the people’s assessment of thermal comfort. After the simulation part, the energy calculations were examined according to a review template from WSP Systems. This provided a basis for fair consideration. From the obtained results it was shown that floor heating and increasing the setpoint to 22 °C gave an increased thermal comfort but at the same time an increase in energy use. An HVAC system with a heat exchanger and radiators resulted in reduced energy use by about a third from the reference case and a slight increase in current thermal comfort. It also proved that the choice of an HVAC system with heat exchanger produced the highest annual energy savings. However one must take into account installation costs for different types of systems as opposed to when the setpoint is increased to 22 °C. Thus it becomes a cost issue and a critical parameter for selecting among these three types of solutions.

The aim of this diploma thesis is to assess the economic efficiency of alow-energy and passive construction. This paper presents problems of lowenergy and passive construction, their individual characteristics, classification, construction materials, evaluation methods and opportunities for economic assessment due to the investment costs of implementation objects. The main practical part focuses on comparing the investment and operating costs for the construction of a standard, low-energy and passive house. Together with this are processed simple labels building. The out come of this diploma thesis is the calculation of returnability increased by the initial investment in the construction of a standard, low-energy and passive house.

Dissertation deals with the technical parameters of natural thermal insulation. In addition, there is a global trend in the construction of reducing energy consumption for heating, air conditioning, or with operating facilities in buildings and the use of perspective and efficient building materials with a negligible negative impact on the environment. Therefore, the attention not only professionals are increasingly turning to alternative materials, such as natural insulation, the material can be drawn from local sources and whose production is energy-saving and leaving a small ecological footprint. As part of the doctoral thesis were tested short term water absorption, measurements were made of the thermal conductivity and its change after the test short term water absorption. Was determined dependence of thermal conductivity on humidity and heat resistance was determined. Moreover a natural insulation applications in building construction with a comparison of the various technical parameters and environmental footprint. At the conclusion was made by acoustic insulation in timber construction and price analysis.