Spectrum splitting is an approach to increasing the conversion efficiency of a photovoltaic (PV) system. Several methods can be used to perform this function which requires efficient spatial separation of different spectral bands of the incident solar radiation. In this paper several of holographic methods for implementing spectrum splitting are reviewed along with the benefits and disadvantages associated with each approach. The review indicates that a volume holographic lens has many advantages for spectrum splitting in terms of both power conversion efficiency and energy yield. A specific design for a volume holographic spectrum splitting lens is discussed for use with high bandgap InGaP and low bandgap silicon PV cells. The holographic lenses are modeled using rigorous coupled wave analysis, and the optical efficiency is evaluated using non-sequential raytracing. A proof-of-concept off-axis holographic lens is also recorded in dichromated gelatin film and the spectral diffraction efficiency of the hologram is measured with multiple laser sources across the diffracted spectral band. The experimental volume holographic lens (VHL) characteristics are compared to an ideal spectrum splitting filter in terms of power conversion efficiency and energy yield in environments with high direct normal incidence (DNI) illumination and high levels of diffuse illumination. The results show that the experimental VHL can achieve 62.5% of the ideal filter power conversion efficiency, 64.8% of the ideal filter DNI environment energy yield, and 57.7% of the ideal diffuse environment energy yield performance.

In this study the impact of outdoor temperature variations and solar illumination exposure on spectral filter material and holographic optical elements is examined. Although holographic components have been shown to be useful for solar spectrum splitting designs, relatively little quantitative data exist to demonstrate the extent to which these materials can withstand outdoor conditions. As researchers seek to investigate practical spectrum splitting designs, the environmental stability of holographic materials should be considered as an important factor. In the experiment presented, two holographic materials, Covestro Bayfol HX photopolymer and dichromated gelatin, and 3M reflective polymer filter materials are exposed to outdoor conditions for a period of several months. The environmental effect on absorption, spectral and angular bandwidth, peak efficiency, and Bragg matching conditions for the holograms are examined. Spectral bandwidth and transmittance of the 3M reflective filter material are also monitored. Holographic gratings are recorded, measured, and mounted on glass substrates and then sealed with a glass cover plate. The test samples are then mounted on a photovoltaic panel to simulate realistic temperature conditions and placed at an outdoor test facility in Tucson, Arizona. A duplicate set of holograms and 3M filter material is stored as a control group and periodically compared over the test period.

In this paper a prototype spectrum-splitting photovoltaic system based on volume holographic lenses (VHL) is designed, fabricated and tested. In spectrum-splitting systems, incident sunlight is divided in spectral bands for optimal conversion by a set of single-junction PV cells that are laterally separated. The VHL spectrum-splitting system in this paper has a form factor similar to conventional silicon PV modules but with higher efficiencies (>30%). Unlike many other spectrum-splitting systems that have been proposed in the past, the system in this work converts both direct and diffuse sunlight while using inexpensive 1-axis tracking systems. The VHL system uses holographic lenses that focus light at a transition wavelength to the boundary between two PV cells. Longer wavelength light is dispersed to the narrow bandgap cell and shorter wavelength light to the wide bandgap cell. A prototype system is designed with silicon and GaAs PV cells. The holographic lenses are fabricated in Covestro Bayfol HX photopolymer by 'stitching' together lens segments through sequential masked exposures. The PV cells and holographic lenses were characterized and the data was used in a raytrace simulation and predicts an improvement in total power output of 15.2% compared to a non-spectrum-splitting reference. A laboratory measurement yielded an improvement in power output of 8.5%.

This work is dedicated to a comprehensive experimental study on the interaction of femtosecond laser pulses with the nonlinear optical medium lithium niobate. The nonlinear optical response in the nanosecond regime was already studied extensively with a variety of techniques, whereas femtosecond pulses were mainly used in transient absorption or transient grating experiments. Naturally, the temporal resolution of these measurements depends on the pulse duration, however, dynamics during the pulse excitation were barely investigated. The motivation of this work is to widen the limits of femtosecond spectroscopy, not only to temporally resolve faster nonlinear optical processes, but further to show a sensitivity to other coupling mechanisms between the pulses and the material. Especially, the role of transient, dynamic holographic gratings is investigated with a careful determination of the pulse duration, bandwidth and frequency chirp. A basis of this work is established in the first part by studying the material response via light-induced absorption before focusing on the main topic, the pulse interaction with elementary (holographic) gratings, both self-induced and static, in the second part. By this detailed study, several features of femtosecond laser pulses, holographic gratings and the ultrafast material response can be revealed: (i) grating recording is feasible even with pulses of different frequencies, provided that their pulse duration is sufficiently short, (ii) grating based pulse coupling causes a pronounced energy transfer even in a common pump-probe setup for transient absorption measurements with (non-)degenerated frequencies, (iii) beyond expectation, oscillations in the phonon frequency range become apparent in different measurements. The presented results point towards appropriate future experiments to obtain a more consistent, microscopic model for the ultrafast response of the crystal, involving the interplay between photo-generated polarons, self-induced gratings, and phonons.

We develop a theory of vectorial wave coupling in cubic photorefractive crystals placed in an alternating ac-field to enhance the nonlinear response. First we analytically and numerically investigate the dependences of the first Fourier harmonics of the space-charge field, induced in an AC-biased sillenite crystal by a light-interference pattern, on the light contrast m. The data obtained was used to extend the vectorial beam-coupling theory on the whole contrast region. In particular, we proved in the general case that despite of essential differences between thediffusion and AC nonlocal responses the later keeps the light interference fringes straight during the interaction. This fundamental feature allows, under certain restrictions, to reduce the nonlinear problem of vectorial coupling to the known linear problem of vectorial Bragg diffraction from a spatially uniform grating, which admits an exact solution. As a result, the nonlinear vectorial problem can be effectively solved for a number of practically important cases.The developed theory was applied to describe the transformation of a momentary phase changes of one of the input beams into the output intensity modulation (so-called grating translation technique). In contrast to the previous studies, we take into account the change of the space-charge field amplitude across the crystal (the coupling effects). The theory developed is employed to optimize the conditions for the linear signal detection under polarization filtering for the transverse and longitudinal optical configurations. We also analyze the possibility of the linear detection without polarization filtering.Illumination of AC-biased photorefractive BTO crystals with a coherent light beam results in development of strong nonlinear scattering. We investigate the angular and polarization characteristics of the scattered light for the diagonal optical configuration and different polarization states of the pump.

In der vorliegenden Arbeit werden die nichtlinearen optischen Eigenschaften der Materialien Lithiumniobat und Di-Zinn-Hexathiohypodiphosphat aufgrund der Suszeptibilität 3. Ordnung und kleiner Polaronen untersucht. Zudem wird gezeigt, dass die Interferenz verschiedenfarbiger Laserpulse die Aufzeichnung von statischen und dynamischen holographischen Gittern ermöglicht. Ein Teil dieser Arbeit ist in den im Anhang angegebenen 6 Publikationen bereits veröffentlicht. Lithiumniobat wird mit einer Erweiterung des Z-Scan Experiments untersucht, welches die Pulslängenabhängige Messung der nichtlinearen Absorption und der nichtlinearen Brechungsindexänderung ermöglicht. Dabei konnte festgestellt werden, dass bei sehr kurzen Pulslängen von 70 fs ein Effekt der Polaronen auf die nichtlineare Absorption vernachlässigbar ist und die Zwei-Photonen-Absorption die nichtlineare Absorption dominiert. Mit größerer Pulslänge gibt es allerdings Abweichungen zwischen der Theorie der Zwei-Photonen-Absorption und den Messergebnissen. Mit der Entwicklung eines Polaronen-Anregungs-Modells, welches eine polaronische Absorption aufgrund wiederholtem optisch induziertem Hopping annimmt, konnte dieser Effekt konsistent erklärt werden. Die Messungen der nichtlinearen Brechungsindexänderung lassen darauf schließen, dass sowohl freie Ladungsträger als auch kleine Polaronen neben der Suszeptibilität 3. Ordnung einen Einfluss auf die Brechungsindexänderung haben, da eine nichtlineare Abhängigkeit von der Intensität auch bei Pulslängen von 70 fs festgestellt werden konnte. Analog dazu konnte in Di-Zinn-Hexathiohypodiphosphat ein großer Zwei-Photonen-Absorptionskoeffizient festgestellt werden, welcher für Photonenenergien nahe der Bandkante Werte zeigt, die größer sind als theoretischen Überlegungen zeigen. Eine transiente Absorption nach optischer Anregung, gemessen durch ein Anreg-Abtast-Experiment, sowie Literatur legen nahe, dass in Di-Zinn-Hexathiohypodiphosphat gebundene Lochpolaronen durch optische Anregung entstehen können. Durch den hohen Zwei-Photonen-Absorptionskoeffizienten konnte das Aufzeichnen eines kontrastreichen, dynamischen Amplitudengitters mittels Femtosekundenpulsen gezeigt und nachgewiesen werden. Die Kürze der Femtosekundenpulse ermöglicht aber nicht nur das Aufzeichnen eines Zwei-Photonen-Absorptionsgitters aufgrund der hohen Intensitäten, sondern erlaubt zudem die Beobachtung von Interferenz zwischen verschiedenfarbigen Pulsen. In der Zeitspanne der Pulslänge beträgt die Bewegung der Interferenzstreifen, welche in der Größenordnung der Lichtgeschwindigkeit liegt, nur ein Bruchteil der Streifendistanz, sodass das Interferenzmuster eingefroren und beobachtbar erscheint. Somit lassen sich statische Hologramme in holographischen Filmen, wie auch dynamische Hologramme aufzeichnen. Über ein dynamisches holographisches Gitter mittels Zwei-Photonen-Absorption konnte so eine Frequenzkonversion durch Dopplerverschiebung in Lithiumniobat gezeigt werden.