Proton exchange membrane fuel cells (PEMFCs) have attracted great attention due to their high power density, low-temperature operation and high energy conversion efficiency. However, the high cost of Pt catalysts and durability problems hinder their commercialization. So their cost must be lowered drastically and their durability must be extended. In an effort to overcome these problems, there have been intensive efforts to enhance the activity, durability and to lower the price of catalysts by alloying with other less expensive metals. In particular, the sluggish kinetics of ORR caused by Pt oxide at cathode and Pt catalyst degradation by electrochemical surface area (ECSA) loss have been a huge research area where a lot of researchers have paid lots of attention to solve. In this regard, the objective of this dissertation is to evaluate a series of Pt catalyst electrode surface electrochemical reactions on PEMFC electrode in order to help searching new catalysts and enhancing system design, assist in the search for new catalysts and improved system design by suggesting the developed mechanism of electrocatalyst activity and stability (durability). We have been focused on understanding the oxide-mediated dissolution of Pt by using electrochemical experiment methods such as RRDE, EQCN, SECM with a combination of ICP-MS and computational simulation with COMSOL Multiphysics. Firstly, in chapter 3, we showed the oxide-mediated Pt dissolution rate and the influence of hydrogen and cation underpotential deposition on Pt dissolution. In chapter 4, we revealed oxygen reduction reaction (ORR) plays a significant role in Pt oxide formation and reduction that influences the Pt catalyst dissolution, resulting in accelerated Pt dissolution rate at specific potential range. Finally, we found out the nature of mobile species generated during PtO₂ reduction process which have been disputed as Pt ion or other mobile species and fulfilled computational simulation for evaluation of SECM experiment in chapter 5. Based on these experiments and simulation, we were able to explain some mechanism of literature results that already were reported but have not been clearly explained so far. In terms of the purpose of this dissertation, the mechanism of oxide-mediated Pt dissolution, influence of ORR to Pt oxide formation/reduction and Pt dissolution, the nature of mobile species generated during PtO₂ reduction process, are sure to be very helpful in developing new catalysts and enhancing system design and suggested operating conditions. / text

Les oxydes de manganèse présentent un grand intérêt en raison de leur activité catalytique pour l'ORR (la réaction de réduction de l’oxygène) en milieu alcalin et peuvent être utilisés comme matériaux sans métaux nobles pour la cathode dans les piles à combustible. La présente thèse est consacrée à l’étude de l’activité d'oxydes de manganèse pour l’ORR. Il a été montré que Mn2O3 avec structure bixbyite a une meilleure activité catalytique vers l'ORR en milieu alcalin que les autres oxydes de manganèse étudiés. L'activité spécifique de Mn2O3 est seulement 4 fois inférieure à celle de Pt à une surtension de 0.3 V (ERH). Le lien entre la structure des oxydes de Mn et l'activité ORR est identifié: l'activité spécifique augmente exponentiellement avec le potentiel du couple redox Mn(III)/Mn(IV) de surface. Pour assurer l'activité électrocatalytique élevée de Mn2O3, il est nécessaire d'ajouter du carbone à la composition d'électrode, ainsi que de garder un potentiel supérieur à 0.7 V (ERH). / Manganese oxides are of great interest due to their catalytic activity towards the ORR (the oxygen reduction reaction) in alkaline media and can be used as noble metal-free materials for the cathode in liquid and polymer electrolyte alkaline fuel cells. The present thesis is devoted to the investigation of the ORR activity of manganese oxides. It was shown that Mn2O3 with bixbyite structure has a better catalytic activity toward the ORR in alkaline media than other investigated manganese oxide, the surface activity of Mn2O3 is only 4 times lower than that of Pt at an overvoltage of 0.3 V (RHE). The link between the structure of Mn oxides and the ORR activity is found: the specific ORR activity exponentially increases with the potential of the surface Mn(III)/Mn(IV) red-ox couple. To ensure the high electrocatalytic activity of Mn2O3, it is necessary to add carbon to the electrode composition, as well as to keep potential above 0.7 V (RHE).

This thesis describes the design, synthesis and reactivity of bimetallic complexes of doubly-pillared Schiff-base calixpyrrole ligands. Chapter One introduces the oxygen reduction reaction in light of the global energy scenario at present and in the future. Compounds and materials known to catalyse this reaction are discussed, with particular focus on transition metal complexes of pyrrole-containing macrocycles and the ability of these compounds to act as catalysts in redox reactions. Chapter Two describes the design and synthesis of several of the macrocyclic ligands developed during this project. The wide range of metals and geometries supported by one of the ligands, H4L, are outlined and include complexes of alkali-metals (Li, K), a rare earth metal (Mg), transition metals (Pd, Fe) and an actinide (UO2 2+). Chapter Three presents the use of [Co2(L)] for the reduction of dioxygen to water. The redox behaviour of the complex and its ability to reversibly bind oxygen were evaluated. The catalytic activity of [Co2(L)] was investigated in solution by UV-Vis spectrophotometry and electrochemically by rotating ring-disk electrochemistry. In Chapter Four, the ability of [Zn2(L)] to bind anions is described. Isothermal microcalorimetry, NMR, UV-Visible spectrophotometry, and fluorophotometry were used to study the de-aggregation of the anion free complex and the subsequent anion binding event. The stability of the complexes was estimated by DFT calculations. Chapter Five outlines the synthesis of complexes of L for other transition metals relevant to small molecule activation. Chapter Six contains a conclusion and suggestions on further investigations to carry out. Chapter Seven presents the full experimental details and analytical data for this work.

No description available.

La cinétique lente de la réduction de l’oxygène (ORR) est en grande partie responsable de la perte d’énergie de nombreux systèmes de conversion tels que les piles à combustible. Parmi les possibles catalyseurs de l’ORR, les oxydes de type pérovskite sont des candidats prometteurs en milieu alcalin. La présente thèse est consacrée à l’étude de l’activité, du mécanisme et de la stabilité de pérovskites à base de Co et Mn pour l’ORR. Grâce aux techniques d’électrode tournante à disque et disque-anneau (R(R)DE), les études de l’ORR et des transformations d’HO2- sur les couches minces de pérovskite/carbone dans une solution de NaOH ont montré qu’O2 est réduit en OH- via un mécanisme « en série » avec formation d’HO2- intermédiaire. Pour des quantités d’oxyde suffisantes, HO2- est ensuite réduit, ce qui résulte en un mécanisme apparent de 4 électrons. Dans ces électrodes, le carbone joue un double rôle. Il augmente l’activité électrocatalytique en améliorant le contact électrique et il est impliqué dans le mécanisme de l’ORR en catalysant la réduction d’O2 en HO2-, surtout pour les pérovskites à base de cobalt qui sont considérablement moins actives que celles à base de Mn. Néanmoins, l’électrocatalyse de l’ORR semble dégrader les sites actifs des pérovskites. / The sluggish kinetics of the oxygen reduction reaction (ORR) is largely responsible for the energy losses in energy conversion systems such as fuel cells. Among possible inexpensive catalysts for the ORR, perovskite oxides are promising electrocatalysts in alkaline media. The present thesis is devoted to the investigation of the ORR activity, mechanism and stability of some Co and Mn-based perovskites. The rotating (ring) disk electrode (R(R)DE) studies of the ORR and the HO2- transformations on perovskite/carbon thin layers in NaOH electrolyte prove that O2 is reduced to OH- via a “series” pathway with the HO2- intermediate. For high oxide loadings, the formed HO2- species are further reduced to give a global 4 electron pathway. In these electrodes, carbon plays a dual role. It increases the electrocatalytic activity by improving the electrical contact and it is involved in the ORR mechanism by catalyzing the reduction of O2 into HO2-, especially for Co-based perovskites which display lower reaction rates than Mn-based perovskites.

This master thesis deals with qualifications of the catalytic materials for positive electrode low-temperature fuel cells. The teoretical part focuses on the physical and chemical properties of low-temperature fuel cells. There are described methods of hydrodynamic RDE and RRDE. RRDE study utilizes methods linear and cyclic voltammetry for qualifying performance of catalytic materials and presentation of results. The practical part describes the preparation various types of carbon materials. There are monitored the oxygen reduction using RRDE. Catalytic materials are evaluated: CV, stability, kinetic parameters, creation of intermediate H2O2 and kinetics of electrode reactions.