A busca por alternativas viáveis de produção de energia limpa e renovável, utilizando recursos naturais, tem sido um grande desafio. Em especial, o interesse no uso da energia solar para obter energia elétrica tem aumentado. Todavia, as células solares convencionais que são confeccionadas a partir de silício cristalino (Si-c) apresentam uma eficiência de conversão limitada, principalmente, devido às perdas por incompatibilidade espectral. Sendo assim, um dos objetivos dos pesquisadores na área de fotovoltaicos tem sido converter eficientemente fótons da região do visível do espectro solar para a região do infravermelho, onde a célula solar de Si-c possui maior eficiência. A eficiência desta conversão poderia ser melhorada de 28% até 40% usando conversores de energia compostos por íons terras raras. Neste trabalho foram estudadas as propriedades espectroscópicas dos íons terras raras Térbio (Tb3+) e Itérbio (Yb3+), embebidos em três diferentes materiais: vidro aluminosilicato de cálcio com baixa concentração de sílica (7%) (LSCAS), vidro tetraborato de cálcio-lítio (Calibo) e nano-cristais de óxido de zircônia (ZrO2). Sendo assim, nossos estudos visam elucidar os mecanismos geradores dos processos de conversão ascendente e descendente de energia. No processo de conversão ascendente de energia há conversão dos fótons de excitação de baixa energia na região do infravermelho em fótons de alta energia na região do visível. Por outro lado, no processo de conversão descendente de energia ocorre a conversão dos fótons de excitação de alta energia na região do ultravioleta/visível em um ou mais fótons de baixa energia na região do infravermelho. As propriedades espectroscópicas dos materiais estudados foram discutidas a partir das medidas de absorção, luminescência, excitação, evolução temporal da luminescência, curva de potência, difração de raios-X, X-Ray Absorption Near Edge Structure e ressonância paramagnética eletrônica, em função da concentração dos íons Tb3+ e Yb3+. Os resultados mostraram que todas as amostras apresentam conversão ascendente de energia. Assim como, em todas as amostras ocorre o processo de conversão descendente de energia. Em ambos os processos foram identificados os mecanismos geradores dos mesmos. Estes resultados mostram um avanço nos estudos dos processos de conversão ascendente e descendente de energia em sistemas co-dopados com íons Tb3+ e Yb3+. Os resultados sugerem que os materiais estudados podem ser empregados para aumentar a eficiência de conversão da célula solar de Si-c via conversão descendente de energia. / The search for possible alternatives to produce clean and renewable energy using the natural resources has been a great challenge. In particular, the interest to use the solar energy to produce electricity has been increased. However, crystalline silicon-based (c-Si) conventional solar cells have limited conversion efficiency, mainly due to spectral mismatch losses. Thus, one of the goals of some researchers in the photovoltaic field has been to efficiently convert photons in the visible region of the solar spectrum to the infrared region, where the c-Si solar cell has its higher efficiency. The efficiency of this conversion could be enhanced from 28% up to 40% using energy converters based on rare-earths ions. In this work, the spectroscopic properties of rare earth ions, such as Terbium (Tb3+) and Ytterbium (Yb3+) embedded in three different materials were studied: low- silica calcium aluminosilicate glass (7%) (LSCAS), lithium calcium tetraborate glass (Calibo) and zirconium oxide nano-crystals (ZrO2). Thus, our studies aimed to elucidate the mechanisms that generate the Up-conversion and Down-conversion processes. In the Up-conversion process, there is the conversion of the low-energy excitation photons in the near-infrared to high-energy photons in the visible. On the other hand, in the Down-conversion process there is the conversion of the high-energy excitation photons in the ultraviolet/visible region to low-energy photons in the near-infrared region. The optical properties of the studied materials were discussed through absorption, luminescence, excitation, temporal evolution of the luminescence, power curve, X-ray diffraction, X-Ray Absorption Near Edge Structure and electron paramagnetic resonance measurements, as a function of the concentration of Tb3+ and Yb3+ ions. The results showed that all samples exhibit Up-conversion process. In addition, in all samples occurs the Down-conversion process. In both processes were identified the mechanisms that produce them. These results show a breakthrough in the studies of the Up-conversion and Down-conversion processes in Tb3+ and Yb3+ co-doped systems. The results suggest that the materials are applicable in enhancing the conversion efficiency of the Si-c solar cell via NIR Down-conversion.

The ultrashort chirped pulse amplification (CPA) laser technology opens the path to high intensities of 10^21 W/cm² and above in the laser focus. Such intensities allow laser-matter interaction in the relativistic intensity regime. Direct diode-pumped ultrashort solid-state lasers combine high-energy, high-power and efficient amplification together, which are the main advantages compared to flashlamp-pumped high-energy laser systems based on titanium-doped sapphire. Development within recent years in the field of laser diodes makes them more and more attractive in terms of total costs, compactness and lifetime. This work is dedicated to the Petawatt, ENergy-Efficient Laser for Optical Plasma Experiments (PENELOPE) project, a fully and directly diode-pumped laser system under development at the Helmholtz–Zentrum Dresden – Rossendorf (HZDR), aiming at 150 fs long pulses with energies of up to 150 J at repetition rates of up to 1 Hz. The focus of this thesis lies on the spectral and width manipulation of the front-end amplifiers, trivalent ytterbium-doped calcium fluoride (Yb3+:CaF2) as gain material as well as the pump source for the final two main amplifiers of the PENELOPE laser system. Here, all crucial design parameters were investigated and a further successful scaling of the laser system to its target values was shown. Gain narrowing is the dominant process for spectral bandwidth reduction during the amplification at the high-gain front-end amplifiers. Active or passive spectral gain control filter can be used to counteract this effect. A pulse duration of 121 fs was achieved by using a passive spectral attenuation inside a regenerative amplifier, which corresponds to an improvement by a factor of almost 2 compared to the start of this work. A proof-of-concept experiment showed the capability of the pre-shaping approach. A spectral bandwidth of 20nm was transferred through the first multipass amplifier at a total gain of 300. Finally, the predicted output spectrum calculated by a numerical model of the final amplifier stages was in a good agreement with the experimental results. The spectroscopic properties of Yb3+:CaF2 matches the constraints for ultrashort laser pulse amplification and direct diode pumping. Pumping close to the zero phonon line at 976nm is preferable compared to 940nm as the pump intensity saturation is significantly lower. A broad gain cross section of up to 50nm is achievable for typical inversion levels. Furthermore, moderate cryogenic temperatures (above 200K) can be used to improve the amplification performance of Yb3+:CaF2. The optical quality of the doped crystals currently available on the market is sufficient to build amplifiers in the hundred joule range. The designed pump source for the last two amplifiers is based on two side pumping in a double pass configuration. However, this concept requires the necessity of brightness conservation for the installed laser diodes. Therefore, a fully relay imaging setup (4f optical system) along the optical path from the stacks to the gain material including the global beam homogenization was developed in a novel approach. Beside these major parts the amplifier architecture and relay imaging telescopes as well as temporal intensity contrast (TIC) was investigated. An all reflective concept for the relay imaging amplifiers and telescopes was selected, which results in several advantages especially an achromatic behavior and low B-Integral. The TIC of the front-end was improved, as the pre- and postpulses due to the plane-parallel active-mirror was eliminated by wedging the gain medium.

The ultrashort chirped pulse amplification (CPA) laser technology opens the path to high intensities of 10^21 W/cm² and above in the laser focus. Such intensities allow laser-matter interaction in the relativistic intensity regime. Direct diode-pumped ultrashort solid-state lasers combine high-energy, high-power and efficient amplification together, which are the main advantages compared to flashlamp-pumped high-energy laser systems based on titanium-doped sapphire. Development within recent years in the field of laser diodes makes them more and more attractive in terms of total costs, compactness and lifetime. This work is dedicated to the Petawatt, ENergy-Efficient Laser for Optical Plasma Experiments (PENELOPE) project, a fully and directly diode-pumped laser system under development at the Helmholtz–Zentrum Dresden – Rossendorf (HZDR), aiming at 150 fs long pulses with energies of up to 150 J at repetition rates of up to 1 Hz. The focus of this thesis lies on the spectral and width manipulation of the front-end amplifiers, trivalent ytterbium-doped calcium fluoride (Yb3+:CaF2) as gain material as well as the pump source for the final two main amplifiers of the PENELOPE laser system. Here, all crucial design parameters were investigated and a further successful scaling of the laser system to its target values was shown. Gain narrowing is the dominant process for spectral bandwidth reduction during the amplification at the high-gain front-end amplifiers. Active or passive spectral gain control filter can be used to counteract this effect. A pulse duration of 121 fs was achieved by using a passive spectral attenuation inside a regenerative amplifier, which corresponds to an improvement by a factor of almost 2 compared to the start of this work. A proof-of-concept experiment showed the capability of the pre-shaping approach. A spectral bandwidth of 20nm was transferred through the first multipass amplifier at a total gain of 300. Finally, the predicted output spectrum calculated by a numerical model of the final amplifier stages was in a good agreement with the experimental results. The spectroscopic properties of Yb3+:CaF2 matches the constraints for ultrashort laser pulse amplification and direct diode pumping. Pumping close to the zero phonon line at 976nm is preferable compared to 940nm as the pump intensity saturation is significantly lower. A broad gain cross section of up to 50nm is achievable for typical inversion levels. Furthermore, moderate cryogenic temperatures (above 200K) can be used to improve the amplification performance of Yb3+:CaF2. The optical quality of the doped crystals currently available on the market is sufficient to build amplifiers in the hundred joule range. The designed pump source for the last two amplifiers is based on two side pumping in a double pass configuration. However, this concept requires the necessity of brightness conservation for the installed laser diodes. Therefore, a fully relay imaging setup (4f optical system) along the optical path from the stacks to the gain material including the global beam homogenization was developed in a novel approach. Beside these major parts the amplifier architecture and relay imaging telescopes as well as temporal intensity contrast (TIC) was investigated. An all reflective concept for the relay imaging amplifiers and telescopes was selected, which results in several advantages especially an achromatic behavior and low B-Integral. The TIC of the front-end was improved, as the pre- and postpulses due to the plane-parallel active-mirror was eliminated by wedging the gain medium.

Dans la perspective d’améliorer les cellules du futur, nous avons élaboré respectivement des couches minces de ZnO dopé Mo par la méthode spray pyrolyse et dopé Yb par sputtering. Quel que soit la technique utilisée, toutes ces couches sont polycristallines, transparentes avec des surfaces uniformes. De plus les mesures d’effet Hall montrent une conductivité de type n dans le cas des deux systèmes étudiés. Concernant les films minces de ZnO dopé Mo, les propriétés électriques restent potentiellement intéressantes pour des applications en photovoltaïque en tant que dopant additionnel en plus des terres rares. Quant aux films minces de ZnOYb, les résultats de mesures PL ont clairement mis en évidence un couplage optique entre ZnO et l’Yb avec l’observation d’un photon infrarouge pour un photon UV incident. Ceci suggère que le concept « down-shift » est susceptible d’être validé. / In view of improving the cells of the future, we have elaborated respectively doped ZnO thin films by Mo spray pyrolysis method and doped Yb by sputtering. Whatever the technique used all these layers are polycrystalline, transparent with smooth surfaces. In addition, the Hall effect measurements show an n-type conductivity in the case of two systems studied. On thin films of ZnO doped Mo, the electrical properties are potentially interesting for photovoltaic applications as additional dopant in addition to rare earths. As for thin films ZnOYb, PL measurement results have clearly demonstrated an optical coupling between ZnO and Yb with the observation of a photon infrared photon UV incident. This suggests that the concept of "down-shift" is likely to be validated.