The aim of the project was to develop a method to measure and studythe degree of activation of the negative electrode (MH) in a NiMH battery.This was done by characterization of the gases produced during charge of a battery – O2 and H2 – using a Gas Chromatograph. The current applied in the very first charge of the battery was varied in order to examine how this affects the gas evolution. In the developed method, batteries were charged to 8Ah with 9A, after which a gas sample was taken and analyzed with Gas Chromatography. An additional goal was to use the method to examine the difference in activation between virgin and recycled negative electrode material. A module charged stepwise with 0.07C followed by 0.2C had the lowest share of H2 after two cycles, indicated best activation. However, a higher amount of H2 in the beginning of the activation process could possibly enhance the degree of activation during the following cycles. The method indicated that the module with recycled MH was better activated than the virgin MH. To improve the technique, repeated measurements to get better statistics should be done. Gas samples should be taken at dV/dt=0 in order to take samples at same SoC. The charge current should be adjusted so that the same C rate is always used. This would make the results easier to interpret.

Reliable energy supply is a major concern and crucial for development of the global society. To address the dependency on fossil fuel and the negative effects of this reliance on climate, there is a need for a transition to cleaner sources. An attractive solution for replacing fossil-based products is renewable substitutes produced from biomass. Gasification and pyrolysis are two promising thermochemical conversion technologies, facing challenges before large-scale commercialization becomes viable. In case of biomass gasification, tar is often and undesired by-product. An attractive option to convert tar into syngas is nickel-based catalytic steam reforming (SR). For biomass pyrolysis, catalytic SR is in early stages of investigation as a feasible option for bio-crude conversion to syngas. The focus of the thesis is partly dedicated to describe research aimed at increasing the knowledge around tar reforming mechanisms and effect of biomass-derived impurities on Ni-based tar reforming catalyst downstream of gasifiers. The work focuses on better understanding of gas-phase alkali interaction with Ni-based catalyst surface under realistic conditions. A methodology was successfully developed to enable controlled investigation of the combined sulfur (S) and potassium (K) interaction with the catalyst. The most striking result was that K appears to lower the sulfur coverage and increases methane and tar reforming activity. Additionally, the results obtained in the atomistic investigations are discussed in terms of naphthalene adsorption, dehydrogenation and carbon passivation of nickel. Furthermore, the thesis describes research performed on pyrolysis gas pre-conditioning at a small-industrial scale, using an iron-based catalyst. Findings showed that Fe-based materials are potential candidates for application in a pyrolysis gas pre-conditioning step before further treatment or use, and a way for generating a hydrogen-enriched gas without the need for bio-crude condensation. / Tillförlitlig energiförsörjning är en stor utmaning och avgörande för utvecklingen av det globala samhället. För att ta möta beroendet av fossil råvara och de negativa effekter som detta beroende medför för klimatet finns ett stort behov av en övergång till renare energiråvaror. En attraktiv lösning är att ersätta nuvarande fossil råvara med produkter från biomassa. Förgasning och pyrolys är två lovande teknologier för termokemisk omvandling av biomassa. Kommersialisering av dessa teknologier är inte helt problemfritt. I fallet förgasning så behöver, bl.a. oönskade tyngre kolväten (tjära) hanteras innan den producerade orenade produktgasen kan användas i syntesgastillämpningar. Ett effektivt alternativ för detta är gaskonditionering vid höga temperaturer, baserade på katalytisk ångreformering med en nickelkatalysator. Katalytisk ångreformering är en möjlig teknik för omvandling av bioråvara, producerad från pyrolys av biomassa, till syntesgas. Avhandlingen fokuserar delvis på att beskriva den forskning som utförts för att öka kunskapen kring mekanismer för tjärreformering och effekterna av föroreningar från biomassan på en nickelkatalysator nedströms förgasare. Arbetet bidrar till en bättre förståelse av hur alkali i form av kalium (K) i gasfasen upptas, jämviktas och växelverkar med ytan hos nickelkatalysatorn under fullt realistiska förhållanden. Inledningsvis utvecklades en metod för att möjliggöra kontrollerade studier av den kombinerade effekten av S och K, vilken inkluderar exakt dosering av alkali till en produktgas, eliminering av transienter i katalysatoraktiviteten samt katalysatorkarakterisering. Det mest lovande resultatet är att K både sänker ytans svavelinnehåll och ökar aktiviteten för omvandlingen av metan och tjära. För att ytterligare fördjupa kunskaperna i mekanismerna för tjärnedbrytning utfördes experimentella och teoretiska ytstudier på en enkristallnickelyta med naftalen som modellförening. Resultat avseende naftalenadsorption, dehydrogenering av naftalen och kolpassivering av nickelytan diskuteras. Därutöver så beskriver avhandlingen den forskning som utförts inom förkonditionering av pyrolysgas med en järnkatalysator för varsam deoxygenering av biooljan och vätgasproduktion. Detta utfördes vid en småskalig industriell anläggning. De experimentella studierna visar att den undersökta järnkatalysatorn resulterar i en vätgasberikad gas och att den är en potentiell kandidat för tillämpning i ett förkonditioneringssteg. / <p>QC 20170830</p>

The American Cancer Society predicts that 1,665,540 people will be diagnosed with cancer, and 585,720 people will die from cancer in 2014. One of the most common types of cancer in the United States is skin cancer. Melanoma alone is predicted to account for 10,000 of the cancer related deaths in 2014. As a highly mobile and aggressive form of cancer, melanoma is difficult to fight once it has metastasized through the body. Early detection in such varieties of cancer is critical in improving survival rates in afflicted patients. Present methods of detection rely on visual examination of suspicious regions of tissue via various forms of biopsies. Accurate assessment of cancerous cells via this method are subjective, and often unreliable in the early stages of cancer formation when only few cancer cells are forming. With fewer cancer cells, it is less likely that a cancer cell will appear in a biopsied tissue. This leads to a lower detection rate, even when cancer is present. This lack of detection when cancer is in fact present is referred to as a false negative. False negatives can have a highly detrimental effect on treating the cancer as soon as possible. More accurate methods of detecting cancer in early stages, in a nonsubjective form would alleviate these problems. A proposed alternative to visual examination of biopsied legions is to utilize fluorescent nanocrystalline biomarker constructs to directly attach to the abnormal markers found on cancerous tissues. Quantum dots (QDs) are hydrophobic nanoscale crystals composed of semiconducting materials which fluoresce when exposed to specific wavelengths of radiation, most commonly in the form of an ultraviolet light source. The QD constructs generated were composed of cadmium-selenium (CdSe) cores encapsulated with zinc-sulfide (ZnS) shells. These QDs were then encapsulated with phospholipids in an effort to create a hydrophilic particle which could interact with polar fluids as found within the human body. The goal of this thesis is to develop a method for the solubilization, encapsulation, and initial functionalization of CdSe/ZnS QDs. The first stage of this thesis focused on the generation of CdSe/ZnS QDs and the fluorescence differences between unshelled and shelled QDs. The second stage focused on utilizing the shelled QDs to generate hydrophilic constructs by utilizing phospholipids to bind with the QDs. Analysis via spectroscopy was performed in an effort to characterize the difference in QDs both prior to and after the encapsulation process. The method generated provides insight on fluorescence trends and the encapsulation of QDs in polar substances. Future research focusing on the repeatability of the process, introducing the QD constructs to a biological material, and eventual interaction with cancer cells are the next steps in generating a new technique to target and reveal skin cancer cells in the earliest possible stages without using a biopsy.