While there has been a great deal of research on air entrainment at hydraulic jumps within closed conduits, very little of the research has specifically addressed size and temperature scale effects. Influences from jump location and changing length characteristics on air entrainment have also received little attention from past research. To determine the significance of size-scale effects of air entrained by hydraulic jumps in closed conduits, air flow measurements were taken in four different-sized circular pipe models with similar Froude numbers. Each of the pipe models sloped downward and created identical flow conditions that differed only in size. Additionally, specific measurements were taken in one of the pipe models with various water temperatures to identify any effects from changing fluid properties. To determine the significance of the effects of changed length characteristics on air demand, air flow measurements were taken with hydraulic jumps at multiple locations within a circular pipe with two different air release configurations at the end of the pipe. Results showed that air demand was not affected by the size of the model. All together, the data from four different pipe models show that size-scale effects of air entrained into hydraulic jumps within closed conduits are negligible. However, it was determined that air entrainment was significantly affected by the water temperature. Water at higher temperatures entrained much less air than water at lower temperatures. Hydraulic jump location results showed that for both configurations the percentage of air entrainment significantly increased as the hydraulic jump occurred near the point of air release downstream. As the jump occurred nearer to the end of the pipe, its length characteristics were shortened and air demand increased. However, jump location was only a significant factor until the jump occurred some distance upstream where the length characteristics were not affected. Upstream of this location the air demand was dependent only on the Froude number immediately upstream of the jump.

京都大学 / 0048 / 新制・課程博士 / 博士(工学) / 甲第18589号 / 工博第3950号 / 新制||工||1607(附属図書館) / 31489 / 京都大学大学院工学研究科原子核工学専攻 / (主査)教授 功刀 資彰, 教授 中部 主敬, 講師 河原 全作 / 学位規則第4条第1項該当 / Doctor of Philosophy (Engineering) / Kyoto University / DFAM

No description available.

No description available.

No description available.

We have examined potential influences of gender, age, and nutrition on the expression of circadian locomotor activity rhythms in the flesh fly Sarcophaga crassipalpis. We found no significant differences in endogenous circadian period under constant dark conditions resulting from gender, nutrition, or age. Male and female flesh flies were predominantly diurnal under light-dark cycles, but their entrainment patterns differed. Females displayed higher activity levels and increasing activity with age, unlike males. Moreover, females exhibited an extraordinary, but transient, departure from diurnality which we characterize as “extended dark activity” (EDA), a continuous bout of locomotor activity extending three hours, or longer, into the dark phase at twice the median of the individual’s overall locomotor activity. EDA occurred as an age-dependent response to liver consumption. Our results suggest a linkage between physiological events associated with egg provisioning and locomotor activity as well as multiple influences on the expression of circadian clock-regulated behavior.

Cold-flow tests were performed using a simulated Air Augmented Rocket (AAR) operating as a mixer-ejector in order to investigate the effects of varied primary nozzle lip thickness on mixing and entrainment. The simulated primary rocket ejector was supplied with nitrogen at a maximum chamber stagnation pressure of 1712 psi, and maximum flow rate of 1.67 lbm/s. Secondary air was entrained from a plenum, producing pressures as low as 6.8 psi and yielding maximum stagnation pressure ratios as high as 160. The primary ejector nozzles each had an area ratio of approximately 20, yielding average primary exit Mach numbers between 4.34 and 4.57. The primary flow was ejected into an 18.75 inch-long mixing duct with a rectangular cross-sectional area of 2.10 in2. The secondary flow was entrained into the mixing duct through a total cross section of 0.94 in2. Two mixing duct configurations were used, one with plexiglass upper and lower surfaces for flow visualization and one with pressure ports along the lower surface for primary plume measurements. Shadowgraph images were used to characterize the mixing duct flow field, while pressure and temperature instrumentation allowed for calculation of various ejector performance characteristics. Experimentally-calculated performance characteristics were compared to inviscid theoretical predictions. Varying degrees of flow field asymmetry were observed with each nozzle. Test repeatability was found to be excellent for all nozzles. Several distinct phenomena were observed in both the primary plume and secondary streams. The duration of secondary flow choking was found to be inversely proportional to nozzle lip thickness, due to the primary plume being physically closer to the secondary flow with a thinner nozzle lip. This indicated that the ejector’s ability to choke the secondary flow is primarily an inviscid phenomenon. Secondary flow blockage was demonstrated in two consecutive tests using the thickest nozzle lip. Only the left secondary duct became blocked in each case. Blockage was only demonstrated in the centerline pressure configuration, so no visual evidence was able to support the blocked flow theory. At every pressure ratio, entrainment ratio was shown to increase with nozzle lip thickness. The original conical nozzle produced the largest level of entrainment, indicating that the angle of primary flow impingement was the largest contributing factor to secondary entrainment. The increase in efficiency resulting from a bell-mouth nozzle was less than the increase in entrainment efficiency of a conical nozzle, indicating that the conical design was more efficient overall for air augmented rocket applications.

No description available.

No description available.

No description available.