Sweden's drinking water quality is considered to be high partly due to a high quality of the raw water and a well developed sewage infrastructure. Despite this, there is water contamination that could be prevented by installation of a sophisticated early warning system. Some of the major players in the production of drinking water have already invested in different types of early warning systems to ensure drinking water of high quality. There are various forms of early warning systems where automatic monitoring of E. Coli is an interesting alternative. Today's technology allows for this type of measurement, but it is often expensive and sometimes slow. This work aims to investigate whether the phenomenon of Extraordinary Optical Transmission (EOT) can be used as the technology of sensors for real-time measurement of indicators of fecal contaminated water. EOT is a transmissions peak which arises due to plasmon resonance. The study was conducted by performing verification measurements by spectrophotometry to detect the EOT. After this biomeasurements where done to show that the surface of the sample can be functionalized to provide the opportunity to choose which analytes should be detected. The verifying measurements showed that EOT was detected for one of the five samples where the hole size was 400 nm and the hole spacing was 600 nm. This is due to the high signal strength and to the fact that the phenomenon occurred within the measurement range of the instruments. Samples where designated with the name sPa where s indicates hole size in nm and a hole spacing in nm. The signal strength of the sample 140P600 and 200P600 was too low to determine whether EOT occurred. For samples 400P1000 and 600P1000 calculations showed that EOT occurred outside the measurement range, which meant that EOT could not be measured. Sample 400P600 was chosen to implement bio-measurements wherein the surface was functionalized with biotin Bovine serum albumin (B-BSA) to later bind with fluidMAG Streptavidin. Both B-BSA and streptavidin was bound as shown by the kinetic measurements.

Vid GNSS-positionering i samband med fastighetsbildningsåtgärder används vanligtvis den traditionella RTK-mätningen (Real-Time Kinematic) via SWEPOS nätverks-RTK-tjänst. Denna tjänst kräver mobiltelefontäckning eller motsvarande tvåvägskommunikation, vilket kan vara problematiskt inom områden med bristfällig mobiltelefontäckning. Under dessa förhållanden kan istället PPP-mätning (Precise Point Positioning) vara användbart vid fastighetsbildningsåtgärder då dessa tjänster tar emot korrektionsdata i realtid från satelliter. PPP kräver inte någon mobiltelefontäckning, däremot krävs en kommunikationslänk, en RTX-tjänst för att erhålla korrektioner externt från en RTX-satellit. Syftet med studien är att undersöka möjligheten till att nyttja PPP i realtid vid fastighetsbildningsåtgärder som ett alternativ till traditionell GNSS-mätning med nätverks-RTK. För att PPP ska vara ett alternativ till traditionell GNSS-mätning i realtid krävs det att mätosäkerhetskraven inom fastighetsbildning uppfylls. Mätosäkerheten undersöktes genom att utgå ifrån redan kända koordinater (RIX 95-punkter). Mätningarna har genomförts på fem olika platser i Sverige, Göteborg, Vänersborg, Karlstad, Torsby och Malung-Sälen. Mätdata som erhölls från undersökningsplatserna har analyserats samt jämförts med fastighetsbildningskraven. Resultatet av studien erhölls i form av analyserad mätdata med jämförelser mot redan kända (RIX 95) punkter. Avikelsen från känd RIX 95-punkt redovisas i resultatet utifrån tidsaspekten, den systematiska avvikelsen av translativ art, förändringar i avvikelsen från söder till norr samt utifrån två beräkningsmodeller, varav en translation och en transformation. För att få den erhållna mätdatan från RTX-tjänsten att överensstämma bättre med referenspunkten (RIX 95-punkten) togs beräkningsmodellerna fram för att möjliggöra modellering av systematiska avvikelser som uppkommit och därmed uppfylla kraven inom fasighetsbildningsåtgärder. Genom att ha analyserat och granskat olika samband har det framkommit att efter ca 20 minuters mätning, börjar precisionen för mätningarna att bli stabila. Utifrån resultatet är slutsatsen att PPP inte fungerar vid fastighetsbildningsåtgärder för områden inom stomnät, däremot fungerar metoden för skogs- och jordbruksfastigheter utanför stomnät. Förutsatt att en modellering genom translation alternativt transformation som är framtagen i denna studie används för att justera koordinaterna så fungerar PPP-mätning inom samtliga fastighetsbildningsåtgärder. Detta kräver då att mätdata erhålls efter 20 minuters mätning eller mer. / GNSS positioning in conjunction with the real property is usually used the traditional RTK measuring (Real-Time Kinematic) by SWEPOS network RTK service. This service requires mobile phone coverage or equivalent two-way communication, which can be problematic in areas with poor mobile phone coverage. Under these circumstances, PPP (Point Positioning Precise) could be more useful in real property measures when such services receives the correction data in real time from the satellites. PPP does not require any cell phone coverage, however it requires a communication link, a RTX service to obtain corrections externally from a RTX satellite. The purpose of the study is to examine the possibility of using PPP in real time at the real property as an alternative to traditional GNSS measurements with network RTK. The measurement uncertainty was investigated by starting out from already known coordinates (RIX 95 points). The measurements were performed out at five different locations in Sweden, Gothenburg, Vanersborg, Karlstad, Torsby and Malung-Salen. Measurement data obtained from the observations have been analyzed and compared with real property requirements. The results of the study were obtained in the form of data analyzed by comparison of the known (RIX 95) points. The deviation is known from RIX 95 point recognized in income based on the time factor, the bias of the translative case species, changes in deviation from south to north and from two calculation models, a translation and a transformation. To correct the measured values from the RTX service for a better match to the RIX 95 points calculation models were developed to facilitate the modeling of systematic deviations incurred and meet the demands of real property. Analyzing and examining various relationships have shown that after about 20 minutes of measuring, the precision of the measurements starts to become more stable. Based on the results, the conclusion is that the PPP does not work in real property areas within the core network, however, the method works for forestry and agricultural properties outside the core network. Assuming a modelling through translational alternative transformation, developed in this study is used to adjust the coordinates, the PPP measurement is working in all real property registration measures. This requires that the measurement data is obtained after 20 minutes of measurement or more.

The thesis aims to examine the impact of climate change on line rating and to investigate the possibility of a potential increase of capacity of an overhead line. The line rating of an overhead line determines how much current can be transmitted in the line. The weather parameters which affect the line rating are ambient temperature, solar radiation, wind speed, and wind direction. If the line rating is adapted to weather conditions, it is important to be able to predict how the weather will change in the future. Therefore, the impact of climate change on weather parameters is investigated. The ambient temperature and solar radiation are expected to change between different scenarios. However, it is unclear how wind speed and wind direction will be affected. Climate scenarios are designed that take these findings into account. The results show that wind speed has, by a large margin from other weather parameters, the largest impact on the dynamic line rating. This is followed by the wind's angle of attack to the conductor, ambient temperature, and finally solar radiation. For the designed climate scenarios, the dynamic line rating is almost the same in each case, which means that the calculated change in ambient temperature and solar radiation has no significant effect on the line rating. To further increase the capacity of the overhead line, the line could be upgraded with a conductor with a larger cross-sectional area.