No description available.

Despite all environmental and economic advantages of wind power, noise emission remains an issue for population acceptance. In France, the current noise emission regulation defines noise emergence level thresholds, leading to wind turbine curtailment. Great energy generation losses and thus lost revenues are at stake. This master thesis presents current acoustic campaigns conducted for the development of a wind power project in France and proposes acoustic model improvements to predict curtailment losses before the construction of the wind farm. It first gives insights about the French wind power context and a literature review of available technologies to reduce noise emission from the blades. It then presents the particularities of French regulation of emergence levels and the use of the norm NFS 31-114 during the commissioning acoustic control. It explains the current acoustic model used at the development stage to predict noise emission and curtailment and finally proposes improvements such as considering the topography, the environmental characteristics and the use of uncertainties.

Noise is a circumstance of ordinary life and mainly originated by continually growing dynamic and the rapid development of society. In the industrial environment there are noise-intensive parts that influence the condition of present operators negatively. Thus, measures of noise abatement have been investigated intensely by industrial companies as well as federal agencies. As a subdomain of fluid power pneumatics is especially known for characteristic noise emission by the use of air as power transmission. The transient decompression of air from pressure levels up to 8 bar and partly high flow rates nearby sonic speed cause the emergence of direct airborne noise at vent ports of pneumatic components. The following paper outlines the mechanisms that induce the emission of high sound pressure levels. In order to achieve reproducible results a test bench for varying pneumatic standard components is introduced. Based on a selection of those components results are compared to standardized measurement procedures whether fulfilling the standardizations’ requirements. In conclusion, two benefits are achieved. Firstly, standardization is derived enabling neutral comparison of standard pneumatic components’ noise emission. Secondly, the measures can be evaluated to determine the most promising way to redesign pneumatic components of lower noise emissions.

Esse trabalho apresenta uma análise de dados dos níveis de ruído referentes à Subprefeitura de Pinheiros/SP. Foram feitas medições em quarenta pontos, divididas em três fases que puderam ser comparadas com os limites estabelecidos pela lei de zoneamento. Nos processos de levantamentos de dados elaboramos mapas que serviram de suporte tanto em decisões como posteriormente na análise/comparação destes em relação aos limites sonoros estabelecidos. Na primeira fase observou-se uma grande quantidade de pontos com valores acima de 15 dB em relação aos limites estabelecidos. Nas fases seguintes houve uma diminuição, quando comparadas a primeira. Assim obtivemos um panorama dos níveis de ruído da área de estudo e sua situação em relação à lei de zoneamento urbano da cidade de São Paulo. / This paper presents an analysis of data concerning the noise levels referring to Pinheiros Subprefecture (in São Paulo city). Measurements made in forty spots, divided in three steps that could be compared with the limits established by zoning law. In procedures for survey data were prepared maps that served as pillar in decisions as well as later in analysis/comparison of these in relation to the noise limits established. In the first phase there were large numbers of points with values above 15 dB above the limits. In later stages there was an improvement compared with the measurements of the first phase. So we got a picture of the noise levels of the study area and its situation in relation to the urban zoning law of São Paulo city.

Vertical axis wind turbines (VAWTs) have with time been outrivaled by the today common and economically feasible horizontal axis wind turbines (HAWTs). However, VAWTs have several advantages such as the possibility to put the drive train at ground level, lower noise emissions and better scaling behavior which still make them interesting for research. The work within this thesis is made in collaboration between the Department of Construction and Energy Engineering at Halmstad University and the Division for Electricity at Uppsala University. A 200 kW VAWT owned by the latter and situated close to Falkenberg in the southwest of Sweden has been the main subject of the research even if most learnings has been generalized to fit a typical vertical turbine. This particular turbine has a wooden tower which is semi-guy-wired, i.e. the tower is both firmly attached to the ground and supported by guy-wires. This thesis has two main topics both regarding VAWTs: eigenfrequency of the tower and the noise generated from the turbine. The eigenfrequency of a semi-guy-wired tower is studied and an analytical expression describing this is produced and verified by experiments and simulations. The eigenfrequency of the wire itself and how it is affected by wind load are also studied.  The noise characteristics of VAWTs have been investigated, both theoretically and by noise measurement campaigns. Both noise emission and frequency distribution of VAWTs has been studied. The work has resulted in analytical expressions for tower and wire eigenfrequency of a semi-guy-wired tower as well as recommendations for designing future towers for VAWTs. The noise emission of VAWTs has been studied and proven low compared to HAWTs. The noise frequency distribution of the 200 kW VAWT differs significantly from that of a similar size HAWTs with for example lower levels for frequencies below 3000 Hz.

Esse trabalho apresenta uma análise de dados dos níveis de ruído referentes à Subprefeitura de Pinheiros/SP. Foram feitas medições em quarenta pontos, divididas em três fases que puderam ser comparadas com os limites estabelecidos pela lei de zoneamento. Nos processos de levantamentos de dados elaboramos mapas que serviram de suporte tanto em decisões como posteriormente na análise/comparação destes em relação aos limites sonoros estabelecidos. Na primeira fase observou-se uma grande quantidade de pontos com valores acima de 15 dB em relação aos limites estabelecidos. Nas fases seguintes houve uma diminuição, quando comparadas a primeira. Assim obtivemos um panorama dos níveis de ruído da área de estudo e sua situação em relação à lei de zoneamento urbano da cidade de São Paulo. / This paper presents an analysis of data concerning the noise levels referring to Pinheiros Subprefecture (in São Paulo city). Measurements made in forty spots, divided in three steps that could be compared with the limits established by zoning law. In procedures for survey data were prepared maps that served as pillar in decisions as well as later in analysis/comparison of these in relation to the noise limits established. In the first phase there were large numbers of points with values above 15 dB above the limits. In later stages there was an improvement compared with the measurements of the first phase. So we got a picture of the noise levels of the study area and its situation in relation to the urban zoning law of São Paulo city.

Noise is a circumstance of ordinary life and mainly originated by continually growing dynamic and the rapid development of society. In the industrial environment there are noise-intensive parts that influence the condition of present operators negatively. Thus, measures of noise abatement have been investigated intensely by industrial companies as well as federal agencies. As a subdomain of fluid power pneumatics is especially known for characteristic noise emission by the use of air as power transmission. The transient decompression of air from pressure levels up to 8 bar and partly high flow rates nearby sonic speed cause the emergence of direct airborne noise at vent ports of pneumatic components. The following paper outlines the mechanisms that induce the emission of high sound pressure levels. In order to achieve reproducible results a test bench for varying pneumatic standard components is introduced. Based on a selection of those components results are compared to standardized measurement procedures whether fulfilling the standardizations’ requirements. In conclusion, two benefits are achieved. Firstly, standardization is derived enabling neutral comparison of standard pneumatic components’ noise emission. Secondly, the measures can be evaluated to determine the most promising way to redesign pneumatic components of lower noise emissions.

Vertical axis wind turbines (VAWTs) have with time been outrivaled by the today common and economically feasible horizontal axis wind turbines (HAWTs). However, VAWTs have several advantages such as the possibility to put the drive train at ground level, lower noise emissions and better scaling behavior which still make them interesting for research. The work within this thesis is made in collaboration between the Department of Construction and Energy Engineering at Halmstad University and the Division for Electricity at Uppsala University. A 200 kW VAWT owned by the latter and situated close to Falkenberg in the southwest of Sweden has been the main subject of the research even if most learnings has been generalized to fit a typical vertical turbine. This particular turbine has a wooden tower which is semi-guy-wired, i.e. the tower is both firmly attached to the ground and supported by guy-wires. This thesis has two main topics both regarding VAWTs: eigenfrequency of the tower and the noise generated from the turbine. The eigenfrequency of a semi-guy-wired tower is studied and an analytical expression describing this is produced and verified by experiments and simulations. The eigenfrequency of the wire itself and how it is affected by wind load are also studied.  The noise characteristics of VAWTs have been investigated, both theoretically and by noise measurement campaigns. Both noise emission and frequency distribution of VAWTs has been studied. The work has resulted in analytical expressions for tower and wire eigenfrequency of a semi-guy-wired tower as well as recommendations for designing future towers for VAWTs. The noise emission of VAWTs has been studied and proven low compared to HAWTs. The noise frequency distribution of the 200 kW VAWT differs significantly from that of a similar size HAWTs with for example lower levels for frequencies below 3000 Hz.

A tidal current turbine is a device functioning in a manner similar to wind turbine for harnessing energy from tidal currents, a group of which is called a farm. The existing approaches used to predict power from tidal current turbine farms oversimplify the hydrodynamic interactions between turbines, which significantly affects the results. The major focus of this dissertation is to study the relationship between turbine distribution (the relative position of the turbines) and the hydrodynamic interactions between turbines, and its impact on the power from a farm. A new formulation of the discrete vortex method (DVM-UBC) is proposed to describe the behavior of turbines and unsteady flow mathematically, and a numerical model is developed to predict the performance, the unsteady wake and acoustic emission of a stand-alone turbine using DVM-UBC. Good agreement is obtained between the results obtained with DVM-UBC and published numerical and experimental results. Then, another numerical model is developed to predict the performance, wake and acoustic emission of a two-turbine system using DVM-UBC. The results show that the power of a two-turbine system with optimal relative position is about 25% more than two times that of a stand-alone turbine under the same conditions. The torque such a system may fluctuate 50% less than that of a stand-alone turbine. The acoustic emission of such a system may be 35% less than that of a stand-alone turbine. As an extension, a numerical procedure is developed to estimate the efficiency of an N-turbine system by using a linear theory together with the two-turbine system model. By integrating above hydrodynamic models for predicting power and a newly-developed Operation and Maintenance (O&M) model for predicting the cost, a system model is framed to estimate the energy cost using a scenario-based cost-effectiveness analysis. This model can estimate the energy cost more accurately than the previous models because it breaks down turbine’s components and O&M strategies in much greater detail when studying the hydrodynamics and reliability of the turbine. This dissertation provides a design tool for farm planners, and shed light on other disciplines such as environmental sciences and oceanography.

A tidal current turbine is a device functioning in a manner similar to wind turbine for harnessing energy from tidal currents, a group of which is called a farm. The existing approaches used to predict power from tidal current turbine farms oversimplify the hydrodynamic interactions between turbines, which significantly affects the results. The major focus of this dissertation is to study the relationship between turbine distribution (the relative position of the turbines) and the hydrodynamic interactions between turbines, and its impact on the power from a farm. A new formulation of the discrete vortex method (DVM-UBC) is proposed to describe the behavior of turbines and unsteady flow mathematically, and a numerical model is developed to predict the performance, the unsteady wake and acoustic emission of a stand-alone turbine using DVM-UBC. Good agreement is obtained between the results obtained with DVM-UBC and published numerical and experimental results. Then, another numerical model is developed to predict the performance, wake and acoustic emission of a two-turbine system using DVM-UBC. The results show that the power of a two-turbine system with optimal relative position is about 25% more than two times that of a stand-alone turbine under the same conditions. The torque such a system may fluctuate 50% less than that of a stand-alone turbine. The acoustic emission of such a system may be 35% less than that of a stand-alone turbine. As an extension, a numerical procedure is developed to estimate the efficiency of an N-turbine system by using a linear theory together with the two-turbine system model. By integrating above hydrodynamic models for predicting power and a newly-developed Operation and Maintenance (O&M) model for predicting the cost, a system model is framed to estimate the energy cost using a scenario-based cost-effectiveness analysis. This model can estimate the energy cost more accurately than the previous models because it breaks down turbine’s components and O&M strategies in much greater detail when studying the hydrodynamics and reliability of the turbine. This dissertation provides a design tool for farm planners, and shed light on other disciplines such as environmental sciences and oceanography.