A power assisted wheelchair combines human power, which is delivered by the arms through the pushrims, with electrical motors, which are powered by a battery. Today’s electric power assisted wheelchairs use force sensors to measure the torque exerted on the pushrims by the user. The force sensors in the pushrims are rather expensive and this approach also makes the wheels a little bit clumsy. The objective with this project is to find a new, better and cheaper solution that does not use expensive force sensors in the pushrims. The new power assisted wheelchair will instead only rely on its velocity, which is measured with rotational encoders, as feedback signal and thereby the project name “Torque Sensor Free Power Assisted Wheelchair”. The project consisted of two main parts; an extensive construction part, where an ordinary joystick controlled motorized wheelchair has been rebuild to the new power assisted wheelchair without torque sensors and a development part, where different torque sensor free controllers has been designed, simulated, programmed and tested. The project resulted in a torque sensor free power assisted wheelchair, where the final implemented design is a proportional derivative controller, which gives a very good assisting system that is robust and insensitive to measurement noise. The proportional derivative control design gives two adjustable parameters, which can be tuned to fit a certain user; one parameter is used to adjust the amplification of the user’s force and the other one is used to change the lasting time of the propulsion influence. Since the new assisting control system only relies on the velocity, the torque sensor free power assisted wheelchair will besides giving the user assisting power also give an assistant, which pushes the wheelchair, additional power. This is a big advantage compared to the pushrim activated one, where this benefit for the assistant is not possible.

This master´s thesis is focused on now being developed electric taxi system, which is going to be used for aircraft´s ground movement. The content of this work includes description of this system, requirements and developed solutions, next part describes and evaluate the consequences of deployment such system in real traffic.

In high power induction motor drives, the switching frequency of the inverter is quite low due to the high losses in the power devices. Real-time PWM strategies, which result in reduced harmonic distortion under low switching frequencies and have maximum possible DC bus utilisation, are developed for such drives in the present work. The space vector approach is taken up for the generation of synchronised PWM waveforms with 3-Phase Symmetry, Half Wave Symmetry and Quarter Wave Symmetry, required for high-power drives. Rules for synchronisation and the waveform symmetries are brought out. These rules are applied to the conventional and modified forms of space vector modulation, leading to the synchronised conventional space vector strategy and the Basic Bus Clamping Strategy-I, respectively. Further, four new synchronised, bus-clamping PWM strategies, namely Asymmetric Zero-Changing Strategy, Boundary Sampling Strategy-I, Basic Bus Clamping Strategy-II and Boundary Sampling Strategy-II, are proposed. These strategies exploit the flexibilities offered by the space vector approach like double-switching of a phase within a subcycle, clamping of two phases within a subcycle etc. It is shown that the PWM waveforms generated by these strategies cannot be generated by comparing suitable 3-phase modulating waves with a triangular carrier wave. A modified two-zone approach to overmodulation is proposed. This is applied to the six synchronised PWM strategies, dealt with in the present work, to extend the operation of these strategies upto the six-step mode. Linearity is ensured between the magnitude of the reference and the fundamental voltage generated in the whole range of modulation upto the six-step mode. This is verified experimentally. A suitable combination of these strategies leads to a significant reduction in the harmonic distortion of the drive at medium and high speed ranges over the conventional space vector strategy. This reduction in harmonic distortion is demonstrated, theoretically as well as experimentally, on a constant V/F drive of base frequency 50Hz for three values of maximum switching frequency of the inverter, namely 450Hz, 350Hz and 250Hz. Based on the notion of stator flux ripple, analytical closed-form expressions are derived for the harmonic distortion due to the different PWM strategies. The values of harmonic distortion, computed based on these analytical expressions, compare well with those calculated based on Fourier analysis and those measured experimentally.