Incineration of waste is increasing in the EU. However, in the incineration process, both fly and bottom ash materials are generated as waste that requires further action. A common goal throughout Europe is to find ways to utilize ash materials in an environmentally and economically efficient manner in accordance with the current legislation. This legislation is the Waste Framework Directive (WFD) which lists essential properties (H-criteria) to classify waste, as hazardous or not. Of these criteria, ecotoxicity (H-14) should be classified based on the wastes’ inherent hazardous properties. The WFD further states that this classification should be based on the Community legislation on chemicals (the CLP Regulation). Today, there are no harmonized quantitative criteria for the H-14 classification in the WFD, but there is a proposal from the EU on a computing model that summarizes all the measured elements classified as ecotoxic in the solid material. However, there may be a poor relationship between the theoretical ecotoxicity, based on analysed individual elements, and their actual contribution to the measured total toxicity. Therefore, to reduce the risk of incorrectly assessing the hazard potential, the overall aim of this doctoral Thesis was to develop a scientifically well-founded basis for the choice of leaching methodology and ecotoxicity testing for the H-14 classification of ash materials in Europe. In Paper I, different ash materials were classified, two leaching methods were compared and the sensitivity as well as the usefulness of a selected number of aquatic ecotoxicity tests were evaluated. Paper III and IV studied different leaching conditions, relevant for both hazard classification and risk evaluation of ash. Moreover, all four papers investigated potentially causative ecotoxic elements in the ash leachates. The results from this Thesis show that elements not classified as ecotoxic in the chemical legislation have a significant influence on the overall toxicity of the complex ash materials and will be considered if using the approach with ecotoxicity tests on ash leachates, but not if using the computing model. In addition, the approach of comparing chemically analysed elements in the solid ash with literature toxicity data for the same elements systematically over-estimates the hazard potential. This emphasizes the importance of using leaching tests in combination with ecotoxicity tests for the ecotoxicity classification of ash materials, at least if the aim is to fully understand the inherent hazard potential of the ash. To conclude, the recommendation for H-14 classification of ash is that leachates should be prepared using the leaching test and conditions evaluated in Paper III and that the generated leachates should be tested in a battery of test organisms representing a wide range of biological variation and different routes of exposure. This classification proposal has support in the CLP Regulation and contributes to harmonizing the waste and chemical legislation. / <p>At the time of the doctoral defense, the following papers were unpublished and had a status as follows: Paper 3: Manuscript. Paper 4: Manuscript.</p>

This study aims to evaluate the waste management in Norrbottens municipalities in key areas such as possibilities to reach the two national waste goals, information to the public, the effect of legislation, future of waste management and differences in geographic- and demographic areas. The Waste Framework Directive (WFD) issued by the EU and incorporated into Swedish law plays a major part in waste management by defining a hierarchy in five steps how waste should be treated. Interviews conducted with each of the fourteen municipalities aimed to find out what step in the hierarchy they are at and what effect the implementation of EU-legislature into Swedish law has had. Based on the interviews a diverse range of answers was found in relation to the questions asked, generally the more populated municipalities saw a more positive future of waste management, mainly because more developed infrastructure to handle waste is already in place. However the smaller the municipality is the harder it is to allocate resources for waste management and problems arise in the form of expensive transports of waste. A few municipalities think that the WFD has had a positive effect in the form of clearer responsibility for all parties involved in waste management but in general the answers point to a greater effect on a national level rather than a local. Regarding the national waste goals 7 of 14 municipalities believe they will reach the food waste goal but only 1 of 14 believe they will reach the construction waste goal.

The objective of our thesis was to conduct a pilot study to evaluate if an Extended Producer Responsibility (EPR) for textiles in the EU could be a socioeconomically beneficial policy to complement the EU Waste Framework Directive’s amendment of separately collected textiles. The aim was to investigate if the policy could achieve increased circular design of textiles as well as if it could work as a management plan for the increased collection rates. The evaluation was made with a Cost-Benefit Analysis, using the French EPR-system for textiles as a base. It was further complemented with previously conducted research of EPR-systems for other waste streams in the EU, as well as by previously conducted investigations for other national implementations of producer responsibilities for textiles. In additional support, we used data for differences between the member states in the European Union and conducted an expert interview. The EPR was compared to a situation where the municipalities in the member states would instead be responsible for the separate collection of textiles. The result of our investigation illustrates how both alternatives generate a net-loss, the Municipal Responsibility with - €7,611,410,291 and the Extended Producer Responsibility with - €6,012,109,341 during the first year of implementation. The EPR alternative generates a lower net-loss during the first three years of implementation. The producer responsibility is however the less beneficial alternative four years after implementation, since the decreased opportunity cost of labour generated through the hiring of unemployed assumed under the producer responsibility is deducted. The producer responsibility does however generate benefits through clearly defined responsibility of the textiles placed on the European market and gives incentives for increased fibre-to-fibre recycling and for increased durability of textiles. The initiative therefore generates both higher quantifiable-and non-quantifiable, environmental benefits than the alternative. We conclude that an Extended Producer Responsibility should be further examined as a complement to the regulation of separate collection of textiles, to reach an increased circular textile industry.

The limited amount of natural resources on our planet has been actively discussed during the past decade. Recycling materials is becoming increasingly important in order to benefit the economy and the environment. The purpose of this study is to conduct a material flow analysis of the construction and demolition waste in the Helsinki metropolitan area to find out whether or not the goals set by the EU Waste Framework Directive can be reached by 2020. The study aims to map out the flows and suggest improvements wherever needed. The study is conducted by using a case study, HSY Ekomo, the first fully operational circular economy hub in Finland. The results show that both the municipality and private sector are well over the required goal of 70% recyclability rate of construction and demolition waste with a steady positive improvement from the first year of operations. The improvements were over 10% between the year 2016 and 2017. The private sector experiences some turbulence regarding legislation issues such as noise- and environmental permits which limits the economic benefit of recycling construction and demolition waste. Continued monitoring and faster adaption to international standards (such as the EU Waste Framework Directive) is required in order to be able to benefit the most economically and environmentally out of circular economic initiatives. / Den begränsade mängden naturresurser som existerar på vår planet har diskuterats under det senaste decenniet aktivt. Återvinning av material blir allt viktigare i dagens samhälle och vi kan se en trend var utvecklingen strävar efter beslut som har rötterna i cirkulär ekonomiskaprinciper. Resultatet av diskussionerna har blivit höga måtsättningar för medlemsländerna i Europeiska Unionen gällande återvinning var målet är att uppnå en återvinningsgrad på 70% innan 2020 för bygg- och rivavfall. Studien använder materialflödes analys (MFA) som metod för att kartlägga och kvantifiera flödnena av bygg- och rivavfall. Materialflödes analysen använder data från årsrapporter och statistik som blivit tillgängligt av HSY (statligt ägt bolag) samt av intervjuerna som utfördes på fältet. För att kvantifiera flödena på basis av den konceptuella modellen avnändes mjukvaran STAN. Avhandlingen strävar efter att ta första steget för att kartlägga materialflöden av bygg- och rivavfall i huvudstadsregionen (Helsingfors). Målet är att skapa en modell som kan användas som botten i framtida undersökningar och att kvantifiera modellen med existerande data för att se ifall målsättningarna stadgade av Europeiska Unionen kommer att uppnås innan 2020. Studien utfördes på cirkulär ekonomi stationen Ekomo för att kunna göra upp modeller för den privata sektorn och den kommunalla sektorn eftersom båda är verksamma på Ekomo. Resultaten av anvhandlingen var följande: Den privata sektorn och staten uppnår en återvinningsgrad på över 90% vilket är väl över stadgan satt av den Europeiska Unionen under året 2017 med en stadig utveckling från året innan med en väldigt liten andel som placeras på soptipp. Resultaten visar en stark utveckling av intresse från hushåll och företag för återvinning eftersom antalet kunder och lastbilar som besökt stationen ökat starkt under de senaste fem åren. Även om målsättningarna inom återvinning är uppnådda finns det ärenden som måste behandlas för att försäkra en fortsatt positiv utveckling. Den privata sektorn upplever att begränsade möjligheter för återanvänd krossbetong minskar efterfrågan på produkten, vilket gör den finansiellt svår att integrera i deras försälning. Buller- och miljötillstånd tvingar för tillfället bolagen att transportera bygg- och rivmaterialet utanför rivmålet, t.ex till Ekomo, för att krossas vilket ytterligare skapar finansiella problem för den privata sektorn. Lösningar för att göra återvinning av riv- och byggnadsmaterial för den privata sektorn lukrativare behövs för att inspirera flera organisationer att ansluta sig till arbete mot ett mera cirkulärt samhälle. Monitorering och snabbare anpassningsförmåga för internationella standarder krävs för att kunna utnyttja cirkulär ekonomiska initiativ på bästa möjliga sättet. För att komplettera avhandlingen skulle det vara intressant att se resultaten av en livcykelanalys (LCA) gällande samma flöden för att identifiera miljörelaterade problem och för att optimera flöden.