A mathematical model for the drying of particulate solids in a continuous vibrated fluidised bed dryer was developed and applied to the drying of grain wetted with a single liquid and porous particles containing multicomponent liquid mixtures. Simple equipment and material models were applied to describe the process. In the plug-flow equipment model, a thin layer of particles moving forward and well mixed in the direction of the gas flow was regarded; thus, only the longitudinal changes of particle moisture content and composition as well as temperature along the dryer were considered. Concerning the material model, mass and heat transfer in a single isolated particle was studied. For grain wetted with a single liquid, mass and heat transfer within the particles was described by effective transfer coefficients. Assuming a constant effective mass transport coefficient and effective thermal conductivity of the wet particles, analytical solutions of the mass and energy balances were obtained. The variation of both transport coefficients along the dryer was taken into account by a stepwise application of the analytical solution in space intervals with non-uniform inlet conditions and averaged coefficients from previous locations in the dryer. Calculation results were verified by comparison with experimental data from the literature. There was fairly good agreement between experimental data and simulation but the results depend strongly on the correlation used to calculate heat and mass transfer coefficients.   For the case of particles containing a multicomponent liquid mixture dried in the vibrated fluidised bed dryer, interactive diffusion and heat conduction were considered the main mechanisms for mass and heat transfer within the particles. Assuming a constant matrix of effective multicomponent diffusion coefficients and thermal conductivity of the wet particles, analytical solutions of the diffusion and conduction equations were obtained. The equations for mass transfer were decoupled by a similarity transformation and solved simultaneously with conduction equation by the variable separation method. Simulations gave a good insight into the selectivity of the drying process and can be used to find conditions to improve aroma retention during drying.   Also, analytical solutions of the diffusion and conduction equations applied to liquid-side-controlled convective drying of a multicomponent liquid film were developed. Assuming constant physical properties of the liquid, the equations describing interactive mass transfer are decoupled by a similarity transformation and solved simultaneously with conduction equation and the ordinary differential equation that describes the changes in the liquid film thickness. Variations of physical properties along the process trajectory were taken into account as in the previous cases. Simulation results were compared with experimental data from the literature and a fairly good agreement was obtained. Simulations performed with ternary liquid mixtures containing only volatile components and ternary mixtures containing components of negligible volatility showed that it is difficult to obtain an evaporation process that is completely controlled by the liquid-side mass transfer. This occurs irrespective of the initial drying conditions.   Despite simplifications, the analytical solution of the material model gives a good insight into the selectivity of the drying process and is computationally fast. The solution can be a useful tool for process exploration and optimisation. It can also be used to accelerate convergence and reduce tedious and time-consuming calculations when more rigorous models are solved numerically. / QC 20110614

Optical elements are the fundamental components in photonic systems and are used to transform an input optical beam into a desired beam profile or to couple the input beam into waveguides, fibers, or other optical systems or devices. Macroscopic optical elements are easily fabricated using grinding and polishing techniques, but few methods exist for inexpensive fabrication of micro optical elements. In this work we present an innovative technique termed Additive Lithography that makes use of binary masks and controlled partial exposures to sculpt photoresist into the desired optical surface relief profile. We explore various masking schemes for fabricating a variety of optical elements with unprecedented flexibility and precision. These masking schemes used in conjunction with the additive lithographic method allows us to carefully control the photoresist exposure and reflow processes for fabricating complex aspheric lens elements, including aspheric elements whose fabrication often proves highly problematic. It will be demonstrated that employing additive lithography for volume sculpting followed by controlled reflow can also allow us to fabricate refractive beam shaping elements. Finally we will discuss the dry etching techniques used to transfer these optical elements into the glass substrate. Thus the additive lithography technique will be demonstrated as an inexpensive, high throughput and efficient process in the fabrication of micro optical elements.

Background: Virtual reality (VR) offers potential for enhancing physical activity and engagement among older adults in long-term care (LTC) facilities. This addresses the need for health maintenance and independence. Yet, limited research exists on VR acceptance and its optimization for promoting physical activity. Older adults' VR gaming experiences and the social and contextual factors affecting acceptance are underexplored. This study aims to investigate these unique experiences to inform the design of inclusive VR technology in LTC, enhancing physical activity and well-being. Objectives: My dissertation has two objectives: (1) to examine the individual and social factors that impact the acceptance of VR games among older adults in LTC facilities and (2) to explore LTC residents’ experience with VR games and the meaning they associate with their gaming experience. Methods: To reach these objectives I conducted two studies: (1) a scoping review of 5 articles to identify evidence on older adults' acceptance of physical activity VR games in LTC facilities, describe research designs used, define key acceptance concepts, and identify knowledge gaps for future research and (2) a mixed-methods study, including a series of gaming sessions with 20 older adults residing in a healthcare center followed by a composite questionnaire and semi-structured interviews with 15 older adults and 4 staff members. Results: The scoping review identified a knowledge gap in VR acceptance among older adults in LTC. Varying acceptance levels and inconsistent concept definitions were found, emphasizing the need for an integrated approach combining qualitative and quantitative methods. Only one study used validated tools for assessing acceptance. The quantitative study involved VR gaming sessions with 20 participants aged 65 and older, revealing significant positive correlations between perceived ease of use and Selective Optimization with compensation (SOC) strategies. No significant relationship was found between Technology Acceptance Model (TAM) and Future Time Perspective (FTP). Prior gaming experience led to higher SOC and socioemotional Selectivity (SST) scores, higher game self-efficacy, and increased hedonic motivation. Age and gender had no impact. Participants viewed VR as user-friendly and useful, with positive attitudes toward aging and physically demanding activities. The qualitative revealed themes related to enjoyment, physical activity, social connection, and individual preferences. Staff perspectives addressed relevance, personalization, training, and organizational barriers. The study highlighted the potential benefits of VR gaming for LTC residents, offering insights for technology development. Conclusion: This study offered a comprehensive understanding of VR gaming acceptance among older adults in LTC settings, highlighting the significance of individual and social factors in technology acceptance. Personalized design, support, education, trust, and safety are crucial. Integrating social theories of aging is essential to understand older adults' needs and preferences. Implications for VR design include user-centered approaches, intuitive interfaces, customization, social interaction, and safety considerations. Addressing limitations and biases in future research can promote effective use of VR as a therapeutic tool for older adults in LTC.

Le cortex cérébral est impliqué dans plusieurs fonctions entre autres le traitement des informations sensorielles. Il inclut des zones recevant directement une entrée sensorielle telle que le cortex visuel primaire (V1) qui traite les informations visuelles. Au niveau du V1 des mammifères, chaque neurone présente une combinaison préférentielle de stimuli pour lesquels sa réponse est optimale. Cela dit, chaque attribut de stimulus tel que les fréquences temporelle et spatiale, l’orientation et la direction du mouvement induit une réponse maximale du neurone. Le neurone du V1 est donc sélectif. Cependant, cette sélectivité n’est pas le résultat de l’activité du neurone en question seul, mais plutôt du réseau neuronal dans lequel il est impliqué. L’ensemble des préférences d’un neurone ainsi que le réseau neuronal auquel il appartient demeurent sensiblement inchangés, tant que les facteurs contextuels ne varient que peu ou pas. Toutefois, si les composantes de l’environnement changent de manière imposante, la sélectivité neuronale et l’organisation du réseau original seront modifiées pour induire un nouvel état d’équilibre. C’est la plasticité neuronale. Le but ultime de cette thèse est de comprendre et d’approfondir les connaissances relatives aux mécanismes régissant la sélectivité à l’orientation ainsi que la plasticité dans V1, et ce, par différentes études qui sont organisées, dans cette thèse en trois sections. Les sections (3) et (4) se basent sur une étude pharmacologique qui vise à examiner l’effet de la kétamine sur la sélectivité à l’orientation (section 3) et sur l’adaptation visuelle tout en traitant la connectivité neuronale (section 4). La section (5) vise à examiner l’effet de l’adaptation sur l’affinité des courbes d’accord des neurones. Ce travail a permis d’étudier l’effet de la kétamine et de l’adaptation visuelle sur les propriétés sélectives à l’orientation des neurones ainsi que sur la dynamique des relations fonctionnelles au sein du microcircuit. / The cerebral cortex plays a key role in several functions including the processing of sensory information. It contains areas that receive direct sensory input such as the primary visual cortex (V1) which processes visual information. V1 neurons of mammals are selective for several attributes, such as spatial and temporal frequencies, orientation, and direction of motion. Thus, V1 neurons exhibit selectivities. This neuronal selectivity rests in the convergence of clusters of synapses involved in the network. Neural selectivity and networks are formed during the sensitive period of brain development and is present throughout the animal’s life. However, in V1 during postnatal life, the neuronal selectivity and the neural circuitry are further shaped by experience, thus, rendering it plastic. The main objective of the current thesis is to understand the mechanisms involved in the orientation selectivity as well as the neuroplasticity in V1. To this aim, different investigations, organized in this thesis, in three sections, were carried out. The sections (3) and (4) are based on a pharmacological study that aim to examine the effect of ketamine on orientation selectivity (section 3) and on visual adaptation in relation with neural connectivity (section 4). The study presented in the third section (section 5) investigated the effect of adaptation on the cell’s tuning. Here, we disclose the effects of ketamine and visual adaptation on the cell’s tuning properties as well as on the dynamics of functional relationships between neurons in the microcircuit.

Malaria, caused by the parasite Plasmodium falciparum, has a long history as a global health threat. The vector-borne disease causes millions of deaths yearly, especially in developing countries with tropical climates that facilitate transmission. Compounding the problem is the emergence of drug-resistant strains due to overuse of outdated treatments. New compounds with antiplasmodial activity are needed to be developed as effective drugs against malaria. The hypothesis for this project is that marine microorganisms have a high likelihood of yielding novel antiplasmodial chemotypes because of their high diversity, which has not yet been explored for antimalarial development. In this project, microbes harvested and fermented by the Harbor Branch Oceanographic Institute in Fort Pierce, Florida were explored as sources for antiplasmodial natural products. Using a SYBR Green I fluorescence-based assay, 1,000 microbial extracts were screened for inhibition of the multidrug-resistant Plasmodium falciparum strain Dd2. Dose-response analysis was performed on 46 fractions from isolates whose extracts demonstrated greater-than or equal to] 70% inhibition of Dd2 at 1 micro]g/mL. To evaluate cytotoxicity, the MTS cell viability assay was used to calculate IC50 of extracts from active isolates in NIH/3T3 embryonic mouse fibroblasts. Several extracts demonstrated low IC50 in Dd2 and high IC50 in 3T3, suggesting that they contain potential lead antimalarial compounds. Extracts with high selectivity indices (potent plasmodial inhibition with low mammalian toxicity) have been prioritized for dereplication, with the goal of identifying novel active components that can be developed as antimalarial drugs.

No description available.

No description available.

No description available.

Blue Catfish Ictalurus furcatus are native to tributaries of the Mississippi River but are now invasive in several Atlantic slope drainages. This includes subestuaries of the Chesapeake Bay, where their feeding ecology and potential impact on native species was largely unknown. We collected stomach contents from 16,110 Blue Catfish at 698 sites in three large subestuaries of the Chesapeake Bay (James, York, Rappahannock rivers). Cumulative prey curves revealed that sample size was sufficient for diet description, though 1,000 – 1500 stomachs were needed per river. Blue Catfish are opportunistic generalists that feed on a broad array of plant and animal material. Logistic regression models reveal that Blue Catfish undergo significant ontogenetic diet shifts to piscivory at larger sizes (P<0.01) though the lengths at which these shifts occur varies by river system (500 – 900 mm total length; TL). Over 60% of Blue Catfish stomachs contained other invasive species, primarily Hydrilla verticillata and Asian clams Corbicula fluminea. Canonical Correspondence Analysis (CCA) revealed that salinity and season explained the most variation in Blue Catfish diet, while Generalized Additive Models (GAMs) demonstrated that there is considerable spatiotemporal and length-based variation in predation of species of concern. Species of concern include American Shad, American Eel, and river herring, which are imperiled, and blue crab, which support valuable fisheries in Chesapeake Bay. Predation of American Shad, American Eel, and river herring was rare (max predicted occurrence in Blue Catfish diets = 8%), while blue crab was much more common in the diet (max predicted occurrence =28%). Predation of American Shad and river herring peaks in freshwater areas in April, while predation of blue crab peaks in brackish areas in October. Predation of all species of concern is highest for large catfish (500 – 1000 mm TL). Field and laboratory-based estimates of consumption rate revealed that Blue Catfish feed at similar rates as Channel Catfish Ictalurus punctatus, and daily ration is estimated to be 2-5% bodyweight per day during warm temperatures, while peak feeding (maximum daily ration) can approach 10% bodyweight per day. While consumption of imperiled species is rare, Blue Catfish could still have negative impacts on these species due to dense catfish populations. / Ph. D.

A good ecological status of streams and rivers is crucial for maintaining ecological functionality of running waters. Worldwide eutrophication threatens to change structure and function of freshwater ecosystems (Dodds et al., 2008). To reduce the symptoms of eutrophication in streams and rivers an additional approach, besides the reduction of external nutrient inputs from catchment areas, is needed. Therefore the goal has been set to transfer the approach of biomanipulation, which is widely accepted as tool in water quality management in lakes and reservoirs, to streams. The objective of this study was accordingly to analyse and evaluate some crucial preconditions for top-down control of stream food webs. For that purpose the present thesis examined effects of fish predation (stone loach and gudgeon) on grazer-periphyton interaction in small streams by assessing predator avoidance by benthic grazers, effects of benthic grazers on periphyton community composition during fish presence/absence and the possibility of top-down control on algal biomass by benthivorous fish.