The research topics presented in this dissertation focus on validation of customer-level voltage synchrophasor data for transmission system analysis, detection and categorization of power system events as measured by phasor measurement units (PMUs), and identification of the influence of power system conditions (wind power, daily and seasonal load variation) on low-frequency oscillations. Synchrophasor data can provide information across entire power systems but obtaining the data, handling the large dataset and developing tools to extract useful information from it is a challenge. To overcome the challenge of obtaining data, an independent synchrophasor network was created by taking synchrophasor measurements at customer-level voltage. The first objective is to determine if synchrophasor data taken at customer-level voltage is an accurate representation of power system behavior. The validation process was started by installing a transmission level (69 kV) PMU. The customer-level voltage measurements were validated by comparison of long term trends and low-frequency oscillations estimates. The techniques best suited for synchrophasor data analysis were identified after a detailed study and comparison. The same techniques were also applied to detect power system events resulting in the creation of novel categories for numerous events based on shared characteristics. The numerical characteristics for each category and the ranges of each numerical characteristic for each event category are identified. The final objective is to identify trends in power system behavior related to wind power and daily and seasonal variations by utilizing signal processing and statistical techniques. / text

This study takes advantage of wide area measurements to propose a centralized nonlinear controller that acts on power system stabilizers, to cooperatively increase the damping of problematic small signal oscillations all over the system. The structure based on decision trees results in a simple, efficient, and dependable methodology that imposes much less computational burden than other nonlinear design approaches, making it a promising candidate for actual implementation by utilities and system operators. Details are given to utilize existing stabilizers while causing minimum changes to the equipment, and warranting improvement or at least no detriment of current system behavior. This enables power system stabilizers to overcome their inherent limitation to act only on the basis of local measurements to damp a single target frequency. This study demonstrates the implications of this new input on mathematical models, and the control functionality that is made available by its incorporation to conventional stabilizers. In preparation of the case of study, a heuristic dynamic reduction methodology is introduced that preserves a physical equivalent model, and that can be interpreted by any commercial software package. The steps of this method are general, versatile, and of easy adaptation to any particular power system model, with the aggregated value of producing a physical model as final result, that makes the approach appealing for industry. The accuracy of the resulting reduced network has been demonstrated with the model of the Central American System. / Ph. D.

Monitoring and protection of power systems is a task that has manifold objectives. Amongst others, it involves performing data mining, optimizing available resources, assessing system stresses, and doing data conditioning. The role of PMUs in fulfilling these four objectives forms the basis of this dissertation. Classification and regression tree (CART) built using phasor data has been extensively used in power systems. The splits in CART are based on a single attribute or a combination of variables chosen by CART itself rather than the user. But as PMU data consists of complex numbers, both the attributes, should be considered simultaneously for making critical decisions. An algorithm is proposed here that expresses high dimensional, multivariate data as a single attribute in order to successfully perform splits in CART. In order to reap maximum benefits from placement of PMUs in the power grid, their locations must be selected judiciously. A gradual PMU placement scheme is developed here that ensures observability as well as protects critical parts of the system. In order to circumvent the computational burden of the optimization, this scheme is combined with a topology-based system partitioning technique to make it applicable to virtually any sized system. A power system is a dynamic being, and its health needs to be monitored at all times. Two metrics are proposed here to monitor stress of a power system in real-time. Angle difference between buses located across the network and voltage sensitivity of buses lying in the middle are found to accurately reflect the static and dynamic stress of the system. The results indicate that by setting appropriate alerts/alarm limits based on these two metrics, a more secure power system operation can be realized. A PMU-only linear state estimator is intrinsically superior to its predecessors with respect to performance and reliability. However, ensuring quality of the data stream that leaves this estimator is crucial. A methodology for performing synchrophasor data conditioning and validation that fits neatly into the existing linear state estimation formulation is developed here. The results indicate that the proposed methodology provides a computationally simple, elegant solution to the synchrophasor data quality problem. / Ph. D.

Power systems must face new challenges in the current environment. The energy market liberalization and the increase in the loading level make the occurrence of instability phenomena leading to large blackouts more likely. Existing tools must be improved and new tools must be developed to avoid them.<p><p>The aim of this thesis is the improvement of the voltage stability assessment efficiency. Two orientations are studied: the monitoring methods and the load modeling.<p><p>The purpose of the monitoring methods is to evaluate the voltage stability using only measurements and without running simulations. <p><p>The first approach considered is local. The parameters of the Thevenin equivalent seen from a load bus are assessed thanks to a stream of local voltage and current measurements. Several issues are investigated using measurements coming from complete time-domain simulations. The applicability of this approach is questioned.<p><p>The second approach is global and uses measurements acquired by a Wide-Area Measurement System (WAMS). An original approach with a certain prediction capability is proposed, along with intuitive visualizations that allow to understand the deterioration process leading to the collapse.<p><p>The load modeling quality is certainly the weak point of the voltage security assessment tools which run simulations to predict the stability of the power system depending on different evolutions. Appropriate load models with accurate parameters lead to a direct improvement of the prediction precision.<p><p>An innovative procedure starting from data of long measurement campaigns is proposed to automatically evaluate the parameters of static and dynamic load models. Real measurements taken in the Belgian power system are used to validate this approach.<p> / Doctorat en Sciences de l'ingénieur / info:eu-repo/semantics/nonPublished

Continued increase in system load leading to a reduction in operating margins, as well as the tendency to move towards a deregulated grid with renewable energy sources has increased the vulnerability of the grid to blackouts. Advanced intelligent techniques are therefore required to design new monitoring schemes that enable smart grid operation in a secure and robust manner. As the grid is highly interconnected, monitoring of transmission and distribution systems is increasingly relying on digital communication. Conventional security assessment techniques are slow, hampering real-time decision making. Hence, there is a need to develop fast and accurate security monitoring techniques. Intelligent techniques that are capable of processing large amounts of captured data are finding increasing scope as essential enablers for the smart grid. The research work presented in this thesis has evolved from the need for enhanced monitoring in transmission and distribution grids. The potential of intelligent techniques for enhanced system monitoring has been demonstrated for disturbed scenarios in an integrated power system. In transmission grids, one of the challenging problems is network partitioning, also known as network area-decomposition. In this thesis, an approach based on relative electrical distance (RED) has been devised to construct zonal dynamic equivalents such that the dynamic characteristics of the original system are retained in the equivalent system within the desired accuracy. Identification of coherent generators is another key aspect in power system dynamics. In this thesis, a support vector clustering-based coherency identification technique is proposed for large interconnected multi-machine power systems. The clustering technique is based on coherency measure which is formulated using the generator rotor measurements. These rotor measurements can be obtained with the help of Phasor Measurement Units (PMUs). In distribution grids, accurate and fast fault identification of faults is a key challenge. Hence, an automated fault diagnosis technique based on multi class support vector machines (SVMs) has been developed in this thesis. The proposed fault location scheme is capable of accurately identify the fault type, location of faulted line section and the fault impedance in the distributed generation (DG) systems. The proposed approach is based on the three phase voltage and current measurements available at all the sources i.e. substation and at the connection points of DGs. An approach for voltage instability monitoring in 3-phase distribution systems has also been proposed in this thesis. The conventional single phase L-index measure has been extended to a 3-phase system to incorporate information pertaining to unbalance in the distribution system. All the approaches proposed in this thesis have been validated using standard IEEE test systems and also on practical Indian systems.

Classically, wide-area synchronized power system monitoring has been an expensive task requiring significant investment in utility communications infrastructures for the service of relatively few costly sensors. The purpose of this research is to demonstrate the viability of power system monitoring from very low voltage levels (120 V). Challenging the accepted norms in power system monitoring, the document will present the use of inexpensive GPS time synchronized sensors in mass numbers at the distribution level. In the past, such low level monitoring has been overlooked due to a perceived imbalance between the required investment and the usefulness of the resulting deluge of information. However, distribution level monitoring offers several advantages over bulk transmission system monitoring. First, practically everyone with access to electricity also has a measurement port into the electric power system. Second, internet access and GPS availability have become pedestrian commodities providing a communications and synchronization infrastructure for the transmission of low-voltage measurements. Third, these ubiquitous measurement points exist in an interconnected fashion irrespective of utility boundaries. This work offers insight into which parameters are meaningful to monitor at the distribution level and provides applications that add unprecedented value to the data extracted from this level. System models comprising the entire Eastern Interconnection are exploited in conjunction with a bounty of distribution level measurement data for the development of wide-area disturbance detection, classification, analysis, and location routines. The main contributions of this work are fivefold: the introduction of a novel power system disturbance detection algorithm; the development of a power system oscillation damping analysis methodology; the development of several parametric and non-parametric power system disturbance location methods, new methods of power system phenomena visualization, and the proposal and mapping of an online power system event reporting scheme. / Ph. D.