Thesis (M.S.)--Virginia Polytechnic Institute. / Also available via the Internet.

The need for - and use of non-fossile fuels such as biogas have increased due to global warming, oil depletion and stricter environmental regulations. Organic wastes can be anaerobically digested in order to produce biogas, which can be utilized to generate heat or electricity. So far, little attention has been directed towards anaerobic digestion of organic wastes from the forest industry. Due to high sludge management costs and more rigorous environmental legislation, the demand for new and/or improved disposal methodologies has increased. Substrate treatment methods such as enzyme addition and ultrasound are of interest in order to make anaerobic digestion of organic wastes, e.g. biological sludge, economically feasible. The aim of this study is to evaluate if biological sludge from the pulp and paper industry can be used for methane production in anaerobic digestion and to investigate the effects of ultrasound pre-treatment and enzyme treatment. The aim of the study was accomplished by performing four batch experiments, during 67-110 days, and a six months laboratory-scale semi-continuous digestion experiment. Substrates were provided by a chemical and a mechanical paper mill, whereas Kemzymes® from Kemira and ultrasound equipment from Ultra Sonus were used for sludge treatment. The short term average accumulation of methane per added g VS rate increased both when ultrasound pre-treatment and enzyme treatment was applied in batch experiments. The enzyme treatment was considered to have a greater potential in larger scale and was consequently used in the semi-continuous digestion experiment. Positive effects of the treatment were however difficult to prove. Adapting the enzyme treatment to be more specific for the degradation of the sludge is recommended. It is possible that there are inhibitory interactions between ultrasound pre-treatment and enzyme treatment. 75% ultrasound pre-treatment is an alternative to complete pre-treatment and renders equivalent average accumulation of methane per added g VS. Storage of ultrasound pre-treated biological sludge at 4°C for six and 13 days does not affect the average accumulation of methane per added g VS. Enzyme treatment of biological sludge enhanced the average accumulation of methane per added g VS from indigenous material in the inoculum. It is likely that anaerobic digestion of biological sludge from the pulp and paper industry can render a stable biogas production. High viscosity and agitation problems were predominant in the semi-continuous digestion experiment and can be difficult to control in larger scale. The results from the semi-continuous digestion experiment are similar with those obtained from the batch experiments. The methane production rates in this study are lower (biological sludge from chemical pulp process) or higher (mechanical ditto) in comparison to those presented data by Puhakka et al. (1992). Different types of biological sludge were used and might explain the prevailing differences.

En nedgång har setts i Sverige och Europa när det gäller luftföroreningar de senast årtiondena. Nedgången beror bland annat på minskade emissioner från industrier, övergång från uppvärmning med olje- och kolpannor till fjärrvärme och förbättrad bränslekvalitet. Denna studie utvärderar lufthalts- och nedfallsmätningar gjorda i närheten av pappers- och massaindustrin Korsnäs i Gävle. Mätserierna startar vid sent 1970-tal och går fram till årsskiftet 2009/2010. Nedfall av stoft, sulfat, natrium, kalcium och lufthalter av svaveldioxid samt sot studerades. Jämförelser gjordes med Korsnäs miljöförbättrande åtgärder och emissioner under tidsperioden och med andra mätningar gjorda i Sverige och Gävleborgs län. Studien visade en nedgång av svaveldioxidhalterna i luften. Detta stämmer bra med en kraftig reduktion av svavelemissionerna från fabriksområdet under tidigt 1990-tal då installationer av reningsanläggningar skedde på de största emissionskällorna av svaveldioxid. En minskning av svavelhalten i eldningsoljan från Karskär Energi AB, ett energikombinat ägt av Korsnäs på samma fabriksområde, bidrog under samma tidperiod även till emissionsminskningen. Sothalten visade ingen nedåtgående trend under perioden men var säsongsberoende med i genomsnitt högre halter på vinterhalvåret. Troligtvis berodde detta på förbränningsanläggningar i närområdet, så som enskild förbränning och Karskär Energi AB. Fördelning av de högsta lufthalterna visade inte högre halter av svaveldioxid och sot när medelvindriktningen var ostlig och därmed blåste från fabriksområdet mot mätstationen utan när vindriktningen var sydvästlig och blåste från inlandet. Det totala stoft- och kalciumnedfallet visade ingen nedgång men hade i genomsnitt högre uppmätta halter på sommarhalvåret. Sulfatnedfallet visade högre halter under sent 1980-tal för att därefter minska och natriumnedfallet minskade något under perioden. Inga tydliga kopplingar kunde ses mellan lufthalter respektive nedfall och emissionerna från fabriksområdet när dataserierna sorterades efter vindriktning, vindhastighet och efter sommar- respektive vinterhalvår. Nedfall och lufthalter var inte högre, förutom för svaveldioxid, när jämförelser gjordes med andra mätningar i Sverige och Gävleborgs län och samtliga mätningar låg under periodens gällande nationella gränsvärden. / A decline has been seen in Sweden and Europe when it comes to air pollution the last decades. The decline is partly due to reduced emissions from industries, switching from heating using oil and coal boilers to district heating and better fuel quality. This study evaluates deposition and air concentration measurements made in the vicinity of the pulp and paper industry Korsnäs in Gävle. The measurement series starts at the late 1970s and goes up to year-end 2009/2010. Deposition of dust, sulphate, sodium, calcium and air concentrations of sulphur dioxide and soot were studied. Comparisons were made with Korsnäs environmental measures and emissions during the same time period and with other measurements made in Sweden and Gävleborgs County. The study showed a decrease in sulphur dioxide concentrations in the air. This fits well with a major reduction of sulphur emissions from the factory area in the early 1990s when installations of treatment plants were made at the largest emission sources of sulphur dioxide. Reducing the sulphur content of fuel oil from Karskär Energi AB, an energy combine owned by Korsnäs in the same factory area, contributed to the decrease during the same time period. Air concentrations of soot showed no downward trend over the years, but were seasonal, with higher average soot concentrations in the winter. This was most likely caused by the burning of fuel oil from both the private sector and Karskär Energi AB. The largest air concentrations did not show higher levels of sulphur dioxide and soot when the mean wind direction was easterly and thus blew from factory area toward the monitoring station but when the wind direction was southwesterly and blew from inland. The total dust and calcium deposition showed no decline but had higher average measured levels in the summer. Sulphate deposition showed high levels during the late 1980s but has thereafter decreased. The sodium deposition decreased a little during the time period. No clear connection was found between deposition/air concentrations and emissions from the factory area when the data series were sorted by wind direction, wind speed and after the summer and winter months. Depositions and air concentrations were not higher except for sulphur dioxide when the comparison was made with other measurements in Sweden and Gävleborg County. All measurements were below the then current national limits.

Climate change has become an increasingly important strategic issue for businesses to deal with. The stake is high particularly for those in energy-intensive industries as governments are implementing legislations that limit the carbon emission coming from these industries. Not only are such companies’ carbon emission confronted by regulatory bodies, but also various stakeholders such as customers and investors. Such pressures increased the business relevance of the issue and have provided various strategic contexts and drives. Businesses have responded in different ways to the changes that are coming with climate change. The purpose of this study was to provide insight into the dynamics and characteristics of carbon strategies. The case study companies were three pulp and paper companies located in Sweden, all subjected to the EU ETS regulation. In order to fulfill the purpose we have developed an analytical framework which we applied to the empirical findings. Based on our analysis we concluded that there are several factors that determine and drive the development of carbon strategies: sustainability, energy efficiency, market competition, and owners. The findings also revealed that the most prevalent response type was an optimization strategy, which is enhancing the carbon productivity from operational activities. The findings also confirmed the usefulness and comprehensiveness of the analytical framework employed to the understanding of carbon strategies and development factors.

Historically, the paper market has consisted of few customers with high demands. However, the market has changed and nowadays it consists of many customer with lower demands, which causes problems in the warehouse process of Braviken Papermill. The main problem is that the utilization rates in the storage bays are low due to the relatively large bays compared to the order quantities. The purpose of this project is to develop a new set of bays that fits the current market and increases the utilization rates. The goal of the new set is to decrease the amount of manual operations and instead use the full potential of the allocation system.    The new set of bays consist of four bay types, dimensioned for 2, 4, 8 and 16 reel stacks respectively. Several experiments are done, and the new set of bays performs better than the current one, in terms of the utilization rates for storage events in the bays. The average utilization rate is significantly higher for the new set compared to the current. A decrease in effective storage space can be compensated by an increased degree of utilization. Also, it is beneficial with more and smaller bays in a market situation like the one of Holmen Paper.

A number of studies have explored the drivers behind value creation, often referred to as value drivers. These studies point out that the generalizability of research on value creation to other contexts is difficult. One such context in which the value drivers remain unidentified is the context of industrial consultancy services. In the age of digitalization, where industries are becoming more complex and knowledge intensive, consultancy services have grown increasingly important for industrial customers. At the same time, globalization intensifies the competition on consultancy markets creating a high pressure on consultancy firms’ ability to continuously enhance value creation for their customers. Based on these challenges, the purpose of this thesis is to explore how value creation can be enhanced through the identification and utilization of value drivers in industrial consultancy services. Two research questions were formulated based on this purpose and addressed by means of a qualitative study conducted in the paper and pulp industry in Sweden. Semi-structured interviews were conducted with six managers and decision makers from five multinational companies that use consultancy services. The thematic analysis of the interviews led to the identification of 13 value drivers that play key roles in value creation in industrial consultancy services: Individual competence, Organizational resources, Availability, Personal relationship, Communication, Personal attributes, Timeliness, Usage of time, Performance, Cost, Customer-organizational involvement, Documentation and Progress by feedback. Ten among these drivers were considered benefits, while three were considered sacrifices. Consultancy firms should strive towards minimizing the negative effects on value creation caused by sacrificial value drivers and maximize the positive effects on value creation caused by beneficial value drivers. In addition, the thesis contributes a model in which the 13 value drivers can be used by both industrial customers of consultancy services and consultancy firms for the purpose of evaluating and enhancing value creation. Specifically, the model offers a tool that (I) compares different consultancy firms or projects in terms of value creation, (II) evaluates and analyzes projects and collaborations with respect to value creation and (III) enhances value propositions and value creating processes.